EZVR4
User’s Manual
Speco Technologies
200 New Highway
Amityville, NY 11701
800-645-5516
Download from Www.Somanuals.com. All Manuals Search And Download.
About this document
Before installing the unit, be sure to thoroughly review and follow the instructions in this User’s
Manual. Pay particular attention to the parts that are marked NOTICE.
When connecting with external application, first turn the power OFF and follow manual
instructions for appropriate installation.
Before reading this document
1. This manual contains information for configuring, managing and using the EZVR4.
2. To prevent fire or electrical shock, do not expose the product to heat or moisture
4. Be sure to read this manual before operating the unit.
5. For questions and technical assistance of this product contact your local dealer.
►Strong recommendation on installation of the unit
1. Confirm that electricity at the place you want to install the ERVR4 is stable and meets
the electrical requirements. Unstable electricity can cause malfunctions of the unit or
give critical damage to the unit.
2. Several chips on the main board of the unit and hard disk drive inside the unit generate
heat which must be properly discharged. Do not place any objects adjacent to the
ventilation openings on the sides of the unit.
3. Put the EZVR4 in a well-ventilated place and do not put heat-generating objects on the
unit.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
FCC Statement:
WARNING
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference. (2) This device must
accept any interference received including interference that may cause undesired
operation."
* Federal Communications Commission (FCC) Statement
WARNING
This Equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
* You are cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
INSTALLATION
1. The package
2. Un-packed
3. Take the unit out from the package
4. Put on a flat desk
5. Connect your camera cables to the BNC
connectors on the rear.
6. Connect your monitor cable to the BNC
connector labeled “Monitor” on the rear.
7. Connect the power adaptor.
8. Turn on the “Power” switch after the
cameras are installed. The EZVR4 will
then “boot” up and begin recording.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
FRONT PANEL
1.
: Quad screen mode button
2.
3.
4.
5.
6.
7.
8.
9.
CHANNEL 1
CHANNEL 2
CHANNEL 3
CHANNEL 4
24H
: Channel 1 full screen button
: Channel 2 full screen button
: Channel 3 full screen button
: Channel 4 full screen button
: 24 hour recording mode
72H
: 72 hour recording mode
240H
: 240 hour recording mode
480H
: 480 hour recording mode
10. 960H
: 960 hour recording mode
11. REC
: Press this button to start recording. Press again to stop.
: Press this button to display the menu setup
: Press this button to search for a specific playback time
: Copies Playback video onto a USB device
12. MENU
13. SEARCH
14. BACKUP
15. UP / STOP
: Move cursor UP
-
Stop button in Playback
/
Also: In live mode Press the UP button for 5 seconds to lock the
front panel buttons. Repeat to unlock.
16. DOWN / PAUSE
17. REW
: Move Cursor down
-
Pause in Playback
/
: Reverse playback – Playback speed – Frame by frame
: Forward playback – Playback speed – Frame by frame
: Enter button - Value change in menus
/
/
18. FF
19. ENTER
6
Download from Www.Somanuals.com. All Manuals Search And Download.
REAR PANEL
Power cord in 12VDC / 5A, Power Switch (ON / OFF)
Camera 1 ~ 4 input BNC type
Main monitor output
Audio channel input x 1 and output x 1 – RCA Type
Alarm / Relay connector
7
Download from Www.Somanuals.com. All Manuals Search And Download.
Booting Up
Detecting the hard disk
Live screen
Indicator:
Live:
HDD installed
Recording
Video loss
Alarm Output
Overwrite
Key lock
Live mode
Alarm Input
Playback:
Forward
Reverse
Pause
8
Download from Www.Somanuals.com. All Manuals Search And Download.
Remote controller
The keys on the remote control have the same functions as the front keyboard of the unit.
9
Download from Www.Somanuals.com. All Manuals Search And Download.
Main MENU – Time Setup
1.
2.
Press ENTER to select Time Set. Press ENTER again to display the cursor.
Use the left or right buttons to select the item you wish to adjust, then press ENTER to
change the value.
3.
4.
5.
Press MENU to return to the previous screen and move the cursor to Apply.
Press ENTER to confirm.
Select On or Off for Daylight Savings Time. Once the time is initially set, changing the
DST mode will adjust the time appropriately.
10
Download from Www.Somanuals.com. All Manuals Search And Download.
Main MENU – Audio Record
Use direction buttons to select Audio Record. Press ENTER to select On or Off.
Diagram
Speaker
RCA
RCA Cable
Audio Out (Line Level)
Microphone
RCA
Audio In (Line Level)
11
Download from Www.Somanuals.com. All Manuals Search And Download.
Main MENU – Alarm Input
Use direction buttons to select Alarm Input.
Press the Enter button to choose the type of
sensor input (Normally Open - NO or
Normally Closed - NC).
To disable the alarm mode switch to the Off
position..
Main MENU – Alarm Output
Use direction buttons to select Alarm Output. When switched to Off the alarm output is
disabled.
Press the Enter button to turn the output
relay on or off.
12
Download from Www.Somanuals.com. All Manuals Search And Download.
Alarm Input
Door closed
Door open
Alarm 1 + GND / Alarm 2 + GND / Alarm 3 + GND / Alarm 4 + GND
The Alarm Signal type depends upon the Alarm Sensor polarity defined as NO (Normal Open)
or NC (Normal Close).
Alarm Output:
Relay: NO + COM or NC + COM
Relay: NO (Normal open)
Alarm trigger
Relay: NC (Normal Close)
NO
COM
NC
COM
13
Download from Www.Somanuals.com. All Manuals Search And Download.
Main MENU – Auto Record
Use direction buttons to select Auto Record.
Press the Enter button to choose On or Off.
If switched to OFF then Auto Record is
disabled.
When Auto Record is set to On, the EZVR4
will start recording again after 2 minutes of
inactivity after being manually stopped.
Main MENU – Overwrite HDD
Use direction buttons to select Overwrite
Enable. Press the Enter button to choose
Yes or No.
NO - Recording stops when the Hard
Drive is full
YES – Recording continues to overwrite the
oldest information after the Hard Drive is full
14
Download from Www.Somanuals.com. All Manuals Search And Download.
Main MENU – Language
Use direction buttons to select Language.
Press Enter button to choose a language.
Supported Languages:
English / French / Spanish
Main MENU – Exit
Use direction buttons to select Exit.
Press Enter button to leave the menu.
15
Download from Www.Somanuals.com. All Manuals Search And Download.
Playback mode – Note: Instructions appear on the screen after selecting “Search”
Press SEARCH to enter the playback mode. Press ENTER to select a date and time.
Use the left or right arrows to select the item Press MENU to return to the previous screen
you wish to change, then press ENTER to
change the value
and move cursor to Search.
Press ENTER to start the searching.
Wait until the unit starts to playback.
16
Download from Www.Somanuals.com. All Manuals Search And Download.
Backup mode
Note: Plug in a USB device before starting the backup
You must first playback an event using
instructions from the previous page.
When the event you wish to backup appears
on the screen, press the BACKUP button to
select the start time.
Press the BACKUP button a second time to
select the end of the copy. The unit will detect
the USB drive and copy the data to the USB
device. After the backup procedure is
completed you will be returned to the live
screen. The viewer and .avi conversion
software will be saved to the USB driver at the
same time.
17
Download from Www.Somanuals.com. All Manuals Search And Download.
Player Software Main Screen
Click icon to select the file to play. It will be in .vvf format
18
Download from Www.Somanuals.com. All Manuals Search And Download.
Starts to play;
c d e f g h i j k l
Open File
Play
c
d
e
f
g
h
i
j
k
l
Fast Reverse
Play Reverse
Previous Frame
Pause
Fast Forward
Still Capture (Save to C:\ Capture & Clipboard)
Full Screen (manual switch)
Quad Screen
Next Frame
AVI Button: .vvf file export to .avi format
Select export channel(s) and click audio if included.
Browse for the source file
Browse a path for file output
Select a compression codec
Percentage of the export AVI progress
19
Download from Www.Somanuals.com. All Manuals Search And Download.
Specifications
EZVR4
Model
Input
4 CH Inputs 1.0Vp-p, 75ohm (BNC Type)
Main monitor composite video (BNC type) x 1
Output
Horizontal Resolution 640x448 (NTSC) / 640x544 (PAL)
S/N Ratio
More than 40dB
6.7 Million
Color
Monitoring Method
Channel Display
Single / Quad channel
640(H)x 448(V) Active Pixels(NTSC);
640(H) x 544(V) Active Pixels (PAL)
120 fps (NTSC) / 100 fps (PAL)
Screen Quality
Display Rate
Recording/ Play Function
Compressed Picture
Recording Control
Playback Mode
Other Function
Operation Mode
Alarm
M - JPEG
Auto / manual
Date & Time search
Record / Play / Backup
Alarm in x 4 / Relay out x 1
USB 1.1/2.0 Flash drive or HDD
HDD x 1
Back-Up
Storage
Audio Input
RCA x 1 Line Level
Audio Output
HDD Record Mode
Front Panel lockout
Power Supply
Weight
RCA x 1 Line Level
Full stop / overwrite
Yes
DC 12V / 5A Included
N.W./G.W. 6.75 pounds / 8.25 pounds
16.75”(W) x 13”(D) x 2.6”(H)
Dimension
Operating Temperature 41 ºF~104 ºF
Operating Humidity Less than 90%
20
Download from Www.Somanuals.com. All Manuals Search And Download.
|