QCE12U
QCE24U
QCE42U
QuietCab Elite™ Cabinet Assembly Instructions
Follow these instructions to assemble your QuietCab Elite
Cabinet:
STEP 3. Position the corner posts (Item D) onto the base
(Item A) and secure with M6 socket button screws (Item G)
using the 4-mm Allen key (Item H).
Make sure you have the following items:
A. (1) base
STEP 1. Install the (4) caster plates (Item B) onto the base
(Item A).
B. (4) caster plates
C. (4) load-bearing casters with (16) M6 pozi pan screws
D. (4) corner posts with (16) M6 pozi pan screws
E. (4) mounting angles with (16) M6 pozi pan screws
F. (72) M6 pozi pan screws
G. (32) M6 socket button screws
H. (1) 4-mm Allen key
STEP 2. Secure the casters (Item C) to each plate (Item B)
using (4) M6 pozi pan screws (Item F).
I. (1) top cover
J. (4) depth-support rails with (16) M6 pozi pan screws
K. (4) infills with (24) M6 pozi screws
L. (8) 16-mm gasket foam side panels
M. (8) 100-mm front and rear gasket foam panels
N. (1) anti-recirculation kit ([5] pieces per side
and [6] pieces for top and bottom front)
O. (2) side panels
P. (1) front left door
Q. (1) front right door
R. (1) rear left door
S. (1) rear right door
© Copyright 2012. Black Box Corporation. All rights reserved. Black Box and the Double Diamond logo are registered trademarks, and Elite is a trademark, of BB Technologies,
Inc. Any third-party trademarks appearing in this document are acknowledged to be the property of their respective owners.
724-746-5500
|
blackbox.com
Page 1
STEP 7. Install the (4) infill panels (Item K) parallel to the
mounting angles. Attach the depth support rails using M6
pozi pan screws (Item F).
STEP 8. Install the gasket foam (Item L and Item M) to the
complete sides, front, and rear of cabinet.
STEP 10. Install the side panels (Item O) into the location pins
on the base. Fit the front and rear doors (Item R and Item S)
onto the hinges.
NOTE: Make sure that the gasket isn’t stretched. Using your
thumbs, install the gasket into place. Remember that
the 0.6” (15-mm) gasket is for the sides and the 0.4”
(10-mm) gasket is for the front and rear.
STEP 9. Install the anti-recirculation kit (Item N) into the side
and front fascias. Make sure there are no gaps.
724-746-5500
|
blackbox.com
Page 3
|