STEP3 Point the remote control toward
the TV and enter the three-digit
code from the code table. If
there is more than one code
number assigned to your TV
brand, try one code number at a
time until the TV turns off right
after you entered the number.
*Tip: Red light will blink twice.
Instructions
Operating Manual
for 2 in 1 Cable TV
Remote Control
This remote control is preprogrammed
to operate CABLE Box.
The [CATV] button sends out the TV
and CABLE power commands if you
press the [CATV] button.
To return to the original function, press
the [CH-] button in the STEP2 .
Please program it for your TV by
following the instructions shown below.
Batteries
UR-J2000TVE
B. Recalling the TV Three-digit code :
The remote control uses AAA batteries.
Please be sure to match the batteries
Searching Method
STEP1 Press [TV] and [MUTE]
buttons simultaneously until
the red light is on.
Press [CH +] button and hold until the
TV turns off. As soon as the TV turns
off, release [CH+] button.
+
-
with the ( ) and ( ) markings inside the
battery compartment during installation.
STEP2 Press [VOLUME -] button.
*Tip: You can confirm the power off and
The red light will blink a number of
times indicating the number of each
digit of the code. Each digit is
separated by one second interval of
red light being off.
*Tip: One blink, three blinks and 10
blinks, indicates the code
number 130.
on by pressing [MUTE] button.
STEP4 Press [TV] button to store the
three-digit code.
*Tip: Red light will blink twice.
Install two AAA alkaline
batteries as shown here
Three-digit code :
Set-up for your VOLUME control
The remote control is preprogrammed
to control VOLUME and MUTE functions
through your TV. To switch VOLUME
and MUTE functions to your Cable Box:
Helpful hints
Set-up for your Cable Box
Press arrow gently &
pull down to remove cover
The remote control is preprogrammed
to control your cable box. If it does
not work properly, please set-up the
right code by using the three-digit
code or searching method.
If you have a TV with a remote
control, we recommend that you plug
its power cord directly into a wall
outlet if available (your cable installer
may select an alternate setup)
Programming your remote control
STEP1 Press [CATV] and [MUTE]
buttons simultaneously until
red light is on.
Setup for your cable box
No setup is required. The remote control is
preprogrammed to operate your cable box.
STEP2 Press [VOLUME +] button.
STEP3 Press [CATV] button.
To return to the TV’s VOLUME, press
[TV] button.
Setup for your TV
Find your TV brand and its three-digit
code on the back of this manual. If the
TV brand is not listed, please use the
Searching Method in STEP3 .
*Tip: Red light will blink twice.
Operation
If red light does not blink when
you press keys the operation is
intermittent:
Make sure the batteries are
inserted correctly.
Replace old batteries with two new
AAA batteries. Please do not mix
old batteries with new ones.
Set-up for advanced functions
A. To turn on your TV and Cable at the
same time with CATV button:
STEP1 Press [CATV] and [0] buttons
simultaneously until the red
light is on.
STEP1 Turn on your TV manually.
*Tip : If you have RCA TV, don’t turn
on the TV.
Universal Remote Control, Inc.
STEP2 Press [TV] and [MUTE] buttons
simultaneously until the red
light is on.
OEE-0017E Rev 02(05/14/02)
STEP2 Press [CH +] button.
Download from Www.Somanuals.com. All Manuals Search And Download.
|