Nikon ONESHOT360 360TM User Manual

Nikon CoolPix950 Instructions for  
OneShot360™  
Recommended Camera Settings  
Turn the camera on to the manual recording mode (M-REC)  
Set image quality to Fine. This is accomplished by holding down the "QUAL" button  
located below the color LCD screen and rotating the dial located in front of and below the  
shutter release button until "FINE" appears in the lower right hand corner of the color LCD  
screen.  
Disable the flash. To toggle between the different flash modes, including OFF, press the  
flash mode button located to the right of the small digital LCD screen near the shutter  
release button. The flash mode is indicated on both LCD screens (on the right hand side  
of the small digital LCD screen and in the upper right hand corner of the larger color LCD  
screen).  
We recommend zooming in until the circular OneShot360 image exactly fills the digital  
camera LCD viewer screen. If you zoom in too much, you will lose part of the field of view.  
If you zoom in too little, you will not get maximum resolution. Note also that the  
OneShot360 image may not be exactly centered in the LCD screen – this is normal. The  
zoom control is located on the same side of the camera as the color LCD screen in the  
upper right hand corner. You must re-calibrate the zoom level after powering the camera  
down.  
For indoor shots, put the camera in aperture priority mode. This is done by holding down  
the "MODE" button located below the color LCD screen and rotating the dial in front of and  
slightly below the shutter release button. You are in aperture priority mode when the letter  
"A" appears in the lower left hand corner of both LCD screens. Next set the camera to the  
middle of 3 aperture settings (approximately F4.7 at the correct zoom level for  
OneShot360 images). You can see the aperture value in the lower middle portion of the  
color LCD screen and also in the smaller digital LCD screen. For outdoor shots, automatic  
exposure is fine. This mode is indicated by the letter "P" in the lower left hand corner of  
both LCD screens.  
The Nikon CoolPix 950 is equipped with a timer. This allows the photographer to exit the  
area before the shot is taken. This button is located on the same side of the camera as  
the smaller digital LCD screen, on the lower right hand side. Press the button 3 times until  
the timer symbol appears in the upper left hand corner of the color LCD screen. The timer  
must be manually re-enabled for each shot that you want to use it.  
Now make sure the camera is set to a focal distance of 1.5 meters. The button for placing  
the camera in manual focus mode is the same as that for setting the timer, so if you want  
to use both the timer and a manual focus setting, you must enable the timer first.  
Otherwise the camera will be set back to auto focus mode when you enable the timer. To  
input a manual focus distance, press and hold down the manual focus mode button as  
you rotate the dial located just in front of and below the shutter release button. Rotate that  
dial until 1.5 appears on either LCD screen.  
Telephone:  
Facsimile:  
508-870-1500  
508-870-8777  

Rockford Fosgate FRC2204T User Manual
Polaris D7500 User Manual
Magnat Audio PRO 1320 User Manual
Lochinvar KNIGHT XL 801 User Manual
Listen Technologies DCN LBB 3300 User Manual
Kramer Electronics Car Amplifier PT 101R User Manual
Kenwood X SE9 User Manual
Kenwood KDC MP345U User Manual
Kenwood KDC 2022V User Manual
JVC KW AVX810J User Manual