Nokia BH 105 User Manual

Nokia Bluetooth Headset BH-105  
4
1
5
2
3
7
6
8
9
10  
11  
9215201/1  
ENGLISH  
laws and regulations from the US and other  
countries. Diversion contrary to law is  
prohibited.  
Introduction  
With the Nokia Bluetooth Headset  
BH-105, you can make and receive  
calls while on the move.  
metres (33 feet) of each other.  
Connections may be subject to  
interference from obstructions, such  
as walls, or other electronic devices.  
Read this user guide carefully before  
using the headset. Also, read the user The headset is compliant with  
guide for the mobile device that you  
connect to the headset.  
Bluetooth Specification 2.1 + EDR  
supporting the Headset Profile 1.1 and  
Hands-Free Profile 1.5. Check with the  
manufacturers of other devices to  
determine their compatibility with  
this device.  
This product may contain small parts.  
Keep them out of the reach of small  
children. The surface of this device is  
nickel-free.  
Bluetooth wireless technology  
Bluetooth wireless technology allows  
you to connect compatible devices  
without cables. The headset and the  
other device do not need to be in line  
of sight, but they should be within 10  
ENGLISH  
Get started  
with this particular model. The use of any  
other types may invalidate any approval  
or warranty, and may be dangerous.  
The headset contains the following  
parts shown on the title page: power  
key (1), earloop (2), answer/end key  
(3), earpiece (4), indicator light (5),  
charger connector (6), and  
When you disconnect the power cord of  
any accessory, grasp and pull the plug,  
not the cord.  
microphone (7).  
1. Connect the charger to a wall  
outlet.  
Before using the headset, you must  
charge the battery and pair the  
headset with a compatible device.  
Parts of the device are magnetic. Metallic  
materials may be attracted to the device.  
Do not place credit cards or other  
magnetic storage media near the device,  
because information stored on them may  
be erased.  
2. Connect the charger cable to the  
charger connector. The red  
indicator light is displayed during  
charging. Charging the battery  
fully may take up to 2 hours.  
3. When the battery is fully charged,  
the green indicator light is  
displayed. Disconnect the charger  
from the headset, then from the  
wall outlet.  
Charge the battery  
Before charging the battery, carefully  
read “Battery and charger  
information”.  
The fully charged battery has power  
for up to 5 hours and 30 minutes of  
Warning: Use only chargers  
approved by Nokia for use  
ENGLISH  
talk time or up to 120 hours of  
standby time.  
and the red indicator light is briefly  
displayed. If the headset is not  
connected to a device within about 30  
minutes, it switches off automatically.  
To check the battery charge when the  
headset is not connected to a charger,  
press the power key. If the indicator  
light is green, the charge level is  
sufficient. If the light is yellow, you  
may need to recharge the battery  
soon. If the light is red, recharge the  
battery.  
Pair and connect the headset  
1. Ensure that your mobile device is  
switched on and the headset is off.  
2. Press and hold the power key (for  
about 5 seconds) until the green  
indicator light starts to flash  
quickly.  
When the battery charge is low, the  
headset beeps every 5 minutes and  
the red indicator light flashes.  
3. Within about 3 minutes, activate  
Bluetooth connectivity on your  
device, and set it to search for  
Bluetooth devices.  
Switch on or off  
To switch on, press and hold the power  
key for about 2 seconds. The headset  
beeps, and the green indicator light is  
displayed. The headset tries to  
4. Select the headset from the list of  
found devices.  
5. If necessary, enter the passcode  
0000 to pair and connect the  
headset to your device. In some  
devices, you may need to make the  
connect to the last connected device.  
To switch off, press and hold the  
power key for about 2 seconds when  
the headset is on. The headset beeps,  
ENGLISH  
connection separately after  
pairing.  
When the headset is connected to  
your device and is ready for use, the  
green indicator light flashes about  
every 5 seconds.  
Basic use  
To redial the number you last called (if  
your device supports this feature with  
the headset), when no call is in  
progress, press the answer/end key  
twice.  
Place the headset on the ear  
The headset is ready to be used on the  
left ear. To use the headset on the  
right ear, rotate the earloop so that it  
is to the right of the Nokia logo (10  
and 11).  
To activate voice dialling (if your  
device supports this feature with the  
headset), when no call is in progress,  
press and hold the answer/end key for  
about 2 seconds. Proceed as described  
in the user guide of your device.  
Slide the earloop behind your ear (8),  
and gently push the earpiece against  
your ear. Push or pull the earloop to  
set its length. Point the headset  
towards your mouth (9).  
To answer or end a call, press the  
answer/end key. To reject a call, press  
Calls  
To make a call, use your mobile device this key twice.  
in the normal way when the headset is  
connected to it.  
To switch a call from the headset to a  
compatible device, press and hold the  
ENGLISH  
Clear settings or reset  
To delete the pairings from the  
headset when it is switched off, press  
and hold the power key and the  
answer/end key (for about 5 seconds)  
until the red and green indicator lights  
start to alternate.  
answer/end key for about 2 seconds,  
or switch off the headset. To switch  
the call back to the headset, press and  
hold the answer/end key for about 2  
seconds, or switch on the headset.  
Turn lights on or off  
By default, the indicator lights are on  
in all situations. To turn the lights off  
in some situations (for example,  
during a call or when the headset is  
connected to a device) or back on,  
press and hold the power key and the  
answer/end key for about 2 seconds  
when the headset is connected to a  
device.  
To reset the headset if it stops  
functioning, even though it is charged,  
connect the headset to a charger  
while you press and hold the power  
key.  
Troubleshooting  
If you cannot connect the headset to  
your compatible device, check that  
the headset is charged, switched on,  
and paired with your device.  
Battery and charger information  
This device has an internal,  
the device as you may damage the  
nonremovable, rechargeable battery. Do device. This device is intended for use  
not attempt to remove the battery from  
when supplied with power from the  
 
ENGLISH  
following chargers: AC-3, AC-4, AC-5,  
connected to a charger, since  
AC-8, and DC-4. The exact charger model overcharging may shorten its lifetime. If  
number may vary depending on the type left unused, a fully charged battery will  
of plug. The plug variant is identified by  
one of the following: E, EB, X, AR, U, A, C,  
or UB. The battery can be charged and  
discharged hundreds of times, but it will  
eventually wear out. Recharge your  
battery only with Nokia approved  
chargers designated for this device. Use  
of an unapproved charger may present a  
risk of fire, explosion, leakage, or other  
hazard.  
lose its charge over time.  
Always try to keep the battery between  
15°C and 25°C (59°F and 77°F). Extreme  
temperatures reduce the capacity and  
lifetime of the battery. A device with a  
hot or cold battery may not work  
temporarily. Battery performance is  
particularly limited in temperatures well  
below freezing.  
Do not dispose of batteries in a fire as  
they may explode. Batteries may also  
explode if damaged.  
If a battery is being used for the first time  
or if the battery has not been used for a  
prolonged period, it may be necessary to  
connect the charger, then disconnect and  
reconnect it to begin charging the  
battery. If the battery is completely  
discharged, it may take several minutes  
before the charging indicator light is  
displayed.  
Never use any charger that is damaged.  
Important: Battery talk and  
standby times are estimates  
only and depend on network  
conditions, features used, battery age  
and condition, temperatures to which  
battery is exposed, and many other  
factors. The amount of time a device is  
used for calls will affect its standby time.  
Likewise, the amount of time that the  
Unplug the charger from the electrical  
plug and the device when not in use. Do  
not leave a fully charged battery  
ENGLISH  
device is turned on and in the standby  
mode will affect its talk time.  
Care and maintenance  
Your device is a product of superior  
design and craftsmanship and should be  
treated with care. The following  
suggestions will help you protect your  
warranty coverage.  
Do not store the device in cold areas.  
When the device returns to its normal  
temperature, moisture can form  
inside the device and damage  
electronic circuit boards.  
Keep the device dry. Precipitation,  
humidity, and all types of liquids or  
moisture can contain minerals that  
will corrode electronic circuits. If your  
device does get wet, allow it to dry  
completely.  
Do not attempt to open the device.  
Do not drop, knock, or shake the  
device. Rough handling can break  
internal circuit boards and fine  
mechanics.  
Do not use harsh chemicals, cleaning  
solvents, or strong detergents to  
clean the device.  
Do not use or store the device in  
dusty, dirty areas. Its moving parts  
and electronic components can be  
damaged.  
Do not paint the device. Paint can  
clog the moving parts and prevent  
proper operation.  
Do not store the device in hot areas.  
High temperatures can shorten the  
life of electronic devices, damage  
batteries, and warp or melt certain  
plastics.  
These suggestions apply equally to your  
device, charger, or any accessory. If any  
device is not working properly, take it to  
ENGLISH  
the nearest authorised service facility for your local Nokia representative. Check  
service.  
how to recycle your Nokia products at  
browsing on a mobile device,  
Recycle  
The crossed-out wheeled-bin  
symbol on your product, battery,  
literature, or packaging reminds  
you that all electrical and electronic  
products, batteries, and accumulators  
must be taken to separate collection at  
the end of their working life. This  
requirement applies in the European  
Union. Do not dispose of these products  
as unsorted municipal waste. For more  
environmental information, see the  
product Eco-Declarations at  
Always return your used electronic  
products, batteries, and packaging  
materials to a dedicated collection point.  
This way you help prevent uncontrolled  
waste disposal and promote the recycling  
of materials. More detailed information  
is available from the product retailer,  
local waste authorities, national  
producer responsibility organisations, or  

Quasar PLAMCORDER VM L451 User Manual
PYLE Audio PLRD195IF User Manual
plawa feinwerktechnik GmbH CoKG Spypen aias 13 User Manual
Pioneer DEH20UB User Manual
Pioneer Car Amplifier GM X362 User Manual
Philips VKR 6870 User Manual
Nikon Sporter EX 10x50 User Manual
Nikon Coolpix 5400 User Manual
Lochinvar KNIGHT 81 286 User Manual
JVC GZ MG20AH User Manual