nstallation Instructions
I
The following instructions will help guide you through the initial steps of setting up your dryer for use.
Please note that every section of this manual provides important information regarding the preparation and use of
your dryer, and it is important that you review this entire manual before proceeding with any installation or use.
More detailed instructions concerning electrical connections, gas connections, and exhaust requirements are
provided in other parts of this manual.
F
Positioning the Dryer.
Choose a location with a solid floor for your dryer. Place the dryer at least eighteen inches above the floor for a
garage installation. After placing the dryer in the desired location, make sure that it has the required clearances
shown.
33.5"
(850 mm)
25.2"
(640 mm)
23.6"
(600 mm)
Note
Leveling legs should be secured.
All four legs should be on a solid, even floor and properly leveled as shown in this manual.
If dryer is not level, laundry may not be able to accurately detect the moisture level in the clothes.
When leveling, please be cautious to avoid injury.
6
nstallation Instructions
I
Stacking Kit
In order to stack this dryer an LG stacking kit is
required.
F
WARNING
• Incorrect installation can cause serious
accidents.
• The weight of the dryer and the height of
installation makes the stacking procedure too
risky for one person. This procedure should be
performed by 2 or more experienced service
personnel.
Dryer
• The dryer is not suitable for a built-in installation.
Please do not install as a built-in.
• Do not operate the dryer is disassembled.
Washer
Support Holder
3. Assemble the stacking kit as following.
This dryer may only be stacked on top of an LG
washer. DO NOT attempt to stack this dryer on any
other washer, as damage, injury or property damage
could result.
To stack this dryer, the support holder included with
the stacking kit must be used.
•
Peel the protective film from the double-sided tape on
the bracket for your size washer.
Attaching the support holder.
Align the stacking kit holes and the rear cover holes
and then firmly attach the bracket to the side of the
washer in that position.
•
•
23.6 inch(600 mm)
Washer Top plate size
Support
Holder
23.6 inch
(600mm)
Shape
4. Assemble a stacking kit as following.
Installation Procedure
• Screw 2 screws which were removed earlier to
assemble dryer and stacking kit.
1. Place the LG dryer on the LG Washing machine.
2. Remove two screws at the bottom of the rear cover
on each side as shown below.
• Use accessory screws [1.2inch (30mm)] to assemble
washer rear cover and stacking kit.
,
• The procedure for the opposite side will be the
same.
8
nstallation Instructions
I
Level the dryer
F
1. Level the dryer is to prevent undesirable noise
and vibration.
Locate your dryer on a solid, level floor. Make
sure it is not subjected to splashing water or
freezing temperatures. Do not store flammable
materials near the dryer.
2. If the dryer is not properly level, adjust the front
leveling legs up and down as necessary.
Turn the legs clockwise to raise the dryer and
counterclockwise to lower the dryer. Check the
dryer diagonally to make sure it does not rock
either way. Readjust the legs if necessary.
Adjustable feet
Raise
Lower
Adjustable feet
Adjustable feet
Diagonal Check
❊
When pushing down corners of the dryer,
the machine should not move at all.
(Check in either direction.)
If machine rocks when pushing the machine top plate
diagonally, adjust the feet again.
9
|