Soleus Air Air Conditioner Hgw 308r W User Manual

HGW-308R-W Wall Mountable  
Micathermic Heater w/ Remote  
3092402  
Model No. HGW-308R-W  
© 2007 Soleus Air International  
12. A heater has hot and arcing or sparking parts inside. DO NOT use in areas where gasoline, paint,  
explosive and/or flammble liquids are used or stored. Keep unit away from heated surfaces and open  
flames.  
13. Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire.  
However, if you have to use an extension cord, the cord shall be No16.AWG minimum size and rated  
not less than 1500W.  
14. To avoid fire or shock hazard, plug the unit directly into a 120 V AC electrical outlet.  
15. To disconnect heater, turn controls to OFF, then remove plug from outlet. Pull firmly on the plug, DO  
NOT unplug by pulling on the cord.  
16. Always unplug the unit before moving or cleaning, or whenever the heater is not in use.  
17. Use only for intended household use as described in this manual. Any other use not recommended by  
the manufacturer may cause fire, electric shock, or injury to persons. The use of attachments not rec-  
ommended or sold by unauthorized dealers may cause hazards.  
18. Always use on a dry, level surface.  
19. DO NOT use outdoors.  
20. WARNING: To reduce the risk of fire or electric shock, DO NOT use this unit with any solid-state  
speed control device.  
21. DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so will  
void your warranty. The inside of the unit contains no user serviceable parts. Qualified personnel  
should perform all servicing only.  
22. Connect to properly grounded outlets only.  
23. SAVE THESE INSTRUCTIONS.  
PRODUCT INFORMATION & SPECIFICATIONS  
Micathermic heating technology combines two popular heating technologies to create the ideal room heater.  
Using radiant and convection heat, Micathermic heaters are able to achieve full power within minutes and  
provide a consistent and comfortable silent heat without causing dry spots.  
Voltage Rating  
Power Consumption  
Unit Size  
120 V (60Hz)  
1000 (ECO) /1000 (LOW) /1500W (HIGH)  
24.6 in. (W) x 8.5 in. (D) x 22.5 in. (H)  
11 lbs  
Unit Weight  
DISCLAIMER  
ALL INFORMATION AND THE TECHNICAL SPECIFICATIONS PRESENTED IN THIS USER’S MANUAL ARE THE  
PRESENTATION OF THE MANUFACTURER. SOLEUS INTERNATIONAL HAS NOT CONDUCTED INDEPENDENT  
TEST TO THE INFORMATION AND THE SPECIFICATIONS PRESENTED HEREWITHIN.  
3
SAFETY FEATURES  
Tip-Over Safety Feature  
This heater is equipped with a tip-over safety feature. Once the heater is tipped over, an internal switch will  
automatically shut the heater off. Once the heater is restored to an upright position, the heater will reset. To  
continue operation, turn on the heater using the supplied remote control or the control panel on the heater.  
Overheat Safety Feature  
This heater is equipped with a overheat safety feature. When the heaters internal components reach a certain  
temperature that could cause overheat and possible fire, the heater will automatically shut off. To reset the  
heater, unplug the heater power cord from the electrical outlet for 10 minutes. After 10 minutes, plug the  
heater into the electrical outlet and turn on using the supplied remote control or the control panel on the heater.  
WARNING: This heater is for use on 120 volts. The  
cord has a plug as shown in A. An adapter as shown in  
C is available for connecting three-blade grounding-  
type plugs to two-slot receptacles. The grounding lug  
extending from the adapter must be connected to a  
permanent ground such as a properly grounded outlet  
box. The adapter should not be used if a three-slot  
grounded receptacle is available.  
DO NOT DEFEAT THE SAFETY PURPOSE OF  
THE GROUNDED PLUG.  
WARNING: It is normal for the power cord to feel warm to the touch; however, a loose fit between the outlet  
and the plug may cause overheating of the plug. If this occurs, try inserting the plug into a different outlet.  
Contact a qualified electrician to inspect the original outlet for damage.  
IN THE BOX  
MICATHERMIC HEATER  
REMOTE CONTROL  
2 - LEG SCREWS  
2 - MEDIUM BLACK SPRING WASHERS  
2 - MEDIUM GREY WASHERS  
4 - WHEELS  
REMOTE CONTROL BATTERY  
INSTRUCTION BOOKLET  
WALL MOUNTING BRACKET  
4 - DRY WALL ANCHORS  
4 - MOUNTING SCREWS  
2 - LEGS  
4 - WHEEL SCREWS  
4 - SMALL BLACK SPRING WASHERS  
4 - SMALL GREY WASHERS  
4
PRODUCT DIAGRAM  
CARRY HANDLE &  
WALL MOUNT  
(on back)  
DIGITAL  
DISPLAY  
CONTROL  
PANEL  
LEGS  
WHEELS  
5
ASSEMBLY - REMOVING THE HEATER FROM THE PACKAGING  
Remove the heater from the box.  
NOTE: Product drawings may slightly differ from  
actual product. Assembly and packaging are the  
same as depicted in the drawings  
Remove the Styrofoam from both ends of  
the heater, and remove the plastic bag.  
Remove the 2 remaining bags from the box..  
One bag contains: feet with casters. [Fig 1]  
The other bag contains:  
1 mounting support, 4 screws and 4 drywall  
anchors for wall mounting. [Fig 2]  
Save the packaging for storing the heater  
while it is not in use or during summer  
months.  
Note: If any part is damaged or missing, do  
not use or attempt installation. Contact cus-  
tomer service for a replacement.  
6
ASSEMBLY - INSTALLATION  
Required Tools for Floor Use:  
Phillips screwdriver (not supplied)  
Estimated Assembly Time for Floor Use:  
1 minute  
Assembly Instructions for Floor Use:  
Insert the feet and bolts onto the unit as shown in the  
diagram.  
Required Tools for Wall Mounting:  
Phillips screwdriver (not supplied)  
Drill (not supplied)  
Hammer (not supplied)  
Estimated Mounting Time: 5 minutes  
Mounting Instructions:  
STEP 1  
Using the mounting support as a guide, mark the first screw  
hole on the wall.  
STEP 2  
Move the mounting support, and drill the first screw hole.  
STEP 3  
Insert the first mounting anchor into the drilled hole.  
STEP 4  
Place the mounting support on the wall. Insert a screw through  
the mounting support and anchor. Tighten the screw lightly.  
STEP 5  
Use the other side of the mounting support to mark the second  
screw hole on the wall [approximately 5 7/16 in.].  
STEP 6  
Move the mounting support, and drill the second hole.  
STEP 7  
Insert the second mounting anchor into the drilled hole.  
STEP 8  
Place the mounting support on the wall. Insert the second screw  
through the mounting support and anchor. Firmly tighten both  
screws.  
STEP 9  
After mounting the heater, insert two screws into the bottom  
holes and secure the heater to the wall for safety purposes.  
7
OPERATING INSTRUCTIONS  
CONTROL PANEL & REMOTE OPERATION  
1. Place the heater on a firm, level surface and plug into a grounded 120V 60Hz power outlet. Only operate  
heater in upright position with caster wheels attached.  
2. Turn the heater on by pressing the On/Off button on the control panel or the supplied remote control.  
3. Select a heat setting:  
On the control panel, press the MODE button to toggle between the two heat settings; LOW (1000W) or  
HIGH (1500W) . When using the remote control press the HIGH or LOW buttons to select the preferred  
power setting.  
4. Adjust the thermostat by pressing the TEMPERATURE SELECT buttons (▲ or ▼) on the control panel  
or remote control. The digital readout will display the selected temperature.  
5. Once you have chosen the desired temperature, the heater will remain on until the room temperature  
increases to the temperature on the digital display. The heater will cycle on and off to maintain the desired  
room temperature.  
6. This heater is equipped with a 12-hour automatic shut-off timer. To activate the timer, press the TIMER  
button on the control panel or remote control. Each press of the timer button will increase the heater  
operating time by one hour. The digital readout will display the number of hours you have selected. To  
turn off the timer, simply press the TIMER button until the digital readout displays your current selected  
temperature. Once you have selected a shut off time, the heater will operate for the selected time, then  
automatically shut off.  
7. The indication lights on the control panel communicate how the heater is operating. The TIMER light will  
turn-on when the timer is selected. When HIGH, LOW modes are selected, the corresponding lights will  
turn on accordingly.  
8. Unplug the heater when not in use.  
Temperature & Timer  
Display  
Receiver for Remote Control  
Timer Select Button  
Temperature Select Buttons  
Indication Lights  
Mode Select Button  
On/Off Button (Power)  
8
OPERATING INSTRUCTIONS (CONTINUED)  
OPTIMAL OPERATING CONDITIONS  
To get the most out of your Soleus Air Micathermic heater, follow these helpful hints:  
1. All electric heaters are limited to maximum of 1500 watts (per UL and ETL requirements). Due to this  
limitation all electric heaters can heat approximately 150 square feet. Micathermic heaters fit in this  
category, but they are able to provide a more comfortable and consistent heat than other heating  
technologies.  
2. For optimal performance, place the heater in a room and close all windows and doors. This will confine the  
heat to the area that needs it most.  
3. To save energy and in turn save money in the winter, place the heater in a room or area that needs extra  
heat instead of raising the thermostat on your central heating system. This heater will function very well as  
an additional heating source and can easily maintain the temperature in most rooms and attached  
bathrooms. There is no need to increase the heat in the entire house when you only need comfort in the  
room in which you are currently located.  
ABOUT ECO MODE  
ECO mode is an energy saving function that limits the amount of electricity consumed by the heater. Once the  
heater reaches a preset temperature, ECO mode will automatically turn on. Once ECO mode is on, the heater  
will decrease energy consumption to 1000 watts while still maintaining the set temperature on the digital  
thermostat.  
9
MAINTENANCE  
1. Unplug the unit and let it cool completely.  
2. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mild  
detergent if necessary. After cleaning, dry the unit with a soft cloth. CAUTION: DO NOT let liquid  
enter the heater.  
3. DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the  
heater. This may cause damage or deterioration to the surface of the heater.  
4. DO NOT immerse the heater in water.  
5. Wait until the unit is completely dry before use.  
STORAGE  
Store the heater in a cool, dry location when not in use. If available, use the retail packaging and pack up the  
heater to prevent dust from collecting on and inside the heater.  
TROUBLESHOOTING  
If the heater will not operate, please check the following before seeking repair of service:  
1. Check if the power cord is plugged into an electrical outlet, if not, plug in.  
2. Check if electricity to the main fuse is working.  
3. Check if the heater is set to ON by confirming the light on the control panel is lit. If not, press the  
POWER button to turn on the unit.  
4. Check if the heater is on a level surface. If the tip-over safety mechanism inside the heater is engaged  
the heater will not run.  
5. The room temperature has reached the temperature on the digital display of the heater. Increase the  
temperature on the display so the heater will continue operation or wait for the room temperature to  
drop below the set temperature on the heater.  
10  
WARRANTY  
One Year Limited Warranty  
Soleus International Inc. warrants the accompanying Soleus Air heater to be free of defects in material and workman-  
ship for the applications specified in its operation instruction for a period of ONE (1) year from the date of original re-  
tail purchase in the United States.  
If the unit exhibits a defect in normal use, Soleus International Inc. will, at its option, either repair or replace it, free of  
charge within a reasonable time after the unit is returned during the warranty period.  
As a condition to any warranty service obligation, the consumer must present this Warranty Certificate along with a  
copy of the original purchase invoice.  
THIS WARRANTY DOES NOT COVER:  
Damage, accidental or otherwise, to the unit while in the possession of a consumer not caused by a defect in  
material or workmanship.  
Damage caused by consumer misuse, tampering, or failure to follow the care and special handling provisions  
in the instructions.  
Damage to the finish of the case, or other appearance parts caused by wear.  
Damage caused by repairs or alterations of the unit by anyone other than those authorized by Soleus Interna-  
tional Inc.  
Freight and Insurance cost for the warranty service.  
ALL WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANT ABILITY ARE LIMITED TO  
ONE-YEAR DURATION OF THIS EXPRESS LIMITED WARRANTY. SOLEUS INTERNATIONAL INC.  
DISCLAIMS ANY LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES AND IN NO EVENT  
SHALL SOLEUS INTERNATIONAL INC’S LIABILITY EXCEED THE RETAIL VALUE OF THE UNIT FOR  
BREACH OF ANY WRITTEN OR IMPLIED WARRANTY WITH RESPECT TO THIS UNIT.  
This warranty covers only new products purchased from our authorized dealers or retailers. It does not cover used, sal-  
vaged, or refurbished products.  
As some states do not allow the limitation or exclusion of incidental or consequential damages, or do not allow  
limitation on implied warranties, the above limitations and exclusions may not apply to you. This warranty gives you  
specific legal rights, and you may also have other rights that vary from state to state.  
For Technical Support and Warranty Service  
Please Call (888) 876-5387  
Or Write To:  
Soleus International Inc.  
9451 Telstar Ave.  
El Monte, CA 91731 USA  
11  

Mitsubishi Motors Automobile Parts V4a2 User Manual
Panasonic Cs E24ekrs User Manual
Philips Lr6ps16c User Manual
Philips Scb2025nb User Manual
Precisionaire Rigid Air Merv 10 14 User Manual
Samsung As12j User Manual
Samsung Avmwc052ca0 User Manual
Sharp Mx 312nv User Manual
Toshiba Answering Machine Es96r User Manual
Toshiba Multifunctional Digital Color Systems 6520c User Manual