EdgeStar 866 319 5473 User Manual

For assistance, please call:  
Beer Dispenser  
Installation Guide  
866-319-5473  
Thank you for purchasing the EdgeStar Beer Dispenser.  
Are you ready to enjoy some draft beer now?  
All you need is:  
1
Included components (pictured to the left)  
Wrench  
Flat head screwdriver  
Pair of pliers/clamp crimper  
Full keg of beer (1/2 barrel size or smaller [pictured to the left but not included])  
2
3
Note: Any Coors Brand or Miller Rubber Sided kegs will not fit inside this unit.  
Also, fill the included CO tank with CO (Most beer keg providers can fill your CO tank)  
2
2
2
Notice: this manual is provided as a supplement to the owner’s manual. Please refer to the owner’s  
manual for a full discourse on installation, usage and maintenance.  
4
Note: Parts listed throughout this installation guide are numbered according to the diagram parts list.  
5
Install Caster Wheels  
Make sure unit is empty (including white metal keg floor(11)). Carefully  
tip the beer dispenser on its side. Connect the casters(13) to the cabinet  
by screwing in each metal bracket into one of four caster holes (casters  
in the front of the cabinet require the washers(12)). Then carefully set  
the unit upright  
Note: allow dispenser to stand in an upright position for 8 hours  
before turning on the power.  
1
6
10  
Remove Plug  
7
Open the door, and with your hand push the top cabinet plug  
through the top of the cabinet. Use flat head screwdriver as a prying  
tool if necessary.  
2
8
Install Tower  
17  
Now begin installing the tower(3). Unravel the beer line hose from the  
3a  
bottom of the tower, and feed the hex nut and beer line through the hole  
you uncovered in the top of the cabinet.  
9
11  
Secure Tower  
Once you have fed all the line into the cabinet, you can now place the  
tower into the unit. Align the black plastic adapter on the bottom of the  
tower to the hole in the top of the cabinet. The adapter should mate  
securely with the hole. Then turn the adapter about 25° to lock it into  
place. The faucet connection for the tower should now face the front of the  
cabinet. If the tower is not facing the front of the cabinet, remove it and  
reinstall it from another position.  
3b  
14  
15  
18  
12  
13  
Parts List  
1. Faucet Handle  
2. Faucet  
10. American Sankey Keg Coupler  
11. Metal Keg Floor Support  
12. Caster Washer (x2)  
13. Casters (x4)  
14. Neoprene Washer  
15. Snap-On Clamps (x2)  
16. Wire Shelves (not shown) (x2)  
17. Half Barrel Keg (not included)  
18. Faucet Wrench  
Install Railing  
3. Beer Tower  
4. Guard Rail  
5. Drip Tray  
6. Regulator  
Take the railing(4) and slide its  
4
“feet” into the pilot holes in the  
top of the cabinet  
7. CO Tube  
2
8. CO Cylinder (supplied empty)  
2
9. Cylinder Holder  
Warning: This guide is provided for informational purposes only. If you have any questions about  
the installation of this appliance, feel free to contact EdgeStar service at 866.319.5473 or consult  
a qualified installer. Neither the manufacturer nor its distributors shall be liable for any incidental,  
consequential, indirect, special, or punitive damages of any nature, including without limitation,  
lost revenues or profits, or any other damage whether based in contract, tort, or otherwise.  
Warning: CO can be dangerous! CO cylinders contain high-pressure gas, which can be hazardous if  
2
2
handled improperly. Please handle with care.  
Note: Included accessories may not be as pictured  
1

Aiphone Car Video System A User Manual
AIPTEK V2T6 User Manual
ATN NVG7 User Manual
Cornelius ICE FROST User Manual
Cuisinart Smart Stick CSB 77 User Manual
Huey Chiao HCS32 User Manual
Interfire Audio G4 600 User Manual
JVC CS V6 SERIES CS V6936 User Manual
JVC GET0651 001A User Manual
JVC GR DVL167 User Manual