JBL P550c User Manual

c o m p o n e n t  
s y s t e m s  
o w n e r ’s  
m a n u a l  
T H A N K Y O U  
for purchasing a JBL Power Series®  
automotive loudspeaker component  
system. Weve organized this manual  
to make your installation as simple and  
trouble-free as possible. Please read it  
thoroughly before proceeding. Remember  
to keep your sales receipt and this manual in a  
safe place so both are available for future reference.  
IN S TA LLA T IO N  
C O N N E C T IO N S  
Figure 5. Mounting the tweeter using  
the I-Mount flush-mounting kit.  
Open the crossover housing by firmly squeezing the sides  
of the top half and lifting it away from the bottom. Using  
screws or a wire tie, mount the crossover using the holes  
provided. Observing proper polarity, connect the speakers  
and amplifier as shown in Figures 8A and 8B. Replace the  
cover when you are finished making the connections and  
adjustments (see following section).  
The Power Series component crossover features a  
tweeter-level adjustment. The tweeter level may be set to  
0dB (flat response), or it may be attenuated by approxi-  
mately 3dB to suit the listeners preference. The factory  
default position is 0dB; if this is the desired setting, it is  
not necessary to make any changes.  
4
)
blk  
red  
+
3
)
1) push in  
If a reduced tweeter output level is desired, carefully  
remove the small plastic jumper from the pins marked  
“0dB” and place it across the two pins marked “–3dB”  
(refer to drawings below).  
Figure 8A. Wiring connections  
on the crosssover network  
(shown with cover on).  
2
)
turn  
Figure 6. Aiming the tweeter at a  
desired listening position.  
Jumper  
3. Rotate to aim  
angled tweeter  
toward listener.  
P O W E R P 5 5 0 C  
2 R 0  
0dB  
1. Slide screw up or  
down to adjust  
tweeter angle.  
-3dB  
R1  
Flat  
2R0  
Red  
C 2  
0dB  
To AMPLIFIER  
SPEAKER OUTPUTS  
2.Tighten nut and  
washer to lock  
angle settings.  
-3dB  
0dB  
To TWEETER  
To WOOFER  
Blk  
In- In+ W- W+ T- T+  
-3dB  
Figure 8B. Locating wiring connections  
on the P552 woofer. Other woofers  
are wired similarly.  
4. Securely tighten  
the large hand nut.  
–3dB  
Jumper  
Figure 7. Mounting the tweeter using  
the I-Mount surface-mounting kit.  
blk  
+
red  
1
Big Lug =  
2
Sm all Lug =  
S P E C IF IC A T IO N S  
P550c  
P650c  
Type:  
5-1/4" two-way component system  
6-1/2" two-way component system  
Speaker Impedance:  
Power Handling:  
Sensitivity (2.83V, 1m):  
Frequency Response:  
Mounting Depth:  
Cut-Out Diameter:  
4 ohms  
4 ohms  
70W RMS, 210W Peak  
89dB  
90W RMS, 270W Peak  
90dB  
55Hz – 23kHz  
2-316" (56mm)  
4-11/16" (120mm)  
45Hz – 23kHz  
2-1/4" (58mm)  
5-1/16" (129mm)  
GENERAL CARE  
The loudspeaker grilles may be cleaned with a damp cloth. Do not use any cleaners or solvents on the grilles or the speaker cones.  
A valid serial number is required for warranty coverage.  
Features, specifications and appearance are subject to change without notice.  
Declaration of Conformity  
We, Harman Consumer International  
2, route de Tours  
72500 Chateau-du-Loir  
France  
JBL Consumer Products  
declare in own responsibility that the products  
described in this owner’s manual are in compliance  
with technical standards:  
250 Crossways Park Drive, Woodbury, NY 11797 USA  
1.800.336.4JBL (4525) • FAX 1.516.682.3523 • www.jbl.com  
© 2003 Harman International Industries, Incorporated  
EN 50081-1:1992  
EN 50082-1:1997  
JBL is a registered trademark of  
Harman International Industries, Incorporated.  
Emmanuel Millot  
Harman Consumer International  
Chateau-du-Loir, France. 2/03  
Part No. P550C/P650COM2/03  

Black Decker BL10451 User Manual
Bosch Appliances 15SBI User Manual
Bose Bluetooth AM347801 User Manual
Cuisinart CSB 80 User Manual
Curtis RCD641 User Manual
FujiFilm FinePix S4000 User Manual
GE 681131690997 User Manual
Gemini XGA 4000 User Manual
Haier HVFM20A User Manual
Jensen MCD6115 User Manual