Blaupunkt IVSC 5501 User Manual

In Car Video  
IVSC-5501  
Operating and installation instructions  
SAFETY INFORMATION  
General  
Installation and safety notices  
Thank you for deciding to use a Blau- Before connecting your signal conver-  
punkt product. We hope you enjoy us- ter, please read the following informati-  
ing this new piece of equipment.  
on carefully.  
Please read these operating instruc- The battery’s negative terminal must  
tions before using the equipment for remain disconnected whilst you are  
the first time.  
installing and connecting the unit.  
The Blaupunkt editors are constantly Whilst doing so, you must observe the  
working on making the operating in- vehicle manufacturer’s safety notices  
structions clearer and easier to under- (airbags, alarm systems, trip computers,  
stand. However, if you still have any immobilizers).  
questions on how to operate the equip-  
Before drilling any holes, you must make  
ment, please contact your dealer or the  
sure that no installed cables or vehicle  
telephone hotline for your country. You  
components can be damaged.  
will find the telephone numbers printed  
When installing the signal converter, se-  
at the back of this booklet.  
lect a location in the vehicle that allows  
We provide a manufacturer guarantee  
you to attach it firmly into place using  
for our products bought within the Eu-  
screws. The installation location should  
ropean Union. You can view the guar-  
be such that the signal converter does  
antee conditions at www.blaupunkt.de  
not get in the way of the driver and can-  
not endanger the occupants in the event  
or ask for them directly at:  
of the vehicle suddenly coming to a halt,  
Blaupunkt GmbH  
for instance, during an emergency stop.  
Hotline CM/PSS 6  
Robert Bosch Str. 200  
D-31139 Hildesheim  
Accessories  
We recommend you use accessories  
that have been approved by Blaupunkt.  
12  
SUPPLIED EQUIPMENT  
INSTALLATION  
Supplied equipment  
Installation  
The signal converter is supplied with all Note:  
the parts listed below. Please check that  
Before connecting the monitors to  
your signal converter, check that  
the +/- and the switched positive  
are connected properly. After con-  
necting the +/- and the switched  
positive, the red LED on the sig-  
nal converter must light up!  
the range of parts supplied with your de-  
vice is complete. If one of the listed parts  
is missing, please contact your dealer  
immediately.  
Signal Converter  
Connecting cable  
RGB adapter  
Positive connection  
Installation and operating instruc-  
Connect the fuse holder (5A fuse) to pro-  
tect the positive cable (3) (see Fig. 1).  
The fuse holder must be connected to  
the positive terminal at a distance of  
max. 30 cm from the vehicle battery (if  
necessary, drill a hole in the bulkhead  
use the appropriate cable grommets).  
tions  
Signal Converter  
7 607 003 550  
Switched positive  
Connect the switched positive cable (4)  
(see Fig. 1) to the switched positive out-  
put (  
) of the main system unit (e.g.  
car radio or navigation unit). If connect-  
ing to the vehicle’s terminal 15, you must  
connect a fuse holder (1A fuse) to pro-  
tect the switched positive cable (4) (see  
Fig. 1). The fuse holder must be con-  
nected to the positive terminal at a di-  
stance of max. 30 cm from the vehicle  
battery (if necessary, drill a hole in the  
bulkhead and use the appropriate ca-  
ble grommets).  
Connecting cable  
RGB adapter  
Negative (earth) connection  
Attach the negative cable (1) (see Fig. 1)  
directly to the vehicle body using a screw.  
Scratch the surface down to the bare  
metal at the point at which the earth con-  
tact is made and apply graphite grease  
(important for a good earth connection).  
13  
INSTALLATION  
If the installation requires holes to be  
drilled or any other changes to the  
vehicle to be made, please contact  
a specialist workshop in your area.  
Note:  
You cannot display PAL video on the  
wide vision TV monitor using the RGB  
input.  
In this case, the PAL video signal must  
be connected directly to the AV input of  
the wide vision TV monitor.  
14  
INSTALLATION  
12V  
Earth/GND  
(1)  
1
DC 12V IN  
Monitor  
(3)  
Audio in  
(4)  
+12V  
R1  
L1  
RGB IN  
+12V Permanent  
Fig. 1  
15  
INSTALLATION  
Video in  
1
2
3
4
DC 12V IN  
Monitor  
Audio in  
R1  
L1  
R2  
L2  
R3  
L3  
R4  
L4  
RGB IN  
Audio in  
RGB in  
Fuse ( 4 A)  
E
S
OUTPUT  
1
2
3
4
RGB OUT  
RGB out  
Monitors  
16  
CONNECTION DIAGRAM  
TravelPilot DX  
7 607 001 601 / 1,5 m  
7 607 001 602 / 4 m  
Signal converter  
7 607 001 600  
RGB adapter  
7 607 001 601 / 1,5 m  
7 607 001 602 / 4 m  
12V  
17  
CONNECTION DIAGRAM  
I V M S / R  
V i d e o o u t  
u d A i o R o u t  
u d A i o L o u t  
t e r v ( I e V r S C - 5 5 0 1 S ) i g n a l C o n  
18  
SPECIFICATIONS  
Features  
Specifications  
4 audio/video inputs:  
Video input:  
Cinch jacks  
Composite Video, 0.7 ~ 2.0 Vpp,  
75 Ohm  
1 RGB input:  
Audio input:  
15-pin Sub-D socket  
0 ~ 0.3 Vrms, 10-20 kHz  
4 monitor outputs:  
RGB input (video signal, internal re-  
sistance 100 ohm):  
CCVS 50Hz, 8-pin jack, with power,  
earth, switched positive  
min –1.0 / max 1.0 Vdc  
typical 0.7 / max 2.0 Vpp  
1 RGB output:  
15-pin Sub-D plug-type connector  
RGB input (composite-sync, internal  
resistance 100 ohm):  
Conversion:  
RGB (NTSC) 60 Hz in CCVS 50Hz  
CCVS 50Hz in RGB (NTSC) 60 Hz  
min –1.0 / max 1.0 Vdc  
min 0.7 / typical 1.0 / max 2.0 Vpp  
Power input:  
Video output:  
4-pin plug-type connector  
Composite Video, 0.7 ~ 2.0 Vp-p,  
75 Ohm  
Metal housing  
Audio output:  
0 ~ 0.3 Vrms, 10-20 kHz  
RGB output (video signal, internal re-  
sistance 100 ohm):  
min –1.0 / max 1.0 Vdc  
typical 0.7 / max 2.0 Vpp  
RGB output (composite sync, inter-  
nal resistance 100 ohm):  
min –1.0 / max 1.0 Vdc  
min 0.7 / typical 1.0 / max 2.0 Vpp  
Power supply:  
DC 12V, +/- 10%, max. 5A  
19  
Service-Nummern / Service numbers / Numéros du service après-  
vente / Numeri del servizio di assistenza / Servicenummers /  
Telefonnummer för service / Números de servicio / Números de  
serviço / Servicenumre  
Country:  
Phone:  
Fax:  
WWW:  
Germany  
(D)  
0180-5000225  
05121-49 4002  
Austria  
(A)  
(B)  
01-610 390  
02-525 5454  
01-610 393 91  
02-525 5263  
44-898 644  
09-435 99236  
01-4010 7320  
01-89583 8394  
01-576 9473  
01-4598830  
02-369 6464  
40 2085  
Belgium  
Denmark  
Finland  
France  
(DK) 44 898 360  
(FIN) 09-435 991  
(F)  
01-4010 7007  
Great Britain (GB) 01-89583 8880  
Greece  
Ireland  
Italy  
(GR) 0800-550 6550  
(IRL) 01-4149400  
(I)  
02-369 6331  
40 4078  
Luxembourg (L)  
Netherland  
Norway  
Portugal  
Spain  
(NL)  
023-565 6348  
66-817 000  
01-2185 00144  
902-120234  
08-7501500  
023-565 6331  
66-817 157  
01-2185 11111  
916-467952  
08-7501810  
01-8471650  
(N)  
(P)  
(E)  
(S)  
Sweden  
Switzerland (CH) 01-8471644  
Czech. Rep. (CZ)  
02-6130 0441  
01-333 9575  
0800-118922  
02-6130 0514  
01-324 8756  
022-8771260  
Hungary  
(H)  
Poland  
(PL)  
Turkey  
USA  
(TR)  
0212-3350677  
0212-3460040  
708-6817188  
(USA) 800-2662528  
Brasil  
(Mercosur)  
(BR) +55-19 3745 2769 +55-19 3745 2773  
Malaysia  
(Asia Pacific) (MAL) +604-6382 474  
+604-6413 640  
Blaupunkt GmbH  
05/02  
CM/PSS - 8 622 403 178  

Canon Camcorder ZR60 User Manual
Cateye CC 2000 User Manual
Elmo CCD Color Video Camera TNC4604 User Manual
Harman Stove Company SF360 User Manual
Hasbro Car Stereo System T1 50C User Manual
Hitachi Camcorder H720A User Manual
Interfire Audio G2 1200 User Manual
Jensen Tools JHD3510 User Manual
JVC GET0070 001A User Manual
JVC GET0621 001A User Manual