Addonics Technologies RCED256ES User Manual

Enclosure Overview  
Top Cover  
Switch  
Addonics  
T E C H N O L O G I E S  
Ruby Cipher AES 256-bit ExDrive  
RCED256ES & RCED256EU  
Cipher Key  
Cipher Key Socket  
Drive Activity  
LED  
User’s Guide  
Ruby Cipher key  
Check to make sure you have the correct version of the Ruby Cipher key. The  
key should match the label at the back of the drive enclosure.  
FCC Warning Statement  
This equipment has been tested and found to comply with the limits for a class B digital  
device pursuant to Part 15 of the FCC rules. These limits are designed to provide  
reasonable protection against harmful interference in a residential installation. This  
equipment generates, uses and can radiate radio frequency energy. If not installed and  
used in accordance with the instructions, it may cause harmful interference to radio  
communications. However, there is no guarantee that interference will not occur in a  
particular installation. If the equipment does cause harmful interference to radio or  
television reception, which can be determined by turning the equipment on and off, the user  
is encouraged to try and correct the interference by one or more of the following  
suggestions.  
Reorient or relocate the receiving antenna  
Black label AES-256 stands for Ruby Cipher 256-bit key  
Increase the distance between the equipment and the receiver  
Connect the equipment to a different power outlet other than the one where receiver is  
connected  
Consult a certified television or radio technician  
Power: Connect the power cable (provided) to the 5V power connector located at  
the back of the enclosure.  
Step 5 Mount the board to the bottom  
cover.  
Data:  
Model: RCED256ES  
Connect the eSATA to eSATA cable to the eSATA connector located at the back  
of the enclosure and the other end of the eSATA cable to the eSATA connector  
on your SATA host controller with eSATA ports.  
Model: RCED256EU  
Connect the eSATA to eSATA cable to the eSATA connector located at the back  
of the enclosure and the other end of the eSATA cable to the eSATA connector  
on the USB2.0 to eSATA adapter. You can now plug the adapter to a USB port  
on your system.  
Step 6 Put the top cover on by holding it in  
near vertical position and sliding the two  
metal clips inside the two small slots on the  
rear of the bottom cover.  
Powering On Enclosure:  
Note: Be sure the Ruby cipher key is inserted into the drive enclosure prior to  
turning on the power of the drive cradle. The hard drive will not be  
detected by the computer if the power to the drive cradle is turned on  
without the Cipher key. Under such condition, the power on the drive  
cradle will have to be turned off and turned back on again with the  
Cipher key already inserted into the drive enclosure in order to detect  
the hard drive.  
Step 7 Lower the front of the top cover and making sure the two covers lined up  
properly. Tighten the small retaining screw on the front of the bottom cover to  
close the enclosure.  
To power on the enclosure, move the switch located at the front of the enclosure  
to the EXT mode. When the switch is turned on, the LED light beside it would  
light up to indicate power and also drive access.  
Note: There are no drivers needed to use the eSATA cable as long as the  
drivers are installed for the Serial ATA Controller card/chip. It is plug  
and play.  
Cable Connections  
Brand New Hard drive must be partitioned and formatted first before a  
drive letter is assigned by the OS.  
Power connection  
using 5V power adapter  
Internal/External  
or USB power cable  
Power Switch  
Technical Support  
If you need assistance to get your unit functioning properly, please call Addonics  
Technical Support. Our technical staff will be happy to assist you, but they will  
need your help to do so. Calling the technical support staff without all the proper  
information can be both time consuming and frustrating. Here are some tips to  
help you out:  
MODEL NUMBER Please have this number on hand.  
SYSTEM INFORMATION Type of computer, peripherals, etc.  
OPERATING SYSTEM What version of Windows  
WHAT’S THE TROUBLE? – Give enough information  
about your problem so that we can recreate and diagnose it.  
FREE Software Drivers for all Addonics Technologies  
Products are available 24 hours per day at the  
World Wide Web Site: www.addonics.com  
Contact Information  
Phone:  
Fax:  
408-573-8580  
408-573-8588  
Email:  
Internet:  
TECHNICAL SUPPORT  
Phone:  
Hours:  
Email:  
408-453-6212  
8:30 am - 6:00 pm PST  

NEC MA4000 User Manual
Motorola i576 User Manual
Lenovo ThinkCentre 41N5624 User Manual
IBM 22P6959 User Manual
Hitachi Travelstar HTS725025A9A360 User Manual
Hitachi Travelstar HTS725016A9A361 User Manual
Fujitsu MAF3364LC User Manual
Cecilware JAVA 2 QB DC User Manual
BT 1010 User Manual
Aluratek AHDU350 User Manual