Metra Electronics AW 341GO User Manual

KIT FEATURES  
ALL VEHICLES  
Shaft and  
DIN unit  
4
3
provisions  
Fig. A  
Fig. A  
99-3410  
AW -341GO  
DW -3410  
INSTALLATION  
Equalizer  
provisions  
KIT COMPONENTS  
Fig. B  
g. B  
Radio Housing  
INSTRUCTIONS  
APPLICATIONS  
2-SHAFT HEAD UNITS:  
Slide the  
IF AN EQUALIZER WILL BE INCLUDED :  
aftermarket head unit into the kit and  
secure with shaft nuts. (seeFig.A)  
Slide the aftermarket equalizer into the back of  
the Radio Housing.  
Using the hardware  
CAR  
PAGE  
included with the equalizer, mount the unit to  
DIN HEAD UNITS:  
shaft supports. Slide the DIN cage into the  
Cut and remove the  
the kit. (seeFig.A)  
CHEVROLET  
Tracker 1998-04..........................................................1  
GEO  
Metro 1992-94............................................................1  
Tracker 1992-97..........................................................1  
SUZUKI  
Aerio 2003.................................................................. 2  
Esteem 1995-03..........................................................2  
Sidekick 1992-98........................................................1  
Swift 1992-94............................................................. 1  
Vitara series 1999-04.................................................1  
RadioHousing and secure by bending the  
IF AN EQUALIZER WILL NOT BE  
metal locking tabs down.  
Slide the  
INCLUDED:  
Snap the Equalizer Dummy  
Equalizer  
Dummy Plate  
aftermarket head unit into the cage until  
secure. (seeFig.B)  
Plate into theRadioHousing. (seeFig.B)  
(4) #8 x 1" Phillips  
Pan-Head Screws  
5
6
A
B
C
(4) Speed Clips  
D
WIRING AND ANTENNA CONNECTIONS (Sold Separately)  
Harness:  
applications  
Antenna Adapter:  
A) Strip wire ends back ½"  
B) Twist ends together  
C) Solder  
TOOLS REQUIRED  
• 40-GM10 - GM antenna adapter 88-up  
D) Tape  
P
KNOWLEDGE IS OWER  
Phillips screwdriver  
Locate the factory wiring harness in the  
dash. Metra recommends using the  
proper mating adaptor and making  
connections as shown. (Isolate and  
individually tape off the ends of any  
unused wires to prevent electrical short  
circuit).  
Enhance your installation and fabrication skills  
by enrolling in the most recognized and respected  
mobile electronics school in our industry.  
Re-connect the battery terminal and test the unit  
for proper operation. Slide (4) Speed Clips over  
the holes in the sub-dash mounting brackets and  
mount the head unit/kit assembly with (4)Phillips  
Pan-HeadScrews supplied.  
or call 800-354-6782 for more information  
and take steps toward a better tomorrow.  
Cutting tool  
Wrench  
1-800-221-0932  
© COPYRIGHT 2001-2009 METRA ELECTRONICS CORP.  
REV. 07-29-09  
3

RCA L32WD22 User Manual
Planar Systems Car Video System PCT2485 User Manual
Pioneer MULTI PLAYER CDJ 2000 User Manual
Pioneer HTZ BD50 User Manual
Philips Stereo System MCM1120 User Manual
Orion Car Audio 4004 User Manual
Metra Electronics 99 7337B User Manual
KitchenAid KUWO24RSBX00 User Manual
Kenwood KAC 629S User Manual
JVC TS C421SPGU User Manual