New Feature for Network Operations (Remote Setup)
6 Motion Sensitivity
Record Settings
(P27)
Allows you to set the motion sensor sensitivity (1 - 9).
The smaller the setting, the higher the sensitivity.
You can use the RECORD settings menu to configure
recording conditions.
7 Sensor Type
Allows you to set the signal polarity of alarm input from an
external sensor.
● Resolution (common to all channels)
Allows you to set the recorded video resolution.
This setting is applied to all the channels.
• ----- :
Ignores alarm input.
• N/O (Normally Open):
Choose this option if the signal line is normally open and
gets closed when an alarm occurs.
• N/C (Normally Closed):
Choose this option if the signal line is normally closed and
gets opened when an alarm occurs.
● Channel-specific Settings
These settings are specific to a particular channel.
8 Pre Record
Allows you to configure the pre-event recording feature.
1
When enabled, this feature always maintains the most recent
five frames while overwriting the previously saved frames; this
means that you can record the immediately preceding five
frames when an alarm event occurs.
2
4
6
8
3
5
7
9
• ON: Enables the pre-event recording feature.
• OFF: Disables the pre-event recording feature.
F
G
H
9 Alarm Duration
Allows you to set the duration of alarm signal output (1 - 60
SECONDS).
I
F Alarm
1 Channel selector (CH1 - CH4)
Allows you to choose whether to output an alarm signal in
response to an alarm event.
2 Frame Rate
• ON: Enables the output of an alarm signal.
Allows you to set the frame rate at which to record the video
(NTSC: OFF/1 - 30f/s, PAL: OFF/1 - 25f/s).
• OFF: Disables the output of an alarm signal.
G Audio
3 Quality
Allows you to enable or disable audio recording.
• ON: Records video with audio.
• OFF: Disables audio recording.
Allows you to choose one of three quality levels: BASIC,
NORMAL, and FINE.
4 Recording
H Post Event Record
Allows you to set the recording mode.
• DISABLE: Disables recording.
Allows you to set the post-event recording time (2 - 30
SECONDS, 1 - 5, 10, 15 MINUTES).
• CONTINUOUS: Continuously records the video as long as
the DVR is on.
I Motion Zone
• BY MOTION:
Selecting this option causes the DVR to record the video
when its built-in motion sensor has detected a motion.
Allows you to set the motion sensor detection zone.
The "PARTIAL ZONE" option requires you to define the
detection zone. (For more information on how to define the
detection zone, see Page 10.)
• BY EXT. SENSOR:
Selecting this option causes the DVR to record the video
when a sensor or similar device connected to the DVR’s
external sensor terminal is activated.
• FULL ZONE: Detects a motion throughout the entire
screen.
• PARTIAL ZONE: Detects a motion within a user-defined
zone (area) only.
• BY SCHEDULE:
Selecting this option causes the DVR to record the video
during the scheduled time window.
5 Timer set
Set the operational schedule for timer recording (BY
SCHEDULE) using the [Schedule] screen. (For more
information on how to define the schedule, see Page 10.)
9
Download from Www.Somanuals.com. All Manuals Search And Download.
