Metra Electronics 99 7334 User Manual

INSTALLATION INSTRUCTIONS FOR PART 99-7334  
APPLICATIONS  
KIA Borrego 2009  
99-7334  
KIT FEATURES  
DIN Radio Provision  
ISO DIN Radio Provision  
Double DIN Radio Provision  
Stacked ISO Mount Units Provision  
KIT COMPONENTS  
A) Radio Housing B) ISO Trim Plate C) ISO Brackets D) Double DIN Trim Plate  
E) Double DIN Brackets F) Pocket  
B
E
C
Wiring &Antenna Connections (sold separately)  
A
70-7303 - Hyundai / Kia Harness 2009  
40-KI10 - Kia Antenna Adapter 2007-up  
D
F
TOOLS REQUIRED:  
Small Flat Blade Screwdriver/ Panel Removal Tool  
Phillips Screwdriver  
1-800-221-0932  
© COPYRIGHT 2010 METRA ELECTRONICS CORPORATION  
99-7334 DASH DISASSEMBLY  
KIA BORREGO 2009  
A
1
Disconnect the negative battery  
terminal to prevent an accidental  
short circuit.  
2
3
Unclip and remove the side trim  
panels. (Figure A)  
Remove (4) Phillips screws securing  
the radio and (2) Phillips screws  
securing the A/C vent panel above the  
radio. (Figure B)  
4
Unclip and remove the radio and A/C  
vent panel as one piece then unplug  
the radio and vent panel and separate.  
(Figure C)  
B
Continue to kit assembly.  
C
1
99-7334 KIT ASSEMBLY  
DIN RADIO PROVISION  
*Note: Refer also to the instructions included with the aftermarket radio.  
A
1
Slide the DIN cage into the Radio  
Housing and secure by bending the  
metal locking tabs outward. (Figure A)  
2
3
Slide the aftermarket radio into the  
cage until it snaps into place. (Figure B)  
Snap the pocket into the bottom  
opening of the radio housing. (Figure C)  
Continue to final assembly.  
B
C
2
99-7334 KIT ASSEMBLY  
ISO MOUNT RADIO PROVISION  
*Note: Refer also to the instructions included with the aftermarket radio.  
A
1
2
Mount the ISO Brackets to the radio  
using the screws supplied with the  
radio. (Figure A)  
Slide the radio/bracket assembly into  
the radio housing until it snaps into  
place. (Figure B)  
3
4
Snap the ISO Trim plate onto the front  
of the Radio Housing. (Figure C)  
B
Snap the pocket into the bottom  
opening of the radio housing.  
(Figure D)  
Continue to final assembly.  
D
C
3
99-7334 KIT ASSEMBLY  
DOUBLE DIN/STACKED ISO MOUNT UNITS PROVISION  
*Note: Refer also to the instructions included with the aftermarket radio.  
A
1
2
Cut and remove the center bar from  
the radio housing. (Figure A)  
Snap the Double DIN brackets to the  
inside edge of the Radio Housing.  
(Figure B)  
3
4
Slide the Double DIN or stacked ISO  
mount unit(s) into the bracket/radio  
housing assembly and secure the  
unit(s) to the assembly using the  
screws supplied with the unit(s).  
(Figure C)  
B
Snap the Double DIN Trim plate onto  
the front of the Radio Housing.  
(Figure C)  
Continue to final assembly.  
C
4
99-7334 FINAL ASSEMBLY  
FINAL ASSEMBLY  
A
B
(A) Strip wire ends back 1/2"  
B) Twist ends together  
C) Solder  
D) Tape  
C
D
Locate the factory wiring harness in the dash. Metra recommends using the  
proper mating adapter and making connections as shown. (Isolate and individ-  
ually tape off the ends of any unused wires to prevent electrical short circuit.)  
1
2
3
Re-connect the negative battery terminal and test the unit for proper operation.  
Reassemble radio and dash assemblies in reverse order of disassembly.  
FINAL WIRING CONNECTIONS  
Make wiring connections using the EIA color code chart shown below and the instructions included with the  
head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and  
individually tape off ends of any unused wires to prevent electrical short circuit.  
METRA / EIA WIRING CODE  
12V Ignition / Acc. . . . . . . . . . Red  
Right Front (+) . . . . . . . . . . . . Gray  
12V Batt / Memory. . . . . . . . . Yellow  
Ground. . . . . . . . . . . . . . . . . . Black*  
Power Antenna. . . . . . . . . . . . Blue  
Right Front (-). . . . . . . . . . . . . Gray/ Black  
Left Front (+) . . . . . . . . . . . . . White  
Left Front (-). . . . . . . . . . . . . . White / Black  
Right Rear (+) . . . . . . . . . . . . Violet  
Amp Turn-On . . . . . . . . . . . . . Blue / White  
Amp Ground. . . . . . . . . . . . . . Black / White  
Illumination . . . . . . . . . . . . . . Orange  
Dimmer . . . . . . . . . . . . . . . . . Orange / White  
Right Rear (-) . . . . . . . . . . . . . Violet / Black  
Left Rear (+) . . . . . . . . . . . . . Green  
Left Rear (-) . . . . . . . . . . . . . . Green / Black  
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.  
All colors may not be present on all leads due to manufacturer’s specifications.  
Enjoy your newly installed radio!  
5
99-7334 INSTRUCTIONS  
1-800-221-0932  
REV. 09/01/10 © COPYRIGHT 2010 METRA ELECTRONICS CORPORATION INST99-7334  

RCA EZ4000RD User Manual
Quantum Car Speaker qc12s4 User Manual
PYLE Audio View Series PLHR4M User Manual
Pioneer BDP 53FD User Manual
Newcon Optik NVS 7 8X User Manual
Metra Electronics 99 7009 User Manual
Marshall electronic Marshall Electronics Car Stereo System MXL V67Q User Manual
Kenwood KAC 629S User Manual
JVC KD SV3105 User Manual
JVC GZ MG20AG User Manual