Samsung Computer Monitor TC240 2 8 User Guide

SyncMaster TC190, TC240  
LCD MONITOR  
quick start guide  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Place a soft cloth over the table to protect the product and place the product onto the  
cloth so that the front of the product is facing downwards.  
Do not remove the stopper pin before installing the base.  
Hold the main body of the product with your hand as shown by the figure.  
Insert the stand base into the stand connection part in the direction shown in the figure.  
Turn the connecting screw at the bottom of the stand fully so that it is completely fixed.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
After the installation of the base, stand the monitor up as shown in the figure. Now you  
can remove the stopper pin to adjust the stand.  
- Caution  
Avoid lifting the product holding only the stand.  
Disassembly is in the reverse order of assembly.  
1-3  
Installing a Wall Mount  
Before installation, disassemble the product according to the following steps.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Lift up the monitor stand to the maximum angle with your left hand, and remove the back  
decoration cover with your right hand, as shown in the figure.  
Remove the two screws(A).  
Remove the stand arm in the direction shown in the figure.  
This product provides a wall mount of 100 mm x 100 mm(200 mm x 100 mm) that complies with the VESA specifications.  
100 mm x 100 mm  
200 mm x 100 mm  
A. Wall Mount Base  
B. Wall Mount Kit (Optional)  
1. Turn the product off and unplug the power cord from the wall outlet.  
2. Place a soft cloth or cushion on a flat surface to protect the panel and place the product face down.  
3. Separate the stand.  
4. Align the groove of the Monitor's wall mount base with the groove in the wall mount ki and firmly fix the wall mount kit by  
fastening the screws.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
•If you use a screw that is longer than the standard specifications, the inside of the product may be damaged.  
•For wall mounts that are not compatible with the standard VESA specifications, the length of the screw may differ depending  
on the corresponding specifications.  
•Do not use screws that are incompatible with the standard VESA specifications and do not assemble them using excessive  
force.  
This may result in damage to the product or injury due to the product falling. Samsung shall not be held liable for any damage  
or injury.  
•Samsung shall not be held liable for any damage to the product or injury caused by using a stand that is not compatible with  
the specified specifications or due to an installation not performed by an authorized installation engineer.  
•When installing the product using a wall mount, purchase a wall mount that provides at least 4 inches (10 cm) of space from  
the wall.  
•Samsung shall not be held liable for any problems caused by using a stand that is not compatible with the specified  
specifications.  
•Use a wall mount according to specifications of your country.  
1-4  
Connecting to your Network  
The connecting part may differ depending on the product model.  
Connect between the [LAN] port on the product and your network using a LAN cable.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
1-5  
Connecting Power  
Connect one end of the power cord to the POWER port of the product and connect the other end of the power cord to a 220V or  
110V wall outlet.  
(The input voltage is switched automatically.)  
Download from Www.Somanuals.com. All Manuals Search And Download.  
1-6  
Connecting to another Monitor  
Connect between the [VIDEO OUT] port on the product and the D-Sub port on your monitor using a D-Sub cable.  
Connect to the [VIDEO OUT] port to display the same picture on another monitor.  
(For presentation purposes)  
Download from Www.Somanuals.com. All Manuals Search And Download.  
1-7  
Connecting a SERIAL Cable  
Devices which support RS-232C connection (interface) can be connected.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
1-8  
Connecting to your Printer  
Devices which support D-SUB 25-pin connection (interface) can be connected.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
1-9  
Connecting with a PC  
Connect the [RGB IN] port of the product to the [D-Sub] port of your PC with a D-Sub cable.  
Use the [RGB IN] port to directly connect the monitor to a PC.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
1-10 Connecting a Stereo Cable  
Connect the [AUDIO IN] port on the rear side of the monitor to the sound card of the PC.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
1-11 Connecting USB  
The  
USB port of the monitor supports Full-Speed Certified USB 2.0.  
Connect USB devices such as a mouse, keyboard and external storage devices (DSC (Digital Still Camera), MP3, external  
storage, etc.).  
You can use a USB device such as a mouse, keyboard, Memory Stick, or external hard disk drive by connecting them to the  
USB port of the monitor without connecting them to the PC.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
1-12 Connecting Headphones  
Connect your headphones to the Headphone connection terminal.  
You may connect your headphones to the monitor.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
1-13 Connecting MIC  
Connect the microphone cable to the MIC port on the monitor.  
You may connect your microphone to the monitor.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
1-14 Kensington Lock  
A Kensington Lock is an anti-theft device that enables users to lock the product so that they can safely use it in public locations.  
Since the shape and usage of the locking device may differ depending on the model and the manufacturer, for more information,  
refer to the User Manual supplied with the locking device. You have to purchase an additional locking device.  
Locking the product  
1. Insert the locking part of the locking device into the hole of the Kensington lock of the product (  
direction ( ).  
) and turn it in the locking  
2. Connect the Kensington lock cable.  
3. Tie the Kensington lock cable to a desk or heavy object.  
You can purchase the locking device from an electronics store or an online shop.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
2 Troubleshooting  
2-1  
Monitor Self-Diagnosis  
You can check if the product is working properly using the Self-Diagnosis function.  
If a blank screen is displayed and the Power LED blinks even if the product and the PC are properly connected, perform  
the self-diagnosis function according to the procedures below.  
1. Turn the product and the PC off.  
2. Separate the signal cable from the product.  
3. Turn the product on.  
4. If the product is working properly, the <Check Signal Cable> message appears.  
In this case, if a blank screen is displayed again, make sure that there is no problem with the PC and the connection. The product  
is working properly.  
2-2  
Before Requesting Service  
Please check the following before requesting After-Sales service. If the problem continues, please contact your nearest  
Samsung Electronics Service Center.  
A blank screen appears / I cannot turn the product on  
Is the power cord connected properly?  
Check the connection status of the power cord.  
Is the <Check Signal Cable> message displayed on the  
screen?  
Check the cable connecting the PC and the product.  
If the message appears on the screen even if the cable is  
properly connected, recheck the input signal by pressing the  
/SOURCE button of the product.  
Is the <Not Optimum Mode> message displayed on the  
screen?  
This occurs when the signal from the graphics card exceeds  
the maximum resolution or the maximum frequency of the  
product.  
In this case, set up the appropriate resolution and the fre-  
quency for the product.  
Is a blank screen displayed and does the power LED blink at  
a 1 second interval?  
This occurs when the power saving function is running.  
If you click the mouse or press any key, the screen will be  
turned on.  
The on screen adjustment menu (OSD) does not appear.  
Did you cancel the screen adjustment?  
Check if the <OSD Adjustment Lock> function is set to Off.  
The color is weird / The picture is displayed in black and white  
Is the entire screen displayed in the same color as if viewing  
the screen through a cellophane paper?  
Check the cable connection to the computer.  
Reinsert the graphics card into the computer completely.  
Check if the <Color Effect> is set to <Off>.  
Is the graphics card configured correctly?  
Set up the graphics card referring to the user manual.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
The display area suddenly moves to an edge or to the center.  
Did you change the graphics card or the driver? Please press the [AUTO] button to run the auto adjustment  
function.  
Did you change the resolution and frequency appropriate to  
the product?  
Set the resolution and the frequency to the appropriate values  
in the graphics card  
Refer to the (Standard Signal Mode Table)  
Is the graphics card configured correctly?  
Set up the graphics card referring to the user manual.  
The pictures are out-of-focus.  
Did you change the resolution and the frequency appropriate  
to the product?  
Set the resolution and the frequency to the appropriate values  
in the graphics card  
Refer to the (Standard Signal Mode Table)  
The color is displayed in 16 bit (16 colors). The color has been changed after changing the graphics card.  
Did you install the device driver for the product?  
Windows ME/XP/2000 : Set the color again by selecting Con-  
trol Panel Display Settings.  
Is the graphics card configured correctly?  
Configure the color again in accordance with the new graph-  
ics card driver.  
When I connect the monitor, the 'Unknown monitor, Plug&Play (VESA DDC) monitor found' message is displayed.  
Did you install the device driver for the product?  
Install the device driver referring to the descriptions about the  
driver installation.  
Check if all the Plug&Play (VESA DDC) functions are sup-  
ported referring to the User Manual of the graphics card.  
Install the device driver referring to the descriptions about the  
driver installation.  
A “beep, beep” sound is heard when booting the computer.  
If the beep sound is generated 3 or more times when booting up the computer, please request service for the computer.  
Problems related to Audio  
No sound  
Ensure that the audio cable is firmly connected to both the  
audio-in port on your monitor and the audio-out port on your  
sound card.  
Check the volume level.  
Check the volume level.  
Sound level is too low.  
If the volume is still too low after turning the control to its max-  
imum, check the volume control on the computer sound card  
or software program.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
2-3  
FAQ  
FAQ!  
Please try the following!  
How can I change the frequency of the video signal?  
You have to change the frequency of the graphics card.  
(For more information, refer to the User Manual of the com-  
puter or the graphics card.)  
How can I change the resolution?  
Windows XP : Change the resolution by selecting Control  
Panel Appearance and Themes Display Settings.  
Windows ME/2000 : Change the resolution by selecting Con-  
trol Panel Display Settings.  
(For more information, refer to the User Manual of the com-  
puter or the graphics card.)  
How can I use the power saving function?  
Windows XP : Configure it by selecting Control Panel →  
Appearance and Themes Display Screen Saver Set-  
ting or configure it in the BIOS Setup of the computer.  
Windows ME/2000 : Configure it by selecting Control Panel  
Display Screen Saver Setting or Configure it in the  
BIOS Setup of the computer.  
For more information, refer to the Windows user manual for  
the computer.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

RCA DVD Player RTD615i User Guide
Rinnai Water Heater RV53E User Guide
Rival Griddle GR201 User Guide
Roberts Radio CD Player CD965 User Guide
Robic Outdoor Timer SC 606 User Guide
Rosen Entertainment Systems GPS Receiver DP 1001 User Guide
Rotel Stereo System RT 950BX User Guide
Samsung Digital Camera Digimax A4 User Guide
Samsung Satellite TV System DSB A100F User Guide
Satco Products Indoor Furnishings Fluorescent Ballasts User Guide