H2O Audio Capture iN5 BK User Manual

Replacing the Seal  
Silicone Seal Replacement  
Instructions  
1. Unlatch and open case.  
2. Starting at any corner, gently remove the  
seal. Do not stretch or pull on the seal.  
The H2O Audio Capture Waterproof CaseTM  
features a removable, black silicone seal  
that forms a waterproof barrier between  
the base and lid of the case. It is extremely  
important that special attention is paid to  
ensure the seal is completely seated in the  
groove of the lid. If the seal is loose, out of  
alignment, twisted or pinched in any way, it  
will compromise the waterproof integrity of  
the case and should not be used. Any debris  
such as hair or sand will keep it from  
3. To install a new or clean seal, start at any  
corner, push the seal into the corner and  
run your finger along the seal to ensure it is  
seated completely on all four sides and  
corners.  
forming a watertight barrier and should be  
cleaned off before use.  
4. Gently close the lid and lock the latch.  
The lid should close without any resistance.  
If you experience any resistance when  
closing the case please call customer  
service immediately.  
The life of the seal is typically one year. A  
replacement seal has been provided for  
annual replacement, accidental damage,  
loss, overexposure to direct sunlight, or if  
the seal has become misshaped though  
misuse. Please contact H2O Audio Customer  
Support for additional silicone seals.  
Replacing the Seal  
Cleaning and Storing the Seal  
5. Visually inspect the outside of the case  
and ensure the seal is installed correctly. If  
the seal is dirty, out of alignment, twisted  
or pinched in any way it will compromise  
the integrity of the case and should not be  
used.  
It is extremely important that you keep the  
seal clean and free of sand, dirt, hair, lint,  
and other debris.  
To clean the seal, remove it from the case  
and wash with warm fresh water. Strong  
detergents, soaps, and chemicals should  
never be used to clean the seal. Allow seal  
to air dry and install back into the case.  
Do not expose the case to extreme heat,  
such as the inside of a hot car, or in hot  
direct sunlight, such as on a beach, or boat  
deck. Doing so may cause damage and  
subsequent flooding.  
Correct  
This seal is correctly seated in a closed  
case, sealing the case and protecting  
the iPod from water.  
The seal does not require lubrication. Do  
not use silicone grease to lubricate the seal.  
Customer Support is available:  
Monday - Friday 9AM to 5PM PT  
P. 800-708-6080 or 858-623-0339  
F. 858-225-0815  
Incorrect  
This seal is misaligned and has been  
pinched between the base and the lid,  
creating an opening that will cause the  
case to flood.  

Aiwa CT X421 User Manual
Alpine IXA W407 User Manual
Canon ETT555 User Manual
Canon HF R500 9176B002 User Manual
Canon IMAGEANYWARE DC100 User Manual
Hitachi DZ BX35A User Manual
Hypertec N14558PHY User Manual
Interfire Audio TUNN T 270 User Manual
JBL GTO301 1 User Manual
JBL GTO502 User Manual