X10 Wireless Technology Home Security System VK48A User Manual

In d o o r / O u t d o o r Co lo r Ca m e r a  
w it h Bu ilt - in 2 . 4 G Hz W ir e le ss  
Vid e o Se n d e r, a n d se p a r a t e  
Vid e o Re ce iv e r  
O W N ER'S MAN UAL  
MO DEL VK4 8 A  
(IN CLUDES XC1 0 A CAMERA, VR3 1 A VIDEO RECEIVER  
AN D PLUG-IN PO W ER SUPPLIES)  
Download from Www.Somanuals.com. All Manuals Search And Download.  
11. Power Sources - This product should be operated only from the type of power  
source indicated on the marking label. If you are not sure of the type or power  
supply to your home, consult your product dealer or local power company. For  
products intended to operate from battery power, or other sources, refer to the  
operating instructions.  
c)  
d)  
If the product has been exposed to rain or water,  
If the product does not operate normally by following the operating instructions.  
Adjust only those controls that are covered by the operating instructions as an  
improper adjustment of other controls may result in damage and will often  
require extensive work by a qualified technician to restore the product to its  
normal operation,  
12. Grounding or Polarization - This product is equipped with a polarized  
alternating current line plug (a plug having one blade wider than the other).  
This plug will fit into the power outlet only one way. This is a safety feature. If  
you are unable to insert the plug fully into the cutlet, try reversing the plug. If the  
plug should still fail to fit, contact your electrician to replace your obsolete  
outlet. Do not defeat the safety purpose of the polarized plug.  
e)  
f)  
If the product has been dropped or damaged in any way, and  
When the product exhibits a distinct change in performance - this indicates a  
need for service.  
19. Heat - The product should be situated away from heat sources such as  
radiators, heat registers, stoves, or other products including amplifiers) that  
produce heat.  
13. Power-Cord Protection - Power supply cords should be routed so that they are  
not likely to be walked on or pinched by items placed upon or against them,  
paying particular attention to cords at plugs, convenience receptacles, and the  
point where they exit from the product.  
FCC CAUTIO N  
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.  
OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:  
(1)THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND  
14. Lightning - For added protection for this product during a lightning storm, or  
when it is left unattended and unused for long periods of time, unplug it from  
the wall outlet and disconnect the antenna or cable system. This will prevent  
damage to the product due to lightning and power-line surges.  
(2)THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING  
INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.  
This equipment generates and uses radio frequency energy, and if not installed and  
used properly, that is, in strict accordance with the manufacturers instructions, it may  
cause interference to radio and television reception. It has been type tested and  
found to comply with the limits for remote control devices in accordance with the  
specifications in Sub-Parts B and C of Part 15 of FCC Rules, which are designed to  
provide reasonable protection against such interference in a residential installation.  
However, there is no guarantee that interference will not occur in a particular  
installation. If this equipment does cause interference to radio or television reception,  
which can be determined by unplugging the equipment, try to correct the interference  
by one or more of the following measures.  
15. Overloading - Do not overload wall outlets, extension cords, or integral  
convenience receptacles as this can result in a risk of fire or electric shock.  
16. Object and Liquid Entry - Never push objects of any kind into this product  
through openings as they may touch dangerous voltage points or short-out parts  
that could result in a fire or electric shock. Never spill liquid of any kind on the  
product.  
17. Servicing - Do not attempt to service this product yourself as opening or  
removing covers may expose you to dangerous voltage or other hazards. Refer  
all servicing to qualified service personnel.  
Reorient the antenna of the radio/ TV experiencing the interference.  
Relocate the equipment with respect to the radio/ TV.  
• Move the equipment away from the radio/ TV.  
18. Damage Requiring Service - Unplug this product from the wall outlet and refer  
servicing to qualified service personnel under the following conditions:  
• Plug the equipment into an outlet on a different electrical circuit from the radio/ TV  
experiencing the interference.  
a)  
b)  
When the power-supply cord or plug is damaged,  
If necessary, consult your local Dealer for additional suggestions.  
N O TE: Modifications to this product will void the user's authority to operate this  
equipment.  
If liquid has been spilled, or objects have fallen into the product,  
4
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
CO N TEN TS  
CO N TRO LS AN D CO N N ECTIO N S  
CO N TRO LS AN D CO N N ECTIO N S ........................................ 7  
CAMERA/ VIDEO SEN DER, AN D VIDEO RECEIVER .................... 7  
CAMERA/ VIDEO SEN DER .................................................. 8  
VIDEO RECEIVER ............................................................. 9  
CO N N ECTIN G UP ........................................................... 1 0  
SETTIN G UP THE CAMERA/ VIDEO SEN DER ........................... 1 0  
CAMERA/ VIDEO  
SEN DER  
VIDEO RECEIVER  
(BO TTO M VIEW )  
TV  
Channel  
Switch  
2.4 GHz  
Video  
Antenna  
SETTIN G UP THE VIDEO RECEIVER ...................................... 1 2  
FIN E TUN IN G YO UR SYSTEM ........................................... 1 4  
W ARRAN TY................................................................... 1 5  
TV  
CHAN NEL  
3
4
2.4 GHz  
Channel  
Switch  
CH AN NEL  
BC D  
A
2.4 GHz  
Channel  
Switch  
Power Supply  
Socket  
6
7
Download from Www.Somanuals.com. All Manuals Search And Download.  
CO N TRO LS AN D CO N N ECTIO N S  
CAMERA/ VIDEO SEN DER  
VIDEO RECEIVER  
2.4 GHz  
Video  
Antenna  
2.4 GHz Video  
Antenna  
Set channel switch to  
match setting on  
Video Receiver.  
TV Output  
Connector  
Mounting  
plate  
ON-OFF  
Switch  
TO TV  
(on side)  
DC 12 V  
VIDEO OUT AUDIO OUT  
Power Supply  
Jack  
TV Channel  
Switch  
2.4 GHz Channel  
Switch  
A/ V Jacks  
Cable adapter.  
(on bottom)  
(on bottom)  
8
9
Download from Www.Somanuals.com. All Manuals Search And Download.  
CO N N ECTIN G UP  
SETTIN G UP THE CAMERA/ VIDEO SEN DER  
Referring to the diagram on the next page:  
2.4 GHz Video  
Antenna  
Set channel switch to  
match setting on  
Video Receiver.  
1. Attach the camera to a wall using the screws provided.  
2. If you install the camera outdoors, make a small hole in your  
exterior wall and pass the low voltage power jack through it.  
3. Plug the power supply jack into the socket on the adapter cable  
from the camera. Use the smaller of the two power supplies.  
Attach camera to a  
wall, indoors or  
outdoors.  
4. Plug the power supply into any 120V AC outlet.  
5. Set the channel switch to any letter A, B, C, or D  
6. Adjust the antenna if necessary to aim it in the direction of the TV  
or monitor that you will view the camera on.  
Outdoors  
Indoors  
Plug power  
supply in here.  
Plug into  
any AC  
outlet  
Im p o rta n t: Unplug  
power supply before  
unplugging power jack.  
1 0  
1 1  
Download from Www.Somanuals.com. All Manuals Search And Download.  
HO O KIN G UP THE VIDEO RECEIVER  
IF YO UR TV IS ALREADY HO O KED UP TO A DSS RECEIVER O R O THER  
A/ V DEVICE  
If a DSS Receiver or other A/ V  
component is connected to the TV using  
A/ V cables, you can connect the Video  
Receiver to the free LINE IN jacks on  
the component. If there are no LINE IN  
jacks, you will need to use a TV  
VIDEO  
A
UDIO  
1. Connect a set of Audio/ Video  
cables to the A/ V OUT jacks on the  
Video Receiver. Connect the other  
end to your TV (use either L or R  
channel for audio).  
TO TV  
TV  
VIDEO  
A
UDIO  
TO TV  
TV  
antenna splitter as described earlier.  
2. Plug the Video Receiver's Power  
Supply (the larger of the two power  
supplies) into a 120 volt wall outlet  
and plug its jack into the Video  
AUDIO  
VIDEO  
VIDEO  
AUDIO  
AUDIO  
Receiver.  
3. Turn the Video Receiver's power switch (on side of unit) on.  
DS S  
OUT  
IN  
VIDEO  
4. Set the channel switch to the same letter as you set on the  
camera, A, B, C, or D.  
5. Position the Video Receiver in a convenient location such as on  
top of the TV and orient the antenna so that the flat side points in  
the direction of the room where you set up the Video Sender.  
IF YO UR TV DO ES N O T HAVE A/ V CO N N ECTO RS  
You can use the supplied coaxial cable to connect the TV OUT socket  
on the Video Receiver to the Antenna input on your TV. If you already  
have an antenna  
connected to your TV,  
you will need to use a  
TV antenna splitter.  
TO TV VIDEO  
A
UDIO  
Set your TV and the  
TV Channel switch on  
the Video Receiver  
(on bottom) to the  
same channel (3 or  
4).  
TO TV  
ANTENNA  
TV  
1
2
UHF/VHF  
ANT ENNA  
1 2  
1 3  
Download from Www.Somanuals.com. All Manuals Search And Download.  
FIN E TUN IN G YO UR SYSTEM  
WARRAN TY  
1 2 MO N TH LIMITED WARRAN TY  
The Wireless Video Sender usually works best with the flat faces of  
the antennas on the Sender and Receiver unit facing each other (i.e.  
in Line of sight- see diagram below). Sometimes, however,  
reflections and other effects in the home may affect the signal so that  
some adjustment of either the Sender or Receiver antenna may be  
necessary to get the best the signal.  
X10 (USA) INC. (X10) WARRANTS ITS PRODUCTS TO BE FREE FROM  
DEFECTIVE MATERIAL AND W ORKMANSHIP FOR A PERIOD OF ONE (1)  
YEAR FROM THE ORIGINAL DATE OF PURCHASE AT RETAIL. X10 AGREES  
TO REPAIR OR REPLACE, AT ITS SOLE DISCRETION, A DEFECTIVE X10  
PRODUCT IF RETURNED TO X10 W ITHIN THE WARRANTY PERIOD AND  
W ITH PROOF OF PURCHASE.  
IF SERVICE IS REQUIRED UNDER THIS WARRANTY:  
1. RETURN THE DEFECTIVE UNIT POSTAGE PREPAID TO THE ADDRESS  
ON BACK COVER.  
2. ENCLOSE A CHECK FOR $4.00 TO COVER HANDLING AND RETURN  
POSTAGE.  
3. ENCLOSE A DATED PROOF OF PURCHASE.  
4. X10 IS NOT RESPONSIBLE FOR SHIPPING DAMAGE. UNITS TO BE  
RETURNED SHOULD BE PACKED CAREFULLY.  
THIS WARRANTY DOES NOT EXTEND TO ANY X10 PRODUCTS W HICH  
HAVE BEEN SUBJECT TO MISUSE, NEGLECT, ACCIDENT, INCORRECT  
W IRING OR TO USE IN VIOLATION OF OPERATING INSTRUCTIONS  
FURNISHED BY US, NOR EXTEND TO ANY UNITS ALTERED OR REPAIRED  
FOR WARRANTY DEFECT BY ANYONE OTHER THAN X10. THIS  
WARRANTY DOES NOT COVER ANY INCIDENTAL OR CONSEQUENTIAL  
DAMAGES AND IS IN LIEU OF ALL OTHER WARRANTIES EXPRESSED OR  
IMPLIED AND NO REPRESENTATIVE OR PERSON IS AUTHORIZED TO  
ASSUME FOR US ANY OTHER LIABILITY IN CONNECTION W ITH THE  
SALE OF OUR PRODUCTS.  
IF YO U ARE N O T GETTIN G AN Y SIGN AL AT ALL  
Check that the CHANNEL slide switch (labeled A, B, C, D) on both  
units (on bottom) is set to the same letter.  
SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN  
IMPLIED WARRANTY LASTS, AND/ OR THE EXCLUSION OR LIMITATION  
OF INCIDENTAL OR CONSEQUENTIAL DAMAGES SO THE ABOVE  
LIMITATIONS AND EXCLUSIONS MAY NOT APPLY TO THE ORIGINAL  
CUSTOMER. THIS WARRANTY GIVES YOU SPECIFIC RIGHTS AND YOU  
MAY ALSO HAVE OTHER RIGHTS W HICH VARY FROM STATE TO STATE.  
If you are using coaxial TV connections from the Video Receiver,  
check that the TV is tuned to the same channel as the TV Channel  
switch on the bottom of the Video Receiver (3 or 4).  
IF THE SIGN AL IS PO O R, O R THERE IS IN TERFEREN CE  
Try changing the channel on both units. Do this by adjusting the  
CHANNEL slide switch on each unit to any position (A, B, C, or D).  
Make sure both units are set to the same letter.  
1 4  
1 5  
Download from Www.Somanuals.com. All Manuals Search And Download.  
X10 (USA) Inc.  
3824 North 5th St.,  
Suite C, North Las Vegas, NV 89030  
We b Site : w w w .x 1 0 .co m  
VK48A-02/ 99  
1 6  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Westinghouse Computer Monitor LCM 17W7 User Manual
Whirlpool Air Conditioner AS12 User Manual
Whirlpool Dishwasher 3369092 REV A User Manual
Whirlpool Microwave Oven 1997 E User Manual
Whistler Radar Detector 1505 User Manual
White Rodgers Welding System 37 1119B User Manual
WindChaser Products Air Conditioner PACR12 User Manual
Yamaha CD Player CDC 697 User Manual
Zanussi Cooktop ZCV662 User Manual
Zanussi Plumbing Product 132543 User Manual