®
CARE AND USE FOR
ISLAND HOODS
(Turn Book Over for Installation
Instructions)
READ AND SAVE THESE INSTRUCTIONS
HNI
O
O
HTNI
Model #
Serial #
5551 McFadden Avenue, Huntington Beach, CA 92649 • 800/735-4328
RO#8605 • 35-05-274A • ©BSH Home Appliance Corporation, 1998 • Litho in U. S. A. 4/00
Download from Www.Somanuals.cPoamg.eA1ll Manuals Search And Download.
LES INSTRUCTIONS DE SÉCURITÉ IMPORTANTES
AVERTISSEMENT - POUR
5. Utiliser toujours les batteries
RÉDUIRE LE RISQUE
de cuisine et les ustensiles
D’INCENDIE, DE CHOC
appropriés pour le type et la
ÉLECTRIQUE, OU DE LA
quantité de la nourriture
BLESSURE AUX PERSONNES,
ayant préparée.
OBSERVER LE SUIVANT:
AVERTISSEMENT: - POUR
RÉDUIRE LE RISQUE DE
BLESSURE AUX PERSONNES
DANS L’ÉVÉNEMENT D’UN FEU
DE GRAISSE DU SOMMET DE
LA CUISINIÈRE, OBSERVER
LES SUIVANTS:
ATTENTION: SEULEMENT POUR
L’UTILISATION D’AÉRATION. NE
PAS L’UTILISER POUR ÉPUISER
LA VAPEUR OU LES MATIÈRES
EXPLOSIVESOUDANGEREUSES.
1. Utiliser cet appareil seulement
dans la manière destinée par
a) ÉTOUFFER LES FLAMMES
avec un couvercle ajusté,
une tôle du biscuit ou un
plateau métallique, puis
fermer le bec. SOYEZ
le fabricant. Si vous avez des
questions, contacter le
fabricant(800-735-4328).
2. Avant l’entretien ou le
nettoyage de l’appareil, couper
le courant au tableau de
service, et fermer à clef.
CERTAIN D’EMPÊCHER LES
BRÛLURES. Si les flammes
ne s’éteindront pas
immédiatement, ÉVACUER
ET APPELER LE SERVICE
DES INCENDIES.
AVERTISSEMENT - POUR
RÉDUIRE LE RISQUE D’UN FEU
DE GRAISSE DU SOMMET DE LA
CUISINIÈRE:
b) NE JAMAIS RAMASSER UNE
CASSEROLE EN FLAMMES -
Vous pouvez être brûlé.
1. Garder le ventilateur, les
filtres et les surfaces chargées
de la graisse propres.
c) NE PAS UTILISER DE L’EAU,
y compris les torchons
mouillés ou les serviettes -
une explosion violente
résultera.
2. Toujours mettre le capot EN
MARCHE en cuisinant à la
haute chaleur.
d) Utiliser un extincteur
SEULEMENT si:
3. Utiliser les hauts
1) Vous savez que vous
avez un extincteur de Classe
ABC et vous. savez déjà
comment le faire fonctionner.
2) Le feu est petit et est
contenu dans la région où il
a commencé.
positionnements du cuisinière
sur la cuisinière seulement
quand c’est nécessaire.
Chauffer l’huile lentement sur
un positionnement bas à
moyen.
3) Le service des
incendies est appelé.
4) Vous pouvez
4. Ne pas laisser la cuisinière
sans surveillance pendant la
cuisson.
combattre le feu avec votre
dos à une sortie.
Download from Www.Somanuals.cPoamg.eA3ll Manuals Search And Download.
CONTROL PANEL
MODELS: HNI, HTNI ELECTRONIC TOUCH CONTROLS
A. Motor OFF button
Circuit Self-test
B. ON button and motor speed
selection button 1, 2, 3, 1,....
C. Speed 1LED
The control allows the user to
perform a self-test to check the
correct function of the hood.
The self test is activated by pressing
the A and B keys simultaneously
for 3 seconds.
D. Speed 2 LED
E. Speed 3 LED
F. Timer LED
G. Timer.
If the motor is off while the
timer is pressed the motor will
run at speed 3 for 20 minutes
then stop.
If the motor is running when the
timer key is pressed the motor
will continue to run for 10
minutes. After 10 minutes the
motor will stop.
The self-test procedure order is:
1. Four LED’s switch on.
2. Four LED’s switch off.
3. Blower runs at speed 1.
4. Blower runs at speed 2.
5. Blower runs at speed 3.
6. Blower off.
7. Lights switch on.
8. Lights dim (only for model
HTNI).
Pressing the timer or speed
button while the Timer LED is
on will disable the timed mode.
H. Light ON/OFF button.
I. Dim Light ON/OFF button (only
for model HTNI).
9. Lights turn off.
10. Beep signals end of self-test.
OPERATING
INSTRUCTIONS - HOOD
The blower should be turned on for
10 minutes before cooking in order
to establish air currents through the
hood. This will improve the capture
and removal of heat, smoke,
moisture, grease and cooking odors.
Use the low speeds for normal use
and the higher speeds for strong
odors or fumes.
Fig. 1
Grease Filter Saturation LED
The speed 2 LED in Figure 1 in
is marked with an F. This LED will
flash to remind you when the grease
filter needs to be cleaned after 40
hours use. Follow the instructions
for cleaning filters in thisFollow the
instructions for cleaning filters in
this booklet. Once the grease
filters have been cleaned, reset the
display by pressing button A for 3
seconds until you hear the signal
(beep).
Drafts across the range or cooktop
will reduce the effectiveness of the
hood. Such drafts should be pre-
vented when possible.
Page 4
Download from Www.Somanuals.com. All Manuals Search And Download.
FILTERS
CLEANING
INSTRUCTIONS
Be sure lights are cool
before cleaning the hood.
The metal grease filters are made of
anodized aluminum and are long
lasting.
To Clean Filter/s
To Remove The Metal Grease
Filter/s
•
It is recommended that the
filters be washed at least once a
month; they can be washed by
hand or in the dishwasher.
Drain water through holes and
along filter edges and allow to
dry thoroughly before replacing
it.
•
Turn blower and lights off.
For Models HNI, HTNI
•
•
Push each handle in the
direction of the arrows as shown
in Fig. 2.
To Replace The Metal Grease
Filter/s
To Clean Hood Surface
•
For general care, wipe the
outside of the stainless steel,
white, black or glass hood with
sudsy water or household
cleaners such as Fantastic® or
Formula 409®, rinse well and dry
with clean soft cloth to avoid
water marks.
•
Reverse procedure.
•
Wipe and dry brushed stainless
steel in the same direction as the
grain.
Fig. 2
•
•
Do not use abrasive products.
To remove finger prints and give
added shine use spray cleaners
such as Stainless Steel Magic®
and Shimmer®
Download from Www.Somanuals.cPoamg.eA5ll Manuals Search And Download.
LIGHTS
NOTE: Turn blower and lights
off. Make sure the lights are
cool. If new lights do not operate:
verify lights are inserted correctly
before calling service.
ReplaceLightsForModelHTNI
(Fig. 3)
•
•
Remove the damaged light and
replace with a new halogen light
Type MR16, 12 Volt, 20 Watt
maximum.
When installing the new light be
sure that the two prongs of the
light fit perfectly into the two
sockets of the lightholder. Press
in firmly.
Fig. 3
Replace Lights For Model HNI
(Fig. 4)
•
Remove lens cover by removing
screw and pulling cover down.
Pull out flourescent tube and
replace with Philips Type
PL-S 9 Watt maximum.
Replace cover and secure with
screw.
Fig. 4
•
•
Page 6
Download from Www.Somanuals.com. All Manuals Search And Download.
®
Thermador Hood Warranty
FULL ONE YEAR WARRANTY
Covers one year from date of installation, or date of occupancy on a new, or previously
unoccupied dwelling. Save your dated receipt or other evidence of installation/
occupancy date.
Thermador Will Pay For:
All repair labor and replacement parts found to be defective due to materials and
workmanship.
Service must be provided by a Factory Authorized Service Agency, during normal
working hours. For a Service Agency nearest you, please call 800/735-4328.
Thermador Will Not Pay For:
1.
2.
Service by an unauthorized agency. Damage or repairs due to service by an
unauthorized agency or the use of unauthorized parts.
Service visits to:
• Teach you how to use the appliance.
• Correct defects or repairs due to improper installation. You are responsible
for providing electrical wiring and other connecting facilities.
• Reset circuit breakers or replace home fuses.
• Correct damage caused from accident, alteration, misuse, abuse, improper
installation or installation not in accordance with local electrical codes or
plumbing codes, or improper storage of the appliance.
Service labor during limited warranty period.
3.
4.
Travel fees and associated charges incurred when the product is installed in a
location with limited or restricted access (i.e. airplane flights, ferry charges,
isolated geographic regions).
5.
Repairs due to other than normal home use.
This warranty applies to appliances used in residential applications; it does not cover
their use in commercial installations. The warranty is for products purchased and
retained in the 50 states of the U. S. A., the District of Columbia and Canada. Should
the appliance be sold by the original purchaser during the warranty period, the new
owner continues to be protected until the expiration date of the original purchaser's
warranty period. Products for use in Canada must be purchased through the Canadian
distribution channel to ensure regulatory compliance and warranty coverage. This
warranty gives you specific legal rights. You may also have other rights which vary
from state to state.
HOW TO OBTAIN SERVICE
•
•
•
•
Contact the Factory Authorized Service Agent in your area.
Contact the Dealership where you purchased the appliance.
Call the Thermador Customer Support Call Center at 800-735-4328.
Write to us at: Thermador 5551 McFadden Avenue, Hunington Beach, CA 92649.
Download from Www.Somanuals.cPoamg.eA7ll Manuals Search And Download.
Page 8
Download from Www.Somanuals.com. All Manuals Search And Download.
|