Hand Vacuum
OWNER’S MANUAL
Model EP031KC
120V., 60Hz.
450 Watts, 3.75 Amps
For information or assistance:
EURO-PRO Operating LLC
94 Main Mill Street, Door 16
Plattsburgh, NY 12901
Tel: 1 866 98SHARK (1 866 987-4275)
Download from Www.Somanuals.com. All Manuals Search And Download.
TROUBLE SHOOTING GUIDE
GETTING TO KNOW YOUR HAND VACUUM
PROBLEM
POSSIBLE REASON
POSSIBLE SOLUTION
1. Power cord not firmly plugged 1. Plug unit in firmly.
HAND VACUUM
WILL NOT
OPERATE
into outlet.
2. Check fuse or breaker.
Replace fuse/reset breaker.
3. Call 1-800-798-7398.
2. No power in wall outlet.
3. Needs servicing.
1. Allow unit to cool down, then
Restart. Empty dust cup –
(see page 4).
2. Turn unit off and unplug
from wall outlet. Remove
Dust Cup Filter and check
for object(s) in air duct and
remove.
3. Clean or replace Dust Cup
Filter. (see page 4)
HAND VACUUM
1. Dust cup is full.
WILL NOT PICK-UP 2. Unit clogged.
OR SUCTION
POWER IS WEAK
3. Dust Cup Filter needs
cleaning or replacing.
1. Dust cup is full.
2. Dust Cup Filter is not
installed correctly.
3. There is a puncture/hole in
Dust Cup Filter.
1. Empty dust cup.
2. Review Dust Cup Filter
instructions. (see page 4)
3. Replace dust cup filter. (see
page 4)
DUST ESCAPING
FROM HAND
VACUUM
HAND VACUUM
HOSE OR
BRUSHES WILL
NOT PICK-UP
1. Remove hose and/or
bushes. Remove obstruction
from hose.
1. Hose clogged.
2. Dust cup is full.
2. Empty and clean dust cup.
REPLACEMENT FILTERS
Replacement dust cup filter SKU# AKC031
for Model EP031KC
Call:
1-866-98SHARK (1-866-987-4275)
6. Dust Cup Filter
7. Upholstery Brush
8. Crevice Tool
1. Suction Hole
Monday to Friday 8:30 A.M. - 5:00 P.M. Eastern Standard Time
2. Dust Cup Release Button
3. On/Off Power Switch
4. Handle
or
9. Flexible Hose
5. Dust Cup (Container)
FOR TECHNICAL SUPPORT
Call: 800-798-7398
Technical Specifications
Monday to Friday 8:30 A.M. - 5:00 P.M. Eastern Standard Time
Voltage:
Power:
120V., 60Hz.
3.75 Amps, 450 Watts
Please Note
The Dust Cup Filter is washable. It should, however, be replaced every three
(3) months to ensure peak performance of your vacuum.
Important
Make sure that Dust Cup Filter is completely dry before re-installing back
in the hand vacuum.
2
5
Download from Www.Somanuals.com. All Manuals Search And Download.
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS cont.
Cleaning & Changing the
3. To use the flexible hose, push
3. Empty the dust from the dust cup
Warning: Always unplug from
electrical outlet before opening the dust
cup (container).
Note: Dust cup filter must be used
when operating the hand vacuum.
the end of the hose into the
suction hole, then attach the
desired accessory to the other
end of the flexible hose, as
shown below.
(container). (Fig. 3)
Dust Cup Filter
4. Rinse the dust cup filter in cold water
and then wait 24 hours until it dries
completely before replacing back
into the dust cup (container).
(Fig. 4 & 5)
5. When the dust cup filter is completely
dry, replace the dust cup filter carefully
back into the dust cup (container).
6. Attach the dust cup (container) to the
Hand Vacuum.
Warning: Always unplug the unit from
electrical outlet before opening the Dust
Cup (container).
Important: Do NOT use the hand
vacuum without the dust cup filter in
place.
Assembling the Hand Vacuum
1. To open the dust cup (container), push
the dust cup release button and pull
out the dust cup. Verify that the dust
cup filter is inside, then attach the dust
cup (container) to the hand vacuum.
Warning: After each Use - Always
remove and empty the Dust Cup Filter.
1. To open the Dust Cup (container),
push the dust cup release button
and detach the Dust Cup
(container). (Fig. 1)
2. Remove the dust cup filter. (Fig. 2)
Fig. 1
How To Operate Your
Hand Vacuum
Fig. 3
1. Hold the hand vacuum firmly in
your hand by the Handle.
2. Push the On/Off Power Button to
“On” position.
2. To attach the crevice tool or
upholstery brush to the Hand
Vacuum, push desired accessory
into the suction hole, as shown
below.
3. Start vacuuming.
CAUTION: The Hand Vacuum is a
very powerful unit. Make sure that you
hold it firmly, otherwise it can slip out of
your hand and cause injury.
Fig. 4
Fig.2
Fig. 5
CAUTION: The suction hole must be
open, free of any obstructions at all
times. Otherwise, the motor will overheat
and could become damaged.
Please Note: The Dust Cup Filter is
washable. It should, however, be
replaced every three (3) months to
ensure peak performance of your
vacuum.
Important: Make sure that Dust Cup
Filter is completely dry before re-
installing back in the hand vacuum.
3
4
Download from Www.Somanuals.com. All Manuals Search And Download.
|