OWNER’S MANUAL
CEILING SERIES
C500 • C600TT • C610 • C620
C640 • C790 • C800
SPEAKER PLACEMENT
Before installing your speakers, you should consider their
Note: To avoid possible damage to the pivoting tweeters, read
the section entitled “SPEAKER ADJUSTMENTS” in this manual
prior to performing the tweeter adjustment.
placement carefully, taking into account the location of
electrical, plumbing and other fixtures. Contact your Dealer
for assistance if you are unsure of the best location for your
particular listening environment.
In a very large room with high ceilings, it may be necessary to
place additional speakers throughout the room. Contact your
Proficient Audio Systems Dealer for assistance.
Placement In Ceiling: When placing your speakers into the
ceiling, they should ideally be located above the primary
listening area. If the speakers are positioned far away from
the primary listening area, adjust the pivoting tweeters so they
are pointed towards it.
MOUNTING SURFACE PREPARATION
New Construction - Unfinished Ceilings
3. Mark the hole. A template for setting the hole is provided
in the box (along with two paint mask inserts for use when
painting). Position the template in the desired position and
pencil an outline on the ceiling.
A Pre-Construction Bracket, available from your Dealer, may
be installed prior to drywall application across joists (up to 24"
on-center) where a speaker will be located. After the hole is
cut and the drywall is installed, the speakers are then easily
installed following the instructions for mounting in “Finished
Ceilings” below. Note: If the speakers are to be mounted more
than 24" on-center, a special “Extra Long Wing” is available
from your Dealer.
4. Cutting the hole. CAUTION:This is the most important
part of the entire installation. If you are not certain
whether any obstructions exist behind the desired mounting
area, you should start by cutting a small hole in the center
of your penciled mounting hole with a drywall saw, cutting
at a 45° angle towards the inside of the hole. (See Diagram 1)
Cutting the small hole at this angle will make drywall repair
much easier, using the piece cut out. Once you have deter-
mined that there aren’t any obstructions in your desired
mounting location, start cutting the finished hole at a 90°
angle to the ceiling surface.
Finished Ceilings
Prior to the actual installation of the speakers, it will be neces-
sary to run cables to the speaker locations. See your Dealer
for more information about cable installation. After the cable
has been properly installed, you are ready to mount the
speakers. Following the simple steps listed below will result in
a professional looking installation:
1. Determine the best area to mount your speakers. This area
of the ceiling should be free of obstructions such as electri-
cal conduit, HVAC ducts, or water lines. This can best be
determined by noting the placement of fixtures and gaining
access to an attic or crawl space for further analysis of the
location of such obstacles.
Diagram 1:
Ceiling Cut Out
2. Find the joists nearest the desired speaker mounting loca-
tion. We highly recommend using a good stud-finder tool
for this procedure. If you are lining up the speakers to some
other object or molding in the room, make sure you con-
sider the size of the baffle flange which extends beyond the
mounting hole.
5. Add insulation. If the area in the ceiling is not already insu-
lated, add an adequate amount insulation material to loosely
cover the back of the speaker. If the insulation material used
is faced with foil or paper, position the foil or paper away
from the speaker.
Download from Www.Somanuals.com. All Manuals Search And Download.
SPEAKER SPECIFICATIONS
C500
C600TT
Speaker Type:
Tweeter:
2-Way Coaxial In-Ceiling
2-Way Coaxial In-Ceiling
Two 1⁄2" Polyamide Dome
Pivoting 1⁄2" Polyamide Dome
Woofer:
51⁄4" Polypropylene Cone
with Rubber Surround
61⁄2" Injection Molded Polypropylene
Cone with Dual Voice Coil and
Rubber Surround
Impedance:
8Ω
8Ω
Sensitivity:
90dB 1W/1m
None
92dB 1W/1m
Frequency Adjustments:
Frequency Response:
None
40Hz - 20kHz
36Hz - 20kHz
5 - 100 watts (undistorted)
Power Recommendations: 5 - 75 watts (undistorted)
Diameter x Depth:
Ceiling Cut Out:
73⁄4" x 31⁄4
"
91⁄4" x 35⁄8
81⁄4
"
611⁄16"
"
C610
C620
C640
Speaker Type:
Tweeter:
2-Way Coaxial In-Ceiling
Pivoting 1" Soft Dome
2-Way Coaxial In-Ceiling
Pivoting 1" Silk Dome
2-Way Coaxial In-Ceiling
Pivoting 1" Aluminum Dome
Woofer:
61⁄2" Polypropylene Cone
with Rubber Surround
61⁄2" Polypropylene Cone
with Rubber Surround
61⁄2" Injection Molded Graphite
Cone with Rubber Surround
Impedance:
8Ω
8Ω
8Ω
Sensitivity:
91dB 1W/1m
None
91dB 1W/1m
None
92dB 1W/1m
Frequency Adjustments:
Front-Mounted 2 Position
+3dB Treble Adjustment Switch
& +3dB Bass Adjustment Switch
Frequency Response:
40Hz - 20kHz
36Hz - 20kHz
32Hz - 22kHz
Power Recommendations: 5 - 85 watts (undistorted)
5 - 100 watts (undistorted)
5 - 125 watts (undistorted)
Diameter x Depth:
Ceiling Cut Out:
91⁄4" x 35⁄8
"
91⁄4" x 35⁄8
81⁄4
"
91⁄4" x 35⁄8
81⁄4
"
81⁄4
"
"
"
C790
C800
Speaker Type:
Tweeter:
2-Way Coaxial In-Ceiling
Pivoting 1" Silk Dome
2-Way Coaxial In-Ceiling
Pivoting 1” Aluminum Dome
Woofer:
8" Polypropylene Cone
with Rubber Surround
8" Injection Molded Graphite
Cone with Rubber Surround
Impedance:
8Ω
8Ω
Sensitivity:
92dB 1W/1m
None
92dB 1W/1m
Frequency Adjustments:
Front-Mounted 2 Position
+3dB Treble Adjustment Switch
& +3dB Bass Adjustment Switch
Frequency Response:
36Hz - 20kHz
28Hz - 22kHz
Power Recommendations: 5 - 125 watts (undistorted)
5 - 150 watts (undistorted)
Diameter x Depth:
Ceiling Cut Out:
111⁄8" x 41⁄4
"
111⁄8" x 41⁄4
"
97⁄8
"
97⁄8
"
(Features and specifications are subject to change without notice.)
3
Download from Www.Somanuals.com. All Manuals Search And Download.
LIMITED TEN-YEAR WARRANTY
Proficient Audio Systems warrants to the original retail pur-
chaser only that this product will be free from defects in
This Warranty does not include service or parts to repair dam-
age caused by accident, disaster, misuse, abuse, negligence,
materials and workmanship for a period of ten years, provided inadequate packing or shipping procedures, commercial use,
the speaker was purchased from a Proficient Audio Systems
Authorized Dealer.
voltage inputs in excess of the rated maximum of the unit, or
service, repair or modification of the product which has not
been authorized or approved by Proficient Audio Systems. This
Warranty also excludes normal cosmetic deterioration caused
by environmental conditions. This warranty will be void if the
Serial Number on the product has been removed, tampered
with or defaced.
Defective products must be shipped, prepaid and insured,
together with proof of purchase, to the Proficient Audio
Systems Authorized Dealer from whom they were purchased,
or to Proficient Audio Systems at the address listed on this
installation instruction manual. Freight collect shipments will
be refused. It is preferable to ship this product in the original
shipping container to lessen the chance of transit damage. In
any case, the risk of loss or damage in transit is to be borne
by the purchaser.
This Warranty is in lieu of all other expressed warranties. If the
product is defective in materials or workmanship as warranted
above, the purchaser’s sole remedy shall be repair or replace-
ment as provided above. In no event will Proficient Audio
Systems be liable for any incidental or consequential dam-
ages arising out of the use or inability to use the product, even
if Proficient Audio Systems. or a Proficient Audio Systems
Authorized Dealer has been advised of the possibility of such
damages, or for any claim by any other party. Some states do
not allow the exclusion or limitation of consequential damages,
so the above limitation and exclusion may not apply.
If, upon examination at the Factory or Proficient Audio
Systems Authorized Dealer, it is determined that the unit was
defective in materials or workmanship at any time during this
warranty period, Proficient Audio Systems or the Proficient
Audio Systems Authorized Dealer will, at its option, repair or
replace this product at no additional charge, except as set
forth below. If this model is no longer available and can not
be repaired effectively, Proficient Audio Systems, at its sole
option, may replace the unit with a current model of equal or
greater value. In some cases where a new model is substi-
tuted, a modification to the mounting surface may be required.
If mounting surface modification is required, Proficient Audio
Systems assumes no responsibility or liability for such modifi-
cation. All replaced parts and product become the property of
Proficient Audio Systems. Products replaced or repaired under
this Warranty will be returned to the original retail purchaser,
within a reasonable time, freight prepaid.
All implied warranties on the product are limited to the duration
of this expressed Warranty. Some states do not allow limitation
on the length of an implied warranty. If the original retail pur-
chaser resides in such a state, this limitation does not apply.
Should you have any questions regarding this, or any other Proficient Audio Systems product, please call our service hotline at
(909) 787-9940. We are available to assist you every weekday, except holidays, between the hours of 7:00 a.m. and 5:00 p.m. PST.
940 Columbia Avenue • Riverside, CA 92507 • 909.787.9940
1301-11000(rev1)
4
Download from Www.Somanuals.com. All Manuals Search And Download.
|