CAUTIONS:
LOCATION OF CONTROLS
• Before use, ensure the rated voltage of the adaptor matches your local voltage.
• The supplied AC adaptor is for use with this unit only. Do not use it with other equipment.
• If you are not going to use the unit for a long time, disconnect the AC adaptor from the wall outlet.
• Whenever the AC adaptor is plugged in to a wall outlet, electricity is running through the unit, even
when the power switch is turned off.
Top view
Rear view
Front view
Dual Alarm Clock Radio for iPod
POWER BACK-UP DURING POWER INTERRUPTION
Model No.: CR3663i
Open the battery door and insert two "1.5V UM-4/AAA size" batteries into the battery compartment.
Be sure to install two optional "1.5V UM-4/AAA size" batteries for the power back-up function. If the AC
power supply is interrupted, the batteries supply power to keep the clock operating and the alarm times set.
• During power interruption, the clock function is still maintained. The alarm sound will not come on.
• These batteries are only for clock operation and alarm memory during power interruption.You cannot
1819 20
21
.
listen to the radio/iPod/AUX with the batteries
/MEMORY button
iPod dock
8. ALARM1 button
9. SNOOZE/PRESET button
10. ALARM2 button
11. VOLUME +/- buttons
12. SLEEP button
13. Left Speaker
15. Remote Sensor
16. Right Speaker
17. Flap door for dock
18. Earphone jack
19. AUX IN jack
1.
2.
3.
4.
5.
6.
WHEN TO REPLACE THE BATTERIES
To check the batteries' condition, unplug the AC adaptor from the wall outlet and plug it in again after a
few minutes. If the displayed time is incorrect, replace the batteries with new ones.
iPod dock connector
FUNCTION/ button
STANDBY/ON button
HOUR SKIP/TUNING
SKIP/TUNING MIN
WARNINGS:
• Danger of explosion if batteries are incorrectly replaced. Replace only with the same or equivalent type.
• Be sure to install the batteries before unplugging the AC adaptor.
• When the unit is going to be left unplugged for a long time, remove the batteries to avoid undue battery
discharge and unit damage from battery leakage.
20. DC IN jack
button
button
User’s Guide
.
.
14. LCD Display
21 FM Antenna
7
• Do not dispose of battery in a fire; battery may explode or leak.
CAUTION: When discarding batteries, environmental problems must be considered and local rules or
laws governing the disposal of these bateries must be strictly followed.
REMOTE CONTROL
SAFETY PRECAUTIONS
Using the Remote Control Correctly
• Point the remote control at the REMOTE
SENSOR located on the unit.
• When there is a strong ambient light
source, the performance of the infrared
REMOTE SENSOR may be degraded,
causing unreliable operation.
• The recommended maximum effective
distance for remote operation is about
16 feet (5 meters).
1. STANDBY/ON button
2. ALARM1 button
3. SLEEP button
4. SNOOZE/PRESET button
5. DISPLAY button
7
8
1
2
3
FCC Information
VOLUME ADJUSTMENT
9
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
4
10
TO ADJUST THE VOLUME
Adjust the VOLUME control to obtain the desired volume.
6. MEMORY/
button
5
6
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
11
7. PRESET EQ button
8. FUNCTION/ button
9. ALARM2 button
FOR PERSONAL LISTENING
Connect headphones ( Ø3.5mm stereo mini plug) to the PHONES jack. Adjust the VOLUME control to
obtain the desired volume.
When headphones are connected, the speakers are automatically disconnected.
10.
/
buttons
11. VOLUME +/- buttons
CLOCK SETTING
Setting the clock can only be done in STANDBY mode.
To Change Battery
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
ATTENTION
Remove the protective plastic tab before
operating the remote control.
1. Open the battery door.
1. Press and hold the FUNCTION/ button until the hour and the minute digits blink.
2. Press the HOUR/
3. Press the MIN/
button to adjust the desired hours.
button to adjust the desired minutes.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user authority to operate the equipment.
4. Press the FUNCTION/ button once to confirm.
This class B digital apparatus complies with Canadian ICES-003.
12:00 PM = NOON time. The "PM" indicator will light up.
2. Insert one CR2025 (3V) size battery.
CAUTION: The marking information is located at the bottom of the apparatus.
Notes:
• In RADIO mode, press the DISPLAY button on the remote control to shuffle between
the current radio station and the current time.
• In iPod/AUX mode, the current time is always shown on the display.
Warnings:
• The AC adaptor is used as disconnect device and it should remain readily operable during intended
used. In order to disconnect the apparatus from the mains completely, the AC adaptor should be
disconnected from the mains socket outlet completely.
Battery Replacement
• Minimum 10 cm (4 inches) distances around the apparatus for sufficient ventilation.
• Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
• The ventilation should not be impeded by covering the ventilation openings with items such as
newspaper, table-cloths, curtains, etc.
When the battery becomes weak, the operating distance of the remote control is greatly reduced and you
will need to replace it.
LISTENING TO THE RADIO
1. Press the STANDBY/ON button to turn the unit on.
Note: If the remote control is not going to be used for a long time, remove the battery to avoid damage
caused by battery leakage corrosion.
2. Press the FUNCTION/ button to FM or AM band.
• No naked flame sources such as lighted candles should be placed on the apparatus.
3. Press the
or
button to tune in to a station.
On Operation
WARNINGS:
• Adjust the volume control to obtain the desired volume.
• Do not dispose of battery in fire; battery may explode or leak.
• Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
• Danger of explosion would be resulted if battery is incorrectly replaced. Replace only with the same or
equivalent type of battery.
CAUTION: When discarding batteries, environmental problems must be considered and local rules or laws
governing the disposal of these batteries must be strictly followed.
Do not turn up the volume while listening to your iPod with no audio signals or very low level inputs. If
you do so, the speakers may be damaged when the peak level of the sound is played.
Searching for a Station Automatically
• Press and hold the
or
button until the tuner starts searching for a station, then release. After
tuning into a station, the search stops.
• The search may not stop at a station with a very weak signal.
On Use
Use the unit in moderate climates. Never use the unit where it would be subject to:
Presetting Stations
- Heat sources such as radiators or air ducts.
- Direct sunlight.
- Excessive dust.
- Moisture or rain.
The unit can store a total of 20 stations in memory (10FM, 10AM). Presetting allows you to tune in to a
station directly.
1. Tune in to a desired station.
- Mechanical vibration or shock.
- Uneven surface.
• Do not place any heavy objects on top of the unit.
• When the unit is used with an AC power adaptor, do not wrap the unit in a cloth, blanket, etc.. If you
do so, the temperature inside and outside the unit may rise considerably, resulting in malfunctioning
of the unit.
• If the unit is brought directly from a cold to a warm location, or is placed in a very damp room, the
moisture may condense on the lens inside the unit. Should this occur, the unit will not operate. In
this case, remove the disc and leave the unit in a warm place for several hours until the moisture
evaporates.
2. Press the /MEMORY button. The preset number will blink and the "MEM" indicator will be shown
on the display.
3. Press the PRESET/SNOOZE button to select the preset number.
POWER SUPPLY
USING THE AC Adaptor
4. Press the
/MEMORY button again to store it in memory.
Using an AC adaptor which is not supplied with the unit may damage the unit. The supplied AC adaptor
5. Repeat steps 1-4 to store other stations.
operates on AC 100V-240V~50/60Hz.
Tuning in to a Preset Station
1. Press the PRESET/SNOOZE button, the preset number and "MEM" will be shown on the display.
2. Press the PRESET/SNOOZE button repeatedly to select the preset number for your desired station.
For Better Reception
To AC outlet
• For the unit to operate at its best, it should not be subject to temperatures below 41°F (5°C) or
above 95°F (35°C).
FM: Fully unwind the antenna wire. Extend the antenna wire and place it in the position that sounds
best.
Note: Do not connect the FM antenna to an outside antenna.
When the reception is good, the "STEREO" indicator will appear on the display.
AM: Reposition the unit to get better AM reception.
FM antenna
To “DC IN 12V” jack
AC adaptor
Note: To prevent possible interference to the AM signal, please keep a certain distance(The AC
adaptor cable's length) away from the main unit.
Download from Www.Somanuals.com. All Manuals Search And Download.
- ꢀ -
|