WINEGARD®
Installation Instructions
Models DS-1111, VM-1111
INSTALLATION OF THIS MOUNT NEAR POWER LINES IS DANGEROUS. FOR YOUR
SAFETY, FOLLOW THE INSTALLATION INSTRUCTIONS.
S-PIPE
NOTE: THIS MOUNT IS NOT DESIGNED FOR
APPLICATIONS ON A VERTICAL SURFACE
SUCH AS WALLS, POLES, ETC.
CAUTION: LIMIT SIZE OF TV ANTENNA TO
GS-1000/2000, MS-1000/2000 OR A BOOM
LENGTH OF 40” OR LESS.
STEP 1. Assemble satellite dish and mount per
manufacturers instructions. Do not make fine tun-
ing adjustment at this time.
CARRIAGE BOLTS
1/4-20 x 1.25”
STEP 2. Remove (2) clamp tightening carriage
bolts from existing clamp bracket.
1/4-20
HEX NUTS
STEP 3. Attach flat plate to existing clamp bracket
with 1/4 - 20 x 1.25” bolts and install the washers
and nuts.
NEW CLAMP
BRACKET
EXISTING
CLAMP
BRACKET
1/4” WASHERS
STEP 4. Adjust azimuth and elevation on satellite
dish for optimum signal strength per manufactur-
ers instructions.
EXISTING
CLAMP BRACKET
Figure 1
STEP 5. Tighten all hardware on satellite antenna
mount, including clamp bolt nuts, when the opti-
mum signal strength is achieved.
S-PIPE
STEP 6. Slide S-pipe into new clamp, and adjust
to the approximate desired location. See Figure 2
for complete assembly.
FLAT
PLATE
CARRIAGE BOLTS
1/4-20 x 1.25”
STEP 7. Mount off-air antenna to upper mast. Run
coax downlead and secure it at the same time the
DSS wires are installed.
NEW CLAMP
BRACKET
MAKE SURE TO GROUND BOTH ANTENNA/
MOUNTS PER SATELLITE AND OFF-AIR AN-
TENNA INSTALLATION INSTRUCTIONS.
Figure 2
WINEGARD®
Printed in U.S.A.
Winegard Company • 3000 Kirkwood Street • Burlington, IA 52601-2000
© Winegard Company 2001
2451765 Rev. 1/04
|
Winegard Camcorder Accessories TR 3535 User Manual
Toshiba TEC MA 186 User Manual
Sony XR 3501MK2 User Manual
Sony Handycam DCR SR68 User Manual
Sony CDX M620 User Manual
Sony CDX GT700HD User Manual
Sony Camcorder EVI D80N User Manual
Sharp XE A303 User Manual
Samsung VP D6040S(i) User Manual
Samsung SCD963 User Manual