Ozone Generator
Air Purifier
HE-500/O3
1
Model:
HE-500/O3
Rated Voltage:
USA/Japan AC 100-120V/50-60Hz
Power Consumption:
Ceramic Plate Size(1plate):
Air Volume:
46W
Congratulations on the purchase of your New Comfort
HE-500/O3 Odor Destroying Ozone Air Purifier. The
HE-500/O3 is powerful, compact, energy efficient and
attractive. It is designed to quickly and effectively
remove even the worst of odors such as: smoke, smoke
Size: 90X50MM
Max 80 CFM(2.24 M3/min)
3500 mg/h
Active Oxygen(on) ：
Sound Level(DB):
Product size(mm):
Weight:
35
W175xH150xD205MM
4.2 lbs
damage, pet odors, dirty odors, mold and more.
used in homes, businesses, cars, RVs and more. Read
ALL instructions carefully before using this
product
It can be
If you suspect a problem with your unit check the following:
• Unit is plugged in properly. Make sure plug is firmly
pushed in all the way on the air purifier’s side, as well as
the wall.
• It’s important that the commercial air purifier be properly
grounded to avoid potential shock.
• Fuse is installed properly and in good condition. To replace
fuse, pull out the plastic fuse holder, remove old fuse and
insert new fuse. Replacement fuse must be 1 amp (0.79
inch). Refer to picture at follows:
2
7
Operating the Commercial Purifier
When the air purifier no longer produces enough ozone to be
effective, the ozone plate should be cleaned or replaced. (Usually
it should be replaced after working 5000 hours)
(Front View)
How to replace a plate:
1. Turn the unit off
and unplug from
outlet.
2. Use screw driver
to drive off screw
on the cover and
take away cover.
3. Pull ceramic plate
out
of
ozone
generator module.
Timer Control Knob
Turn clockwise to set the timer for
timed operation up to TWO hours.
4. Install ceramic plate as in figure. Be careful not to drop the
plate.
* To clean the ozone plate, follow the instructions above but
then rinse ceramic plate in warm water until clean, allow it
to dry completely, and reinstall.
Indicator Light
Illuminates when unit is in operation.
3
6
(Back View)
The commercial air purifier is designed to remove odors in
unoccupied spaces. The unit has a timer that will operate the unit
up to a maximum of 2 hours. The timer will run the unit for up to
two hours and then shut the commercial air purifier off. You
should allow 40 to 60 minutes before returning to the treated area.
To operate the Commercial Air Purifier:
•
•
•
•
Close off the desired area to be treated.
Remove all occupants and pets.
Position the unit as close as possible to the odor source.
In such environments as motels that have individual
heating and cooling systems, turn the fan on and set to
re-circulate.
Fuse Holder
Power Cord
Houses removable fuse.
(Spare fuse included, 1 amp, 0.79
inch in length)
•
•
•
Set timer to desired time and leave the room.
Allow 40 minutes before re-entering the treated space.
Return to space and ventilate area.
110 Volt grounded cord
4
5
|