SAFETy PrEcAUTiONS
SySTEM cONNEcTiONS
LOcATiON OF cONTrOLS
USEr MANUAL
On Use
Speaker connections
Front View
1
rear View
Never use the unit where it would be subject to:
Heat sources such as radiators or air ducts.
Connect one speaker to the R terminal and the other speaker to the L terminal.
Note: Connecting speakers other than the speakers supplied with the unit may damage
the unit.
-
-
-
-
-
-
rS2128iH
10
Direct sunlight.
Excessive dust.
Moisture or rain.
11
12
13
14
19
15
20
16
2
3
4
5
6
Mechanical vibration or shock.
SPEAKEr
bOX
SPEAKEr
bOX
Uneven surface.
• Do not place any heavy objects on top of the unit.
• when the unit is used with an AC power adapter, do not wrap the unit in a cloth, blanket, etc.
If you do so, the temperature inside and outside the unit may rise considerably, resulting in
malfunctioning of the unit.
• If the unit is brought directly from a cold to a warm location, or is placed in a very damp room,
the moisture may condense on the lens inside the unit. Should this occur, the unit will not
operate. In this case, remove the disc and leave the unit in a warm place for several hours
until the moisture evaporates.
17
7
8
21
18
To Ac
outlet
• For the unit to operate at its best, it should not be subject to temperatures below 41°F (5°C)
or above 95°F (35°C).
9
Additional safety information
To “Dc iN 13.5V” jack
•
Apparatus shall not be exposed to dripping or splashing and no objects filled with liquids,
such as vases, shall be placed on the apparatus.
Ac adapter
•
Always leave sufficient space around the product for ventilation. Do not place product in or
on a bed, rug, in a bookcase or cabinet that may prevent air flow through vent openings.
Do not place lighted candles, cigarettes, cigars, etc. on the product.
Connect power plug only to AC power source as marked on the product.
Care should be taken so that objects do not fall into the product.
Using the Ac Adapter
1.
2.
3.
4.
5.
6.
cD Door
Display
MEM.UP /
FUNcTiON button
STANDby/ON button
11. Standby indicator
12. TiMEr indicator
13. remote control Sensor
•
•
•
•
Using an AC adapter other than the one supplied with the unit may damage the unit.
cAUTiONS:
•
•
button
Before use, ensure the rated voltage of the adapter matches your local voltage.
The included AC adapter is for use with this unit only. Do not use it with other
equipment.
If you are not going to use the unit for a long time, disconnect the AC adapter from the
wall outlet.
Do not attempt to disassemble the cabinet. This product does not contain customer
14.
15.
PLAy/PAUSE button
STOP button
It’s important to read this instruction prior to using your new product for the
first time.
serviceable components.
Precautions
Earphone Jack
16. LiNE iN Jack
•
•
•
This compact disc player uses a laser to read the music on the disc. The laser mechanism
corresponds to the cartridge and stylus of a record player. Although this product incorporates
a laser pick-up lens, it is completely safe when operated according to directions.
Discs rotate at high speed inside the player. Do not use damaged, warped, or cracked discs.
Do not touch the pick-up lens which is located inside the disc compartment. To keep dust
from collecting on the pick-up lens, do not leave the compartment door open for an extended
period of time. If the lens becomes dirty, clean it with a soft brush, or use an air blower brush
designed for camera lenses.
17. VOL + button
18. VOL - button
19. right & Left Speaker Terminals
20. Dc iN 13.5V Jack
21. FM Antenna
7.
8.
PrOG / MEM /
TUNiNG + /
TUNiNG - /
iPod Dock
button
button
button
SAFETy PrEcAUTiONS
whenever the AC adapter is plugged in to a wall outlet, electricity is running through
the unit, even when the power switch is turned off.
•
•
WArNiNGS:
9.
FM ANTENNA
•
•
•
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THE UNIT TO RAIN OR
MOISTURE.
TO AVOID ELECTRICAL SHOCK, DO NOT OPEN THE CABINET. REFER SERVICING TO
QUALIFIED PERSONNEL ONLY.
THE APPARATUS SHALL NOT BE EXPOSED TO DRIPPING OR SPLASHING AND THAT
NO OBjECTS FILLED wITH LIQUID, SUCH AS VASES, SHALL BE PLACED ON THE
APPARATUS.
10. OPEN Knob
Do not connect the FM antenna to an outside antenna.
VOLUME ADJUSTMENT
rEMOTE cONTrOL
Headset safety
•
Have a Blast-just Not in your eardrums! Make sure you turn down the volume on the
unit before you put on headphones. Increase the volume to the desired level only after
headphone are in place.
To Adjust the Volume
1.
EQ / TiMEr button
1
Adjust the VOLUME levels to obtain the desired volume.
2.
3.
4.
5.
6.
ON/OFF button
•
Do not play your headset at high volume. Hearing experts warn against extended high-
volume play.
DO NOT TOUCH THE LENS
CAUTION: INVISIBLE LASER
RADIATION wHEN OPEN AND
INTERLOCKS DEFEATED
rANDOM button
Note: Press the
on the display. Press the
resume the voice.
MUTE button to turn off the sound and the volume numbers will blink
9
10
11
2
3
4
5
6
TUNiNG - /
MEM.UP /
button
button
MUTE button again or press the VOLUME +/- buttons to
•
•
If you experience ringing in your ears, reduce volume or discontinue use.
You should use with extreme caution or temporarily discontinue use in potentially hazardous
situations. Even if your headset is an open-air designed to let you to hear outside sounds, do
not turn up the volume so high that you are unable to hear what is around you.
Excessive sound pressure from earphones and headphone can cause hearing loss.
MENU button
AVOID EXPOSURE TO BEAM
For Personal Listening
7.
MUTE button
VOLUME + / - buttons
FUNcTiON button
button
12
Connect headphones (Ø3.5mm stereo mini plug) to the
VOLUME levels to obtain the desired volume.
earphone jack. Adjust the
•
8.
Double insulation when servicing use only
This product contains a low
identical replacement parts.
power laser device.
13
14
15
16
17
9.
10.
When headphones are connected, the speakers are automatically muted.
Warning: Excessive sound pressure from earphone and headphones can cause hearing
Fcc information
iMPOrTANT SAFETy iNSTrUcTiONS
11. SLEEP button
12. TUNiNG + /
13. SELEcT button
loss.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
NOTE:ThisequipmenthasbeentestedandfoundtocomplywiththelimitsforaClassBdigitaldevice,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
causeharmfulinterferencetoradiocommunications.However,thereisnoguaranteethatinterference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
button
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
7
8
14.
15.
16.
STOP button
button
PLAy / PAUSE button
cLOcK SETTiNG
Setting the clock can only be done in STANDBY mode.
•
If the unit is plugged in with the supplied AC adapter and the unit is in standby mode,
17. PrOG / MEM /
button
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacturer’s
instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized
plug has two blades with one wider than the other. A grounding type plug has two
blades and a third grounding prong. The wide blade or the third prong are provided for
your safety. If the provided plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
10. Protectthepowerplugfrombeingwalkedonorpinchedparticularlyatplugs,convenience
receptacles, and the point where they exit from the apparatus.
11. Only use attachments/accessories specified by the manufacturer.
12. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer,
or sold with the apparatus. When a cart is used, use caution when moving the cart/
apparatus combination to avoid injury from tip-over.
the standby indicator illuminates.
Using the remote control correctly
1. Press and hold the PrOG/MEM/
blink.
button until the hour digits
•
•
Point the remote control at the REMOTE SENSOR located on the unit.
when there is a strong ambient light source, the performance of the infrared REMOTE
SENSOR may be degraded, causing unreliable operation.
•
•
•
Reorient or relocate the receiving antenna.
•
The recommended effective distance for remote operation is about 19 feet (6 meters).
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
WArNiNG: Changes or modifications to this unit not expressly approved by the party responsible
2. Tap the
or
button to adjust the desired hours then tap the
button once to confirm. The minute digits will begin
To change battery
PrOG/MEM/
to blink.
•
ATTENTiON
1. Open the battery door.
Remove the plastic sheet
before operating the remote
control.
for compliance could void the user’s authority to operate the equipment.
3. Tap the
or
button to adjust the desired minutes then tap the
button once to start clock.
For customers in canada
PrOG/MEM/
This apparatus complies with the Class B limits for radio noise emission set out in radio interference
regulations.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
2. Insert one CR2025 (3V) size battery.
12:00 PM = NOON time, and “PM” appears.
Warnings:
•
The AC adaptor is used as disconnect device and it should remain readily operable during
intended used. In order to disconnect the apparatus from the mains completely, the AC adaptor
should be disconnected from the mains socket outlet completely.
•
The AC adaptor of apparatus should not be obstructed OR should be easily accessed during
intended use.
Minimum 10 cm (4 inches) distances around the apparatus for sufficient ventilations.
The ventilation should not be impeded by covering the ventilation openings with items such as
newspaper, table-cloths, curtains, etc.
Note:
•
In iPod/AUX mode, the current time is always shown on the display.
•
•
Portable Cart Warning
•
No naked flame sources such as lighted candles should be placed on the apparatus.
battery replacement
13. Unplug this apparatus during lightening storms or when unused for a long period of
time.
14. Referallservicingtoqualifiedservicepersonnel.Servicingisrequiredwhentheapparatus
has been damaged in any way, such as the power-supply cord or plug is damaged,
liquid has spilled or objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has been dropped.
LiSTENiNG TO THE rADiO
On Safety
When the battery becomes weak, the operating distance of the remote control is greatly
reduced and you will need to replace it.
As the laser beam used in this compact disc player could be harmful to the eyes, do not attempt
to disassemble the casing. Refer servicing to qualified personnel only.
1. Press the
2. Press the FUNcTiON button to switch to TUNEr mode.
3. Press the or button to tune in to a station.
button to turn the unit on.
Note: If the remote control is not going to be used for a long time, remove the battery to
avoid damage caused by battery leakage corrosion.
•
Do not put any foreign objects in the disc compartment. If you do so, the laser beam interlock
may be defeated allowing the laser to remain on when the lid is opened.
Should any objects or liquids fall into the unit, disconnect the power supply and have the unit
WArNiNGS:
•
4. Adjust the volume levels.
•
•
•
Do not dispose of battery in fire; battery may explode or leak.
Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
checked by qualified personnel before any further operation.
Searching for a Station Automatically
On Operation
•
Press and hold the
or
button until the tuner starts searching for a station, then
Since the CD system offers a wide dynamic range, the peaks of the high level inputs are recorded
with high fidelity, and the noise level is very low. Do not turn up the volume while listening to a part of
the disc with no audio signals or very low level inputs. If you do so, the speakers may be damaged
when the peak level of the sound is played. The lens of the laser should be kept clean. Do not touch
the lens. If you do so, the lens may be damaged and the unit will not operate correctly.
release. After tuning in a station, the search stops.
cAUTiON: When discarding batteries, environmental problems must be considered and
local rules or laws governing the disposal of these batteries must be strictly followed.
•
The search may not stop at a station with a very weak signal.
- 1 -
- 2 -
- 3 -
- 4 -
Download from Www.Somanuals.com. All Manuals Search And Download.
|