AMERI*CAN TELECOM INC.
Technical Document
SL PTG012 Telephone and Charging
Station
Installation Instructions
The Ameri*Can Telecom Inc. SL PTG012
Phone and Charging Station is a wall
mount or desktop enclosure designed for
SpectraLink pocket phones and battery
changers. It includes a hinged dust cover
with a key lock and holds up to 12
SpectraLink Phones and 12 battery
chargers.
SL PTG012
Inventory
Verify that all items listed on the Ameri*Can packing list were included in the shipment
as received from Ameri*Can for this installation. Notify Ameri*Can Telecom promptly
of any discrepancies.
Equipment supplied:
Wall Anchor & Screws
Power Cord
180060-00 and 180059-02 (4 ea.)
170000-02 (1 ea.)
SL PTG012
230443-19
Charger Mounting h/w
180012-00 (20 ea.)
180100-00 (20 ea.)
Tools Required
• Measuring Tape, Pencil and Level
• Drill and assorted Drill Bits, including a 1/8” Bit and Safety Glasses
• Assorted Screwdrivers
SL PTG012 Installation Instructions
Page 1
AMERI*CAN TELECOM INC.
Technical Document
3. Attach each PTQ365 charger to the housing using two (2) nylon spacers (p/n
180100-00) under the charger, and two (2) #6-19 screws (p/n 180012-00) per
charger.
PTQ365
4. Plug a power supply jack into each charger.
5. Plug in the AC power cord to turn power on. Verify that each charger LED is lit
solid red.
6. Place a SPECTRALINK battery into each charger position.
Verify that each charger LED is lit solid green.
Battery
LED
Enclosure Installation
The SL PTG012 SpectraLink Phone and Charging station can be placed on a table or can
be wall mounted. When wall mounted, the enclosure can be mounted horizontally or
vertically, using a Philips screwdriver and the included mounting hardware. To mount the
SL PTG012 Station to the wall, install the enclosure as follows:
1. Locate the four screws and anchors supplied with the kit.
SL PTG012 Installation Instructions
Page 3
AMERI*CAN TELECOM INC.
Technical Document
2. Position the enclosure on the wall in the location it will be mounted. Ensure that
it’s at the appropriate height, and level; mark the position of the four mounting
holes, forming a rectangle 26” by 4 3/8”. Refer to the illustration below. Note: If
the wall is wallpapered, use a razor to cut the area around the mark before
drilling.
3. Use a 1/8” bit to drill the pilot holes for the wall anchors to mount the enclosure.
4. Insert the anchors into the drilled holes. For vertical mounting, install two screws
in the side hanger holes and for horizontal hanging, place the two screws in the
top hanger holes.
5. Hang the Enclosure on the “key holes” located on the rear of the Enclosure.
Install the two remaining screws in holes located in the storage pockets of the
enclosure.
SL PTG012 Installation Instructions
Page 4
AMERI*CAN TELECOM INC.
Technical Document
SL PTG012 Installation Instructions
Page 5
|