Nokia Extra Power Dc 11k User Manual

Nokia Extra Power DC-11/DC-11K  
5
2
3
4
Issue 2  
ENGLISH  
Before you can use the DC-11 device  
to charge the battery in a compatible  
device, you must charge the DC-11  
device.  
The indicator light flashes during  
charging. If the light is not  
displayed, check that the charger is  
properly connected to the DC-11  
device.  
Charge the DC-11 device  
Before charging the DC-11 device,  
carefully read "Battery and charger  
information".  
3. When the DC-11 device is fully  
charged, the indicator light stops  
flashing. Disconnect the charger  
from the DC-11 device, then from  
the power source.  
Warning: Use only chargers  
approved by Nokia for use  
with this particular model.  
The DC-11 device can also be charged  
through a USB port of a compatible PC  
using the Nokia connectivity cable  
CA-100 or CA-126 (sold separately).  
Connect one end of the cable to the  
charger connector on the DC-11  
device and the other end to a USB port  
on the PC.  
The use of any other types may invalidate  
any approval or warranty, and may be  
dangerous.  
When you disconnect the power cord of  
any accessory, grasp and pull the plug,  
not the cord.  
1. Connect a compatible charger to a  
power source.  
While charging the DC-11 device, you  
can use it to charge the battery in one  
or two devices. Connect the device or  
devices to the DC-11 device.  
2. Connect the charger cable to the  
charger connector on the DC-11  
device. The device switches on.  
ENGLISH  
Charge the battery of the other device  
You can use the DC-11 device to  
charge the battery in two devices  
at the same time.  
charge the DC-11 device, and press  
the power key to switch it on.  
If the DC-11 device cannot start  
charging the other device within  
about 30 seconds, the DC-11  
device switches off.  
The fully charged DC-11 device has  
enough power to fully charge a  
950 mAh battery once.  
1. If the charger plug you want to  
use is inserted into the end of the  
DC-11 device, pull the plug out  
from the recess, and uncoil the  
charging cable from the side of  
the device.  
4. Check the charge level from the  
connected device.  
5. When the battery in the other  
device becomes fully charged, the  
indicator light stops flashing and is  
continuously shown for about  
30 seconds, and the DC-11 device  
switches off. You can also stop  
charging and switch off the DC-11  
device by pressing and holding the  
power key for about 5 seconds. The  
DC-11 device automatically  
switches off if it becomes  
2. Connect the charger plug to the  
other device.  
3. Press the power key of the DC-11  
device.  
The indicator light flashes during  
charging. If the light does not  
flash, check that the other device is  
properly connected to the DC-11  
device. If the light is not displayed,  
discharged.  
ENGLISH  
When you charge the battery of a  
low-power device such as a  
Bluetooth headset, the indicator  
light may continue flashing even  
after the battery has been fully  
charged.  
6. Disconnect the DC-11 device from  
the other device.  
7. To carry the DC-11 device with you,  
insert the charging cable into the  
side slot, and push the charger plug  
into the recess.  
Battery and charger information  
This device has an internal,  
device. Use of an unapproved charger  
may present a risk of fire, explosion,  
leakage, or other hazard.  
nonremovable, rechargeable battery.  
Do not attempt to remove the battery  
from the device as you may damage the  
device. This device is intended for use  
when supplied with power from the  
following chargers: AC-3, AC-4, AC-5,  
AC-8, DC-4, and DC-9. The exact charger  
model number may vary depending on  
the type of plug. The plug variant is  
identified by one of the following: E, EB,  
X, AR, U, A, C, or UB. The battery can be  
charged and discharged hundreds of  
times, but it will eventually wear out.  
Recharge your battery only with Nokia  
approved chargers designated for this  
If a battery is being used for the first time  
or if the battery has not been used for a  
prolonged period, it may be necessary to  
connect the charger, then disconnect and  
reconnect it to begin charging the  
battery. If the battery is completely  
discharged, it may take several minutes  
before the charging indicator light is  
displayed.  
Unplug the charger from the electrical  
plug and the device when not in use.  
Do not leave a fully charged battery  
 
ENGLISH  
connected to a charger, since  
Do not dispose of batteries in a fire as  
they may explode. Batteries may also  
explode if damaged.  
overcharging may shorten its lifetime.  
If left unused, a fully charged battery  
will lose its charge over time.  
Never use any charger that is damaged.  
Always try to keep the battery between  
15°C and 25°C (59°F and 77°F). Extreme  
temperatures reduce the capacity and  
lifetime of the battery. A device with a hot  
or cold battery may not work temporarily.  
Battery performance is particularly limited  
in temperatures well below freezing.  
Important: Charging  
capacity is an estimate only  
and depends on battery age  
and condition and on temperatures to  
which battery is exposed.  
Care and maintenance  
Your device is a product of superior  
design and craftsmanship and should be  
treated with care. The following  
suggestions will help you protect your  
warranty coverage.  
Do not use or store the device in  
dusty, dirty areas. Its moving parts  
and electronic components can be  
damaged.  
Do not store the device in hot areas.  
High temperatures can shorten the  
life of electronic devices, damage  
batteries, and warp or melt certain  
plastics.  
Keep the device dry. Precipitation,  
humidity, and all types of liquids or  
moisture can contain minerals that  
will corrode electronic circuits. If your  
device does get wet, allow it to dry  
completely.  
Do not store the device in cold areas.  
When the device returns to its normal  
ENGLISH  
temperature, moisture can form  
inside the device and damage  
electronic circuit boards.  
This requirement applies in the European  
Union. Do not dispose of these products  
as unsorted municipal waste. For more  
environmental information, see the  
product Eco-Declarations at  
Do not attempt to open the device.  
Do not drop, knock, or shake the  
device. Rough handling can break fine  
mechanics.  
Always return your used electronic  
products, batteries, and packaging  
materials to a dedicated collection point.  
This way you help prevent uncontrolled  
waste disposal and promote the recycling  
of materials. More detailed information  
is available from the product retailer,  
local waste authorities, national  
Do not use harsh chemicals, cleaning  
solvents, or strong detergents to  
clean the device.  
Do not paint the device. Paint can  
clog the moving parts and prevent  
proper operation.  
producer responsibility organisations, or  
your local Nokia representative. Check  
how to recycle your Nokia products at  
browsing on a mobile device,  
If the product is not working properly,  
take it to the nearest authorised service  
facility for service.  
Recycle  
The crossed-out wheeled-bin  
symbol on your product, battery,  
literature, or packaging reminds  
you that all electrical and  
electronic products, batteries, and  
accumulators must be taken to separate  
collection at the end of their working life.  

Mitsubishi Electronics Msz Ga22va User Manual
Panasonic Uc200 User Manual
Samsung Aw 050dm User Manual
Sanyo Cr14250se User Manual
Sanyo Kms0972 User Manual
Sennheiser 300 Iem G2 User Manual
Shinco Air Conditioner Kfr 25gwz Bm User Manual
Trane Air Conditioner 4ttx5060a1 User Manual
White Rodgers Ssc1000 User Manual
York Roomtop R407c User Manual