Sony Microcassette Recorder CFS 515S User Manual

On placement/operation  
Pre ca u t io n s  
WARNING  
• Do not leave the player in a location  
near heat sources, or in a place subject  
to direct sunlight, excessive dust or  
mechanical shock.  
Ad ju st in g t h e a u d io e m p h a sis  
(DYNAMIC SOUND SYSTEM)  
Se t t in g u p t h e syst e m  
Co n n e ct in g t h e Sp e a ke rs  
On safety/pow er sources  
To prevent fire or shock hazard, do not  
expose the player to rain or moisture.  
To avoid electrical shock, do not open  
the cabinet. Refer servicing to qualified  
personnel only.  
• Should any solid object or liquid fall  
into the player, unplug the player, and  
have it checked by qualified personnel  
before operating it any further.  
• For AC operation, check that the  
players operating voltage is identical  
with your local power supply (see  
“Specifications”) and use the supplied  
mains lead; do not use any other type.  
The voltage selector is located on the  
rear of the player (CFS-515S only).  
• The player is not disconnected from the  
AC power source (mains) as long as it is  
connected to the wall outlet, even if the  
player itself has been turned off.  
• For battery operation, use six R20 (size  
D) batteries.  
• Do not place anything within 10 mm of  
the side of the cabinet. The ventilation  
holes must be unobstructed for the  
player to operate properly and to  
prolong the life of its components.  
• Since a strong magnet is used for the  
speakers, keep personal credit cards  
using magnetic coding or spring-  
wound watches away from the player  
to prevent possible damage from the  
magnet.  
Using the 5 BAND GRAPHIC EQUALIZER  
Make sure you turn off the power before making connections.  
Use  
To adjust  
Do not install the appliance in a  
confined space, such as a bookcase or  
built-in cabinet.  
Ra d io  
MEGA BASS  
400 Hz  
deep bass sound.  
b
a
1
speaking voice, middle frequencies  
of instrumental music.  
Ca sse t t e -  
Co rd e r  
The FUNCTION selector is located at  
the front.  
When you turn on the player, the  
OPR/ BATT indicator lights up.  
1 kHz  
4 kHz  
10 kHz  
presence of vocals.  
• If the player has not been used for a  
long time, set it in the playback mode to  
warm it up for a few minutes before  
inserting a cassette.  
brightness of the sound.  
]
high treble sounds or to reduce high  
frequency noise/ tape hiss.  
}
}
2
]
• When the batteries are not to be used,  
remove them to avoid damage that can  
be caused by battery leakage or  
corrosion.  
• The nameplate indicating operating  
voltage, power consumption, etc. is  
located at the rear.  
Operating Instructions  
If you have questions or problems  
concerning your player, please consult  
your nearest Sony dealer.  
T
F
E
L
T
H
G
R
I
E
K
N
R
A
6
E
D
E
P
E
C
S
P
A
IM  
Using the PRESET MODE  
Set the position to  
To  
DYNAMIC  
MANUAL  
adjust the sound using the 5 BAND  
GRAPHIC EQUALIZER.  
1
2
Align the grooves and slide the speaker box down until it  
snaps into place a.  
SOUND  
SYSTEM  
MANUAL  
Connect the black wires to (–) minus and the red wires to  
(+) plus terminals: the right speaker wires to the RIGHT,  
and the left speaker wires to the LEFT terminals.  
DYNAMIC  
DISCO  
get powerful, clear sounds emphasizing low  
and high range audio.  
SOUND  
SYSTEM  
DISCO  
Tip  
DYNAMIC  
PARTY  
get light, bright sounds emphasizing high  
and middle range audio.  
SOUND  
To detach the speakers, unlock the speaker b and slide the speaker box all  
the way up and away from the player.  
SYSTEM  
CFS-515S  
CFS-515L  
PARTY  
Ch o o sin g Po w e r So u rce s  
LIVE  
get wide-ranging sounds having presence.  
DYNAMIC  
SOUND  
SYSTEM  
Sony Corporation © 1999  
Printed in Vietnam  
To u se t h e p la ye r o n AC p o w e r so u rce (m a in s)  
LIVE  
Connect the supplied AC power cord to the AC IN jack.  
3-862-882-71(1)  
No t e  
When adjusting the 5 BAND GRAPHIC EQUALIZER, be sure to set the  
PRESET MODE to MANUAL. The graphic equalizer will not work in any  
other position.  
To a d ju st t h e so u n d b a la n ce o f t h e rig h t a n d le ft sp e a ke rs.  
Use BALANCE.  
Tro u b le sh o o t in g  
Sp e cifica t io n s  
Frequency range  
CFS-515S  
Battery life  
Deck A  
Th e re is n o a u d io .  
FM Recording: Sony R20P: Approx. 10  
hours/ Sony LR20 alkaline: Approx. 20  
hours  
Playback: Sony R20P: Approx. 3.5  
hours/ Sony LR20 alkaline: Approx. 8  
hours  
Pow er requirements  
CFS-515S  
110-120 V/ 220-240 V AC selectable,  
50/ 60 Hz  
CFS-515L  
• Connect the mains lead securely.  
• Insert the batteries properly.  
• Replace all batteries if they are weak.  
• Unplug the headphones.  
• Adjust the volume.  
• Set FUNCTION to the position you  
want to operate.  
FM: Saudi Arabia: 87.6-107 MHz  
Other countries: 87.6-108 MHz  
MW: 530-1,605 kHz  
SW1: 2.3-7 MHz  
SW2: 7-22 MHz  
CFS-515L  
FM: 65-108 MHz  
MW: 531-1,602 kHz  
LW: 153-279 kHz  
Capstan  
1
to AC IN  
No ise is h e a rd .  
2
to a wall outlet  
• Someone is using a portable telephone  
or other equipment that emits radio  
waves near the player. Move the  
portable telephone, etc., away from the  
player.  
SW: 5.95-18 MHz  
230 V AC, 50 Hz  
IF  
FM: 10.7MHz  
MW/ LW/ SW: 455 kHz  
Aerials  
FM/ SW: Telescope  
MW/ LW: Built-in ferrite bar  
Recording system  
4-track, 2-channel stereo  
Frequency response  
70–13,000 Hz  
Playback  
head  
9V DC, six R20 (size D) batteries  
Pow er consumption  
AC 18 W  
Pinch  
roller  
To u se t h e p la ye r o n b a t t e rie s  
• Dimensions  
Insert six R20 (size D) batteries (not supplied) into the battery  
compartment.  
Ca sse t t e ca n n o t b e in se rt e d .  
• Insert the cassette properly.  
Approx. 697 x 211 x 201.5 mm (w/ h/ d)  
(27 1/ x 8 3/ 8 x 8 inches) incl. projecting  
parts 2and controls, not incl. handle  
• Mass  
Approx. 5.8 kg (12 lb 13 oz) incl. batteries  
• Supplied accessory  
AC power cord (1)  
To a d ju st t h e vo lt a g e (CFS-515S o n ly)  
Th e r REC b u t t o n d o e s n o t  
fu n ct io n .  
No cassette is in deck B.  
• Make sure the safety tab on the cassette  
is in place.  
Be sure to set the VOLTAGE SELECTOR (at the rear) to your local power  
supply.  
Speakers  
Full range: 10 cm (4 inches) dia., 6 ohms,  
cone type/ Tweeter: 2 cm (13/ 16 inches) dia.  
Output  
Headphones jack (stereo minijack), for  
16–68 ohms impedance headphones  
Maximum pow er output  
5 W + 5 W  
VOLTAGE  
SELECTOR  
220 - 240V  
Design and specifications are subject to  
change without notice.  
Deck B  
Po o r p la yb a ck, re co rd in g o r  
e ra sin g q u a lit y.  
• Dirty heads. Clean the unit (as shown)  
with a cotton swab slightly moistened  
with cleaning fluid or alcohol.  
• Demagnetize the heads and all metal  
parts in the tape path with a  
Erase head  
Capstan  
110 - 120V  
commercially available tape head  
demagnetizer.  
Tip  
For customers supplied with an AC plug adaptor, use it if the plug of the  
mains lead does not match your mains.  
Record/  
Playback head  
No t e s  
Pinch roller  
• To use the player on batteries, disconnect the mains lead from the player.  
• Replace the batteries when the OPR/ BATT indicator dims or when the player  
stops operating. Replace all batteries with new ones.  
Cotton sw ab  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Sony Home Theater System SA VE835ED User Manual
SOYO Computer Hardware P4X400 User Manual
Stanton Music Mixer MODEL M203 User Manual
State Industries Water Heater 0710 316888 002 User Manual
Sub Zero Refrigerator 661 B User Manual
Sunbeam Bread Maker BM3500 User Manual
Sunbeam Kitchen Grill GC2600 User Manual
Sylvania Digital Photo Frame SDPF1089 User Manual
Symphonic TV VCR Combo 9 TVCP User Manual
Tanaka Brush Cutter TBC 2100 User Manual