Multimedia Navigation System
GM Series Quick Start Guide
In-Dash Multi-Media /
Navigation System
System Features:
• Navigation
• Bluetooth Hands-Free
• iPod™ and MP3 compatible
• Back-up camera and/or sensor ready
• Play DVDs, Audio CDs, MP3 Discs
• Supports steering wheel controls
• Built-in MP3 Recorder
Download from Www.Somanuals.com. All Manuals Search And Download.
• Satellite Radio ready
Basic Functions
Turning The System On/Off
Vehicle ignition must be On or in ACC Mode to
operate system.
Press the Left Knob on the panel to turn the
system ON/OFF
When the vehicle is turned off, the unit will
automatically turn off.
ON/OFF
Screen Organization
Your system will automatically default to the last screen you were on prior to turning off the unit.
The Information Bar is located at the
top of the screen. Depending on the
source, it will provide information or content
sensitive controls
This will take you to the Settings
Menu for advanced control settings.
The Source Tabs located at the bottom of
the screen will give you direct access to
common sources
Note: “PHONE” is highlighted BLUE when a phone is paired to Rosen Bluetooth
Download from Www.Somanuals.com. All Manuals Search And Download.
2
Radio
Touch Button Descriptions
Short touch to seek previous and
next available stations.
Long touch to scan. Each station
will play for several seconds.
Touch to select AM and FM1,2 & 3 preset
screens.
Satellite Radio (If Equipped)
Short touch to seek previous and
next available stations.
Touch to select SAT 1,2 & 3 preset
screens
Preset Channels
To set a station as a Preset, press and hold the
button. The name of the channel for SAT Radio
or station frequency for AM/FM Radio will
appear in the button when saved.
Short touch the desired Preset button to select
that channel
Download from Www.Somanuals.com. All Manuals Search And Download.
3
iPod Audio
When the optional iPod interface is connected to a compatible iPod player, the audio files stored
on the iPod can be played through the system.
Note: Sleep mode should be enabled on the iPod to reduce battery drain if the iPod is left
connected with the vehicle off.
Touch Button Descriptions
Show/hide the key pad
Repeat the current played song
Scan and play songs in the
current folder. The next song will
be played after the current song
has played for several seconds.
Play songs in the current folder
in random order.
Touch to enter category list. The
system categorizes into 6 options
Press once to display song
information.
Press twice to display spectrum
graphics.
Play A Song
Touch the song shown on playlist to play.
Select previous song
Select next song
Page up
Page down
Play/Pause
Download from Www.Somanuals.com. All Manuals Search And Download.
4
CD/DVD
CD/DVD
Play/Pause track
Stop track
Play previous song/chapter
Play next song/chapter
Repeat current song played
CD Only
Change audio EQ setting
Change spectrum display
Play songs on disc in random order
Scan songs for several seconds
Copy song to Favorites folder
DVD Only
Long Touch in DVD mode to show the DVD
control screen. To return to full screen,
either touch the image or let the screen idle
for 10 seconds
Set up DVD
Change language
Show current title info
Main DVD menu
Shows information such as Chapter,
Time Elapsed, etc
Download from Www.Somanuals.com. All Manuals Search And Download.
5
Bluetooth Hands-Free
Note: This system requires a Bluetooth enabled phone. Bluetooth phones and software vary by
brand and date of manufacture. Some phones or phone functions may not be compatible or may
operate differently with this system during use. Phone compatibility problems are not warrantable
issues.
There are several different Bluetooth screens in
the PHONE function. The first screen you will see
is the Call Screen. To switch between screens,
press the PHONE tab repeatedly.
Pairing Your Phone
Place your phone into discovery mode.
Press the PHONE tab to open the
Bluetooth set-up page
Press “Pair” to pair your cell phone for
the first time. You will only need
to do this once, unless you connect to a
different cell phone or the connection is
deleted.
“Pairing” will be displayed on the screen. After
the connection succeeds on your phone, select
“Rosen” and enter the password (1234). The sys-
tem will indicate “Linking” and then “Connected.”
When your phone is connected its name will be
displayed on the unit.
Select Auto Connect If you desire the
system’s Bluetooth feature to automati
cally detect your cell phone when the
system is turned on.
Select Auto Answer to set the system to
automatically pick up after three rings.
Note: If using factory Bluetooth, please refer to your vehicle’s owner’s manual.
Download from Www.Somanuals.com. All Manuals Search And Download.
6
Making/Ending A Call
You can dial the number from your
phone or use the touch-screen shown at
the right by entering the number, then press
the Call button.
Clear last number
Press to redial the last number dialed with
the touch screen.
Press to transfer call between cell phone
and car speakers
Press to end the call.
Answer An Incoming Call
For incoming calls, the system will
automatically switch to the answer screen.
Press to answer.
Press the icon to refuse or end the call
Press to transfer call between cell phone
and car speakers.
Note: While in Navigation mode the incoming call box will disappear. Touch the screen to
show the incoming call box
Call List
The call list can be used to view missed,
received and made calls.
The system will not display your cell phone’s
internal phonebook but will show the last
numbers missed, received or made. Press the
appropriate button on the screen to view the
numbers To make a call from the list, touch the
number on the screen and it will automatically dial
the number.
Note: If unit is equipped with the Phonebook option, this will display instead of “Call List”.
Download from Www.Somanuals.com. All Manuals Search And Download.
7
Settings
Press to enter the Settings Menu. To
change system settings, select desired
option.
System Settings
The time displayed on all screens
Turn the backup camera On/Off
Settings Menu Screen
Allows the Nav screen to display for a short
time when directions are given
Button beep On/Off.
Spectrum On/Off
Display the microphone level. Press to
switch between “Low, Med, High”
Guidepoint
Settings Screen
Phone Reminder On/Off
(If using Rosen Bluetooth)
Audio Settings
The AUDIO screen will allow you to adjust
audio settings such as Treble, Mid Range,
Bass and 5.1 Channel.
Press to reset back to original audio
settings
Audio Screen
Display Settings
Change the brightness, color and contrast of the
display.
Press to increase the value
Press to decrease the value
Press to reset back to original display
settings
Display Screen
Download from Www.Somanuals.com. All Manuals Search And Download.
8
Navigation
Understanding the Map
The top part of the screen shows
you what the next street is and which
direction to turn on your route
Select the Quick
Menu to access the
most used functions
These displays show
you the distance, time
left and the estimated
arrival time of your trip
Shows you the street
you are currently on
Access the Navigation Menu
Find an address or Point of Interest and
access the Favorites and History menu
Displays the route details and allows
you to edit, change or cancel existing
route
Displays current position, surrounding
map area and route.
Customize the navigation software
Download from Www.Somanuals.com. All Manuals Search And Download.
9
Quick Menu
Located in the top right corner of the
map screen is the Quick Menu. In
this screen, there is a selection of
functions that are frequently needed
during navigation.
You can use this option to search for
places of interest along the way of
your route, such as: Gas Stations,
Restaurants, Parking, etc.
Modifying Existing Routes
You can modify an existing route by accessing either the Quick Menu or Main Navigation
menu
You can use this option to se-
lect an alternative route to your
destination.
This option is a good way to
change road types and modes.
You can avoid highways, allow
toll roads, etc.
Download from Www.Somanuals.com. All Manuals Search And Download.
10
Enter or Find Address
If you are on the Map screen, press MENU. In the Navigation Menu, select Find Address.
Note: By default, the software proposes the country and state where you are currently
located.
1. Touch “City Name” and the key-
board screen will appear.
2. Your current city will automatically
default. To search for a different city,
start typing each letter of the City
name
Tap to confirm city
3. A “Select City” screen will appear.
This will show a list of cities that
match your selection. Touch the city
you desire.
4. Select “Street” and the keyboard
screen will appear.
Download from Www.Somanuals.com. All Manuals Search And Download.
11
5. Start typing each letter of the street
name.
6. A Street Name list will appear. Se-
lect the one you are looking for.
7. Repeat these steps for House number,
or if you do not know it, you can select the
SELECT STREET option.
8. A map will appear.
Click Next and a short
summary of the route will flash on the
screen for a few seconds.
9. After the summary, the map ap-
pears showing the entire route.
Tap to start your journey.
Download from Www.Somanuals.com. All Manuals Search And Download.
12
Rosen Navigation Information
Safety Information and Precautions
WARNING! Please read and follow the following safety precautions.
Failure to follow the instructions below may increase
your risk of collision and personal injury.
The Rosen Navigation software is not a substitute for your personal judgment. The route suggestions should never supersede
any local traffic regulation or your personal judgment and /or knowledge of safe driving practices. Prior to completing any ma-
neuvers suggested by your Rosen Navigation software (for example, a U-turn or a left turn), verify that you can legally and safely
complete the maneuver. Do not follow route suggestions if they direct you to perform an unsafe or illegal maneuver, would place
you in an unsafe situation, or would route you into an area that you consider unsafe.
Do not use the Rosen Navigation software to locate emergency services (such as police, fire stations, hospitals, and clinics).
The database may not include all emergency service providers. Use your own best judgment and ask for directions in these
situations.
If the vehicle is in motion, only a passenger should program the Rosen Navigation software. The driver should not program the
system unless the vehicle is parked in a safe location.
The Rosen Navigation software’s map database provides information on suggested routes without regard to factors that may
affect your driving experience or the time required to arrive at your destination. For example, the system does not reflect road de-
tours, closures or construction, some road characteristics (e.g., road surface, slope or grade, weight or height restrictions, etc.),
temporary traffic congestion, weather conditions, and similar factors.
Vehicle Position
The Rosen Navigation software’s computer considers vehicle speed and heading changes, together with longitude and latitude
information, to accurately determine vehicle heading and position on a digital map.
Map and Information Database
The map database used by your Rosen Navigation software was created using high-resolution aerial and land based data col-
lection.
Car navigation maps are frequently updated. While the database was judged to be as accurate as possible at the time of its
release, a map database can never be 100% accurate. Road information that is maintained in the map databases, such as turn
restrictions or road names may change over time.
Errors or missing information in the map data are not covered by the Product Warranty. New and/or updates for the map data
are the responsibility of the End-user.
End-User License Agreement
Please refer to the Rosen Navigation User’s Manual to review and accept the terms and conditions in the End-User License
before operating this product.
Download from Www.Somanuals.com. All Manuals Search And Download.
All rights reserved. Copyright 2011
DP-GM1011 Rev D
|