Metra Electronics 95 7331 User Manual

INSTALLATION INSTRUCTIONS FOR PART 95-7331  
APPLICATIONS  
KIA Amanti  
2007-2009  
95-7331  
KIT FEATURES  
• Double DIN Radio Provision  
• Stacked ISO Mount Units Provision  
KIT COMPONENTS  
A) Radio Housing B) Double DIN Brackets  
A
B
TOOLS REQUIRED:  
Small Flat Blade Screwdriver/ Panel Removal Tool  
• Phillips Screwdriver • Socket set  
1-800-221-0932  
© COPYRIGHT 2007-2008 METRA ELECTRONICS CORPORATION  
95-7331 DASH DISASSEMBLY  
KIA AMANTI 2007-2009  
1
2
Disconnect the negative battery ter-  
minal to prevent an accidental short  
circuit.  
A
B
C
Unclip the top half of the shift knob  
and remove the “C” clip securing the  
shifter. Pull up on shifter to remove.  
(Figure A)  
Unclip and remove the panel surround-  
ing the shifter. (Figure B)  
3
4
3
2
1
Unclip and remove top half of center  
console including the cup holders.  
(Figure C)  
Open center console and remove  
screw cover in bottom. (Figure D)  
5
6
Remove (2) 10 MM bolts securing  
compartment then unclip and remove  
the compartment. (Figure D)  
Continue to kit assembly.  
D
1
95-7331 DASH DISASSEMBLY  
KIA AMANTI 2007-2009  
7
8
Unclip the rear trim panel from the  
E
center console including a/c vents.  
Unplug and remove the rear trim  
panel. (Figure E)  
Remove (1) Phillips screw from each  
side at the rear of the center console.  
(Figure E)  
Unclip the side panels from the front of  
the center console. It is not necessary  
to remove these panels. (Figure F)  
9
Remove (4) Phillips screws securing  
center console then lift and slide the  
center console back out of the way.  
Note: You do not have to take the cen-  
ter console all the way out. (Figure G)  
10  
F
Remove (1) Phillips screw from each  
side panel then unclip and remove  
the side panels. (Figure H)  
11  
12  
13  
Remove (4) Phillips screws securing  
the radio. Unplug and remove the  
radio.  
Unclip and remove the switches and/  
or switch covers along the top of the  
factory radio. (Retain switches  
and/or covers to be reinstalled in  
the radio housing.)  
G
Continue to kit assembly.  
H
2
95-7331 KIT ASSEMBLY  
DOUBLE DIN RADIO PROVISION  
STACKED ISO MOUNT UNITS PROVISION  
*Note: Refer also to the instructions included with the aftermarket radio.  
1
2
Snap the switches into the radio hous-  
ing in the same location as removed  
from the factory radio. (Figure A)  
A
Snap the Double DIN brackets to the  
inside edge of the Radio Housing.  
(Figure B)  
3
Slide the Double DIN Radio or stacked  
ISO Mount units into the bracket/radio  
housing assembly and secure to the  
assembly using the screws supplied  
with the radio or ISO mount units.  
(Figure C)  
B
Continue to final assembly.  
C
3
95-7331 FINAL ASSEMBLY  
FINAL ASSEMBLY  
A
B
(A) Strip wire ends back 1/2"  
B) Twist ends together  
C) Solder  
D) Tape  
C
D
Locate the factory wiring harness in the dash. Metra recommends using the  
proper mating adapter and making connections as shown. (Isolate and individ-  
ually tape off the ends of any unused wires to prevent electrical short circuit.)  
1
2
3
Re-connect the negative battery terminal and test the unit for proper operation.  
Reassemble radio and dash assemblies in reverse order of disassembly.  
FINAL WIRING CONNECTIONS  
Make wiring connections using the EIA color code chart shown below and the instructions included with the  
head unit. Metra recommends making connections as shown below; Strip, Splice, Solder, Tape. Isolate and  
individually tape off ends of any unused wires to prevent electrical short circuit.  
METRA / EIA WIRING CODE  
12V Ignition / Acc. . . . . . . . . . Red  
Right Front (+) . . . . . . . . . . . . Gray  
12V Batt / Memory. . . . . . . . . Yellow  
Ground. . . . . . . . . . . . . . . . . . Black*  
Power Antenna. . . . . . . . . . . . Blue  
Right Front (-). . . . . . . . . . . . . Gray/ Black  
Left Front (+) . . . . . . . . . . . . . White  
Left Front (-). . . . . . . . . . . . . . White / Black  
Right Rear (+) . . . . . . . . . . . . Violet  
Amp Turn-On . . . . . . . . . . . . . Blue / White  
Amp Ground. . . . . . . . . . . . . . Black / White  
Illumination . . . . . . . . . . . . . . Orange  
Dimmer . . . . . . . . . . . . . . . . . Orange / White  
Right Rear (-) . . . . . . . . . . . . . Violet / Black  
Left Rear (+) . . . . . . . . . . . . . Green  
Left Rear (-) . . . . . . . . . . . . . . Green / Black  
*NOTE: When a Black wire is not present, ground radio to vehicle chassis.  
All colors may not be present on all leads due to manufacturer’s specifications.  
4
95-7331  
NOTES  
5
95-7331 INSTRUCTIONS  
1-800-221-0932  
REV. 09/12/08 © COPYRIGHT 2007-2008 METRA ELECTRONICS CORPORATION INST95-7331  

Raypak Gas Fired Boiler User Manual
Polk Audio Car Speaker MM6 User Manual
Pioneer PRS D3000SPL User Manual
Pioneer DEH 64BT User Manual
PB Heat EC Series User Manual
Niles Audio INTELLIPAD TS 1 User Manual
M&S Systems Car Amplifier User Manual
Lochinvar Condensing Boiler User Manual
KitchenAid KFP720OB1 User Manual
Kenwood Car Stereo System TM 231E User Manual