INSTALLATION GUIDE
Grill Module
Download from Www.Somanuals.com. All Manuals Search And Download.
Wolf Grill Module
3
wolfappliance.com/specs
Grill Module Installation
IMPORTANT NOTE: Installation of the Wolf electric grill
Wolf Grill Module
Model Number
Serial Number
module must be completed by a qualified installer.
IG15/S
Read this entire installation guide prior to installation and
save for the local inspector’s reference. The homeowner
should keep this installation guide for future reference.
This appliance must be installed in accordance with
National Electrical Codes, as well as all state, municipal
and local codes. The correct voltage, frequency and
amperage must be supplied to the appliance from a dedi-
cated, grounded circuit which is protected by a properly
sized circuit breaker or time delay fuse. The proper
voltage, frequency, and amperage ratings are listed on the
product rating plate.
Record the model and serial numbers before installing
the grill module. Both numbers are listed on the product
rating plate, located on the underside of the module. Refer
to the illustration below.
RATING PLATE
Location of rating plate.
Download from Www.Somanuals.com. All Manuals Search And Download.
Grill Module Specifications
4
Overall Dimensions
Installation Specifications
GRILL MODULE
Failure to locate the grill module without the proper
clearances will result in a fire hazard.
21" (533)
IMPORTANT NOTE: Installation of the Wolf electric grill
module must meet minimum clearance requirements
shown in the installation illustration on page 6.
15"
The Wolf grill module is intended for indoor use. It is
designed to fit a standard 24" (610) deep base cabinet
(381)
with 25" (635) deep countertop. Before making the coun-
tertop cut-out, verify that the module will clear the side
walls of the base cabinet.
1
6 /4" (159)
1
/2" (13)
It is recommended that you use a Wolf cooktop ventilation
hood, pro hood or hood liner with the grill module. Refer
to the Wolf design guide.
SIDES
1" (25) FRONT / BACK
IMPORTANT NOTE: Wolf does not recommend the use of
downdraft ventilation with the grill module.
Download from Www.Somanuals.com. All Manuals Search And Download.
Grill Module Specifications
Electrical Requirements
5
wolfappliance.com/specs
IMPORTANT NOTE: This appliance must be installed in
accordance with National Electrical Codes, as well as all
state, municipal and local codes. The correct voltage,
frequency and amperage must be supplied to the appli-
ance from a dedicated, grounded circuit which is
Verify that power is disconnected from the electrical
box before proceeding.
protected by a properly sized circuit breaker or time delay
fuse. The proper voltage, frequency, and amperage ratings
are listed on the product rating plate located on the under-
side of the module. Refer to the illustration on page 3.
The Wolf electric grill module requires a separate,
grounded 3-wire electrical supply with its own circuit
breaker. Locate the electrical supply within the shaded
area shown in the installation illustration on the following
page.
MODEL IG15/S
The complete appliance must be properly grounded at
all times when electrical power is applied.
•
•
Power supply: 240/208 V AC, 60 Hz, 20 amp service.
Max connected load: 2.8 kW at 240 V, 2.1 kW at 208 V.
Do not ground the appliance with the neutral (white)
house supply wire. A separate ground wire must be
utilized.
The grill module is provided with a 4' (1.2 m) flexible
3-wire conduit that makes a connection to a junction box.
The conduit consists of two insulated hot lead conductors
and one insulated ground conductor.
If aluminum house supply wiring is utilized, splice the
appliance copper wire to the aluminum house wiring
using special connectors designed and agency certified
for joining copper and aluminum. Follow the connector
manufacturer’s recommended procedure carefully.
Improper connection can result in a fire hazard!
IMPORTANT NOTE: You must follow all National Electrical
Code regulations. In addition, be aware of local codes and
ordinances when installing your service.
For electrical installation, attach the conductors to the
residence wiring in accordance with National Electrical
Codes and all state, provincial, municipal and local codes.
The wiring diagram covering the control circuit is located
inside the module control box.
Download from Www.Somanuals.com. All Manuals Search And Download.
Grill Module Specifications
6
Installation Specifications
GRILL MODULE
SIDE
CABINET
30" (762) min
COUNTERTOP
TO COMBUSTIBLE
MATERIALS
13" (330)
max
18" (457) min
SEE COUNTERTOP
2" (51)* CUT-OUT BELOW
7" (178) TO
COMBUSTIBLE*
7" (178) TO
COMBUSTIBLE*
1
6 /4"
(
)
159
36" (914)
FLOOR TO
COUNTERTOP
15"
E
(381)
15" (381)
*Minimum clearance from cooktop cut-out to combustible materials up to 18" (457) above countertop.
NOTE: Application shown allows for installation of two 15" (381) modules side by side.
14" (356)
CUT-OUT
WIDTH
1
19 /4" (489)
CUT-OUT
DEPTH
1
FRONT
2 /2" (64) min
COUNTERTOP CUT-OUT
Download from Www.Somanuals.com. All Manuals Search And Download.
Grill Module Specifications
7
wolfappliance.com/specs
Installation Specifications
MULTIPLE COOKTOP INSTALLATION
If the grill module is to be used in combination with
additional cooktops or modules with a filler strip, refer to
the chart below for the countertop cut-out width. The
dimensions are derived by adding an additional 11/4" (32)
for each additional unit, to give you the total countertop
cut-out width. Dimensions include the filler strip.
When multiple cooktops are installed side by side, each
unit must have its own separate, recommended electrical
circuit.
When two or more cooktops or modules are installed
together, an integrated module filler strip is recommended.
The filler strip and other accessories are available through
your authorized Wolf dealer. To obtain local dealer informa-
tion, visit the find a showroom section of our website,
wolfappliance.com.
IMPORTANT NOTE: Review specific installation instruc-
tions for product to product capabilities.
Multiple Cooktops
COUNTERTOP CUT-OUT
2 Modules
3 Modules
WIDTH
291/4" (743)
441/2" (1130)
593/4" (1518)
441/4" (1124)
591/2" (1511)
501/4" (1276)
4 Modules
30" (762) Cooktop / Module
30" (762) Cooktop / 2 Modules
36" (914) Cooktop / Module
Download from Www.Somanuals.com. All Manuals Search And Download.
Grill Module Installation
Install the Module
8
Remove the grill module from its shipping carton and
discard packing materials.
To attach the brackets to the sides of the module, insert
the clip into the rectangular punchout in the pan, and push
down. Install the clamping screw into the bracket and
tighten until the screw contacts the underside of the coun-
tertop. Do not overtighten screws. Refer to the illustration
below.
Lower the grill module into the countertop cut-out
opening. Center the module in the opening and check that
the front edge of unit is parallel to the front edge of the
countertop. Check that all minimum clearances are met.
Using a pencil, outline the rear edge of the module frame
on the countertop. Remove the module from the opening.
IMPORTANT NOTE: Do not seal the grill module to the
countertop. It must be removed if service is necessary.
IMPORTANT NOTE: When repositioning the module in the
countertop opening, lift the entire unit up from the opening
to prevent scratching the countertop.
Apply the foam strip, included in the hardware package,
to the underside of the module frame. Refer to the illustra-
tion below.
Reinsert the grill module into the countertop opening.
Align the rear edge of the module frame with the pencil
line and check that it is parallel to the front edge of the
countertop. Lift the entire module to make adjustments.
MODULE
MODULE
COUNTERTOP
FOAM
STRIP
BRACKET
CLIP
1
3 /2" (89)
CLAMPING
SCREW
Foam strip.
Installation brackets.
Download from Www.Somanuals.com. All Manuals Search And Download.
Grill Module Installation
Before Operating
9
wolfappliance.com/specs
Module Removal
Read the entire Wolf grill module use & care guide
included with the unit. It contains important safety, opera-
tion, service and warranty information.
The grill module must be disconnected from the
electrical supply before removal.
Before operating, clean the grill module thoroughly with
hot water and a mild detergent. Rinse and dry with a soft
cloth. This removes any residual oil and grease left on the
surface from the manufacturing process. Refer to care
recommendations in the use & care guide.
IMPORTANT NOTE: Removal of the grill module should
only be performed by a Wolf authorized service center
technician.
If removing the grill module is necessary for cleaning or
service, first disconnect the electrical supply. Remove the
mounting brackets on each side of module and remove.
To reinstall, follow the steps on the previous page.
Download from Www.Somanuals.com. All Manuals Search And Download.
Service Information
Troubleshooting
10
Service Information
IMPORTANT NOTE: If the grill module does not operate
If service is necessary, maintain the quality built into your
grill module by calling a Wolf authorized service center.
properly, follow these troubleshooting steps:
•
•
•
•
Verify that electrical power is being supplied to the
module.
To obtain the name and number of a Wolf authorized
service center, check the contact & support section of our
website, wolfappliance.com or call Wolf customer service
at 800-332-9513.
Check the electrical connections to ensure that the
installation has been completed correctly.
When calling for service, you will need the grill module
model and serial numbers. Both numbers are listed on the
product rating plate located on the underside of the
module. Refer to the illustration below for the location of
the rating plate.
Follow troubleshooting procedures outlined in the
Wolf grill module use & care guide.
If the module still does not operate properly, contact a
Wolf authorized service center. Do not attempt to repair
the module yourself. Wolf is not responsible for service
required to correct a faulty installation.
IMPORTANT NOTE: Installation and service must be
performed by a qualified installer or service agency.
Warranty service must be performed by a Wolf authorized
service center.
RATING PLATE
Location of rating plate.
Download from Www.Somanuals.com. All Manuals Search And Download.
The information and images in this guide are the copyright property of Wolf Appliance, Inc. Neither this guide nor any information or images contained herein
may be copied or used in whole or in part without the express written permission of Wolf Appliance, Inc. ©Wolf Appliance, Inc. all rights reserved.
Wolf, Wolf & Design, Wolf Gourmet, W & Design and the color red as applied to knobs are registered trademarks and service marks of Wolf Appliance, Inc.
Sub-Zero, Sub-Zero & Design, Dual Refrigeration, Constant Care and The Living Kitchen are registered trademarks and service marks of Sub-Zero, Inc.
(collectively, the“Company Marks.”) All other trademarks or registered trademarks are property of their respective owners in the United States and other countries.
Download from Www.Somanuals.com. All Manuals Search And Download.
WOLF APPLIANCE, INC. P. O. BOX 44848 MADISON, WI 53744 WOLFAPPLIANCE.COM 800.332.9513
817487 REV-A
6/2010
Download from Www.Somanuals.com. All Manuals Search And Download.
|