Digital Concepts 418AF User Manual

DIGITAL SLAVE FLASH  
Item #418AF  
For Use with Digital or Film Cameras  
Your Digital Slave Flash will work with cameras that have a built in hot shoe, by connecting  
this device to the camera’s hot shoe and switching the unit to NORMAL mode. If your camera  
does not have a built in hot shoe this unit can be used by switching to Slave On mode. This  
device features four slave modes that allow it to work with cameras that fire their built-in flash  
instantaneously as well as cameras that have single or multiple flash red-eye reduction  
systems. Please check your camera’s owner’s manual to determine which flash system your  
camera has.  
Remote Flash Photography (for cameras that do not have a built in hot shoe)  
Put the Mode Select Switch in the Slave On position, and then place the Function Switch to  
one of the S1, S2, S3, or S4 positions to match your camera’s flash system using the  
definitions listed below:  
S1: Instant synchronization. This device fires after it senses the first flash fired from the  
camera.  
S2: This device fires after it senses the second flash fired from the camera.  
S3: This device fires after it senses the third flash fired from the camera.  
S4: This device fires after it senses the fourth flash fired from the camera.  
*After the green Ready light glows the device is ready to use. You should now switch the  
flash of your camera to “On”.  
*Point your camera towards the subject you are photographing and take a picture after both  
flashes indicate they are ready for operation. The ready lights on both flashes should be  
glowing in order to begin.  
*The Digital Slave Flash will automatically fire each time the camera’s flash fires.  
You may also wish to use the Digital Slave Flash as an extra light, in order to illuminate the  
object you are photographing from a different angle than your camera’s built in flash. To do  
so, simply place your Digital Slave Flash where you might want an extra light to be, and follow  
the above instructions.  
Direct Hot Shoe Photography (for cameras with a built in hot shoe)  
If your camera has a built in hot shoe, you can directly mount your Digital Slave Flash to your  
camera. Once you do so, put the Mode Select Switch in the Normal position and wait for the  
Ready light to glow on your Digital Slave Flash, and proceed to take a photo.  
Inserting Batteries (batteries not included)  
Your Digital Slave Flash requires 4 AA batteries. Alkaline or Ni-MH batteries should be used  
only. Do not use Ni-Cd batteries. To insert batteries correctly, first remove the battery cover  
from the Digital Slave Flash. Then insert the batteries by following the directions on the  
diagram inside the battery compartment. Close the battery cover once your batteries are  
properly inserted.  
Replacing Your Batteries  
If the green READY light on your Digital Slave Flash does not glow within 20 seconds then the  
batteries are overly drained and need to be replaced, or recharged if possible. It is  
recommended that you remove the batteries from your Digital Slave Flash when the unit is not  
in use for extended lengths of time.  

Alpine CDE 7856 User Manual
AudioBahn MULTIFUNCTIONAL SOURCE UNIT A3351 User Manual
Canon Camera Accessories 40D User Manual
Dual SXSERIES SX652 User Manual
Eizo Nanao Car Video System CG232W User Manual
Garmin Boating Equipment 906 1090 05 User Manual
Hifionics HS800 4 User Manual
HP (Hewlett Packard) Hewlett Packard Car Video System 2310 User Manual
Hypertec N10339PHY User Manual
Hypertec N16168LHY User Manual