Sanyo Eneloop Nc Mqn06 User Manual

For customer service issues, please call 1-866-848-9912  
Parts and usage  
How to charge  
With this charger, you can  
Call GE SANYO at (866) 848-9912 • SANYO Energy (U.S.A.) Corp.,  
c/o XWG, 1840 County Line Road Huntingdon Valley, PA 19006  
charge up to 4 AA or 4AAA  
eneloop Ni-MH batteries.  
1) This charger is designed to charge 2 or 4 pcs of AA or AAA  
Ni-MH rechargeable batteries. AA and AAA batteries can be  
charged at the same time.  
Charger Model #NC-MQN06  
2) If you want to charge 4 pcs of AA or AAA, put batteries into the  
charger compartments, taking care to observe polarity (+/-) as  
indicated inside the charger.  
Notes on Safety (Please read for proper use.)  
Severity of symbol  
Regarding eneloop Ni-MH batteries  
AAA (-) contact surface  
AA (-) contact surface  
Danger - Very close to causing death or heavy damage  
to human body.  
3) If only charging 2 batteries at a time, place the batteries in the  
left or right side compartments of the charger.  
Please follow the instructions below to avoid damage or injury.  
Warning - May cause death or heavy damage to  
human body.  
Charge indicator light  
• Flashes when charging.  
• Turns on when charging is  
complete.  
Danger  
Caution - May cause heavy damage to human body  
or property damage.  
• Do not dispose of in fire. Do not heat, deform, solder, dissamble or  
modify.  
• Do not insert batteries with the (+) and (-) ends reversed.  
Example of the symbols  
How to insert and remove battery  
• If leaked liquid gets in the eyes, wash them with clean water and  
consult a doctor immediately.  
This symbol is to inform that the action written inside of the  
symbol is prohibited. (Left is to prohibit you from taking apart)  
How to insert  
Batteries should not be used in underwater lighting or in sealed  
• Match the + and – terminal of the  
battery with the charger’s + and  
– contact surface.  
electronic devices.  
Safety issues of charger  
Warning  
Danger  
• For AA battery, insert from the  
+ terminal and push on the  
– terminal.  
• For AAA battery, insert from  
– terminal as in the picture, then  
Do not connect the (+) and (-) ends with metal objects. When  
carrying or storing batteries, avoid direct contact with metal objects.  
• Children should be supervised while handling the batteries.  
• Do not peel off or damage the outer tube.  
Use under the specified voltage  
Please use under AC100V to 240V. Otherwise, may  
cause high heat, fire breakout, electric shock, or harm to  
human body.  
How to insert a AA battery  
4) Swing plug out and plug into AC100-240V outlet.  
place + terminal into + contact surface.  
• If leaked liquid gets on the skin or clothing, wash off with clean water  
immediately.  
5) Confirm that the indication lights begin to flash. Do not plug in  
upside down. If plugged in upside down, it will finish charging  
before it is fully charged.  
Warning  
How to remove  
• For AA battery, take out from  
– terminal.  
• For AAA battery, if pushed on  
the + side, - side will pop out  
for easy removal.  
• Do not connect 10 batteries or more in series.  
Do not allow metal objects come into contact with charger.  
May cause electric shock, excessive heat, or fire.  
Caution  
6) When charging is complete, the indicator lights will turn on  
constantly. Refer to charging chart for typical charge time.  
This appliance is not intended for use by persons  
(including children) with reduced physical, sensory or  
mental capabilities, or lack of experience and knowledge,  
unless they have been given supervision or instruction  
concerning use of the appliance by a person responsible  
for their safety. Children should be supervised to ensure  
that they do not play with the appliance. Do not charge  
non-rechargeable batteries.  
Operating temperature range for Ni-MH battery eneloop  
How to insert a AAA battery  
• Discharge  
• Recharge  
• Store  
23°F to 122°F  
41°F to 95°F  
- 4°F to 86°F  
7) After charging is done, unplug the charger from the outlet and  
swing plug back into place.  
Spec  
• Outside of the indicated range, battery’s performance and  
life-cycle may decrease.  
Input  
Size  
AC100-240V ~ 50/60Hz 8W  
118 x 72 x 32.5 mm  
~ 98g  
Weight  
Do not use these batteries together with dry cells, other types of  
batteries, new or old batteries together, or batteries with different  
charge levels.  
AA - 2/4 x 1.2V — 300mA  
AAA - 2/4 x 1.2V — 150mA  
Output  
Temp. range  
41°F – 95°F  
Caution  
Charge time  
1 – 4 battery  
Suitable Battery  
May deform charger causing high heat, leakage,  
or explosion.  
Correctly use “eneloop”  
Ni-MH battery  
Ni-MH  
battery  
eneloop  
AA HR-3UTG ( Max 3000mAh.  
Approx. 10 hours  
Min. 1900mAh*)  
Do not place heavy objects on top of the charger. Avoid  
unstable locations like areas with strong magnetic fields or  
dust. May cause excessive heat or fire.  
AAA HR-4UTG (Max 1000mAh.  
Min. 750mAh*)  
Approx. 7 hours  
About Charging  
Depending upon storage condition, typically eneloop does not need to  
Charge time is the time it takes to charge a fully discharged battery.  
The charge time will depend on the remaining charge in the battery  
and the ambient temperature.  
Charger should be used between 41°F to 95°F. If ambient  
temperature is higher, charger may cause the battery to leak  
or rupture.  
be recharged for the first time if used within  
2
years from the  
manufactured date. However, there may be a time when some digital  
cameras may display the low battery indicator. In these cases, please  
recharge.  
How to assemble C or D battery  
• Match the + and – terminal of a AA eneloop battery with the  
spacer’s + and – terminals.  
• Insert the + terminal of the AA eneloop battery into the – end of  
the spacer.  
• Push the AA battery until it “snaps” into place.  
To remove, push on the + terminal of the AA eneloop battery  
until it releases.  
Indication light  
Charging Safety  
Appearance  
Status  
Handling  
Please recycle used rechargeable batteries.  
Do not charge near hot temperatures like an electric blanket,  
stove, near direct sunlight, inside of a car, or under hot sun, etc. In  
addition, please do not cover the charger with a blanket. In such  
cases, battery would not be fully charged because the temperature  
inside of the charger will become hot, and the safety protective  
function will be activated and stop charging.  
Charging  
Indicator lights flashing  
Normal  
properly  
All rechargeable batteries contain precious  
resources that can be reused. To learn more  
Finish  
Batteries are ready for use  
Indicator lights are on  
Indicator lights are off  
about recycling or to find  
a
drop-off location,  
charging  
a) No battery put inside charger  
b) Battery connected incorrectly  
c) The charger has internal failure  
d) Power off  
Default  
mode  
* All statements concerning capacity (mAh) or the life of the battery (cycle  
life) are based on IEC61951-2.  
* Statements concerning long term storage is based on simulations at room  
temperature.  
Please charge at temperature between 41°F to 95°F.  
AA battery  
C or D spacer  

Murphy Modex Bc700 Series User Manual
Panasonic Cu W7dkr User Manual
Panasonic Rod End Bearing Hrt User Manual
Savin Dsc332 User Manual
Sharp Ar M620n User Manual
Smc Networks Robo Cylinder Ra4c User Manual
Soleus Air Air Conditioner Ph5 13r 35d User Manual
Stiga Parkpro 16 User Manual
Streamlight Battery Charger 48 59 0192 User Manual
Xerox 460 Dc User Manual