Ultra mobile SATA
Spinpoint N1C
Capacity
Model
80GB
120GB
HS08XJF
HS122JF
FEATURES
• MAX.60GB Formatted Capacity Per Disk
• SATA S.M.A.R.T Compliant
• SATA 48-bit Address Feature Set
• Multi-Burst On-The-Fly Error Correction
• SilentSeek™
• High Speed Digital Signal Processor Based Architecture
• Low Power HDC
• Advanced Power Management Control
• Fluid Dynamic Bearing Spindle Motor Technology
• Free Fall Sensor (optional)
DRIVE CONFIGURATION
ENVIRONMENTAL SPECIFICATIONS
Temperature
Capacity
80 / 120 GB
SATA 1.5Gbps
5400 RPM class
8 MB
Interface
Operating
5 ~ 60 ℃
Rotational Speed
Buffer DRAM Size
Byte per Sector
Non-operating
-40 ~ 85 ℃
Humidity (non-condensing)
Operating
512
8 ~ 90 ％
Non-operating
8 ~ 90 ％
PERFORMANCE SPECIFICATION
Average Seek time (typical)
Media Transfer Rate (Max.)
Interface Transfer Rate (Max.)
Drive Ready Time (typical)
Linear Shock (1/2 sine pulse)
Operating, 2ms
14.0 ms
550 Mb/s
1.5 Gbps
4.0 sec
600 G
Non-operating, 1ms
Vibration
1500 G
Operating
0.67 Grms
Altitude (relative to sea level)
Operating
RELIABILITY SPECIFICATION
Non-recoverable Read Error
Controlled Ramp Load/Unload
-300 to 3.000 m
-400 to 15,000 m
1 sector in 10^13 bits
600,000
Non-operating
PHYSICAL DIMENSION
Height
ACOUSTICS
Idle
8.0 mm
78.5 mm
54.0 mm
62 g
2.4 Bel
2.6 Bel
Width
Performance Seek
Length
Weight (Max.)
POWER REQUIREMENTS
Voltage
+3.3V ±5%
540 mA
1.30 W
Spin-up Current (Max.)
Seek (typical)
* Note : Design and specifications are subject to change without prior notice.
1MB = 1,000,000 Bytes, 1GB = 1,000,000,000 Bytes
Read/Write (typical)
Idle (typical)
1.60 W
0.40 W
* Accessible capacity may vary as some OS uses binary numbering system for
reported capacity.
Standby (typical)
Sleep (typical)
0.12 W
0.10 W
* A small portion of the (8MB) buffer memory is reserved for firmware use.
1.8" N1C SATA product specification Rev.08
Match with 1.8" N1C SATA product manual Rev.07
Download from Www.Somanuals.com. All Manuals Search And Download.
|