SKR-L500.fm Page 1 Tuesday, October 4, 2005 2:15 PM
Contents
Speaker System
Getting Started
SKR-L500
Package Contents........................... 2
Placement........................................ 2
Installing & Using
Instruction Manual
Using Cork Spacers with the
Speaker......................................... 2
Wall Mounting.................................. 2
Connecting the Speakers............... 3
Using Speaker Mounts/Brackets ... 3
Thank you for purchasing an Onkyo speaker system.
Please read this manual thoroughly before using your
new speakers. Following the instructions in this
manual will enable you to obtain optimum
performance and listening enjoyment from your
speaker system.
Appendix
Operating Precautions ................... 3
Speaker care.................................... 4
Specifications.................................. 4
Please retain this manual for future reference.
En
Download from Www.Somanuals.com. All Manuals Search And Download.
SKR-L500.fm Page 3 Tuesday, October 4, 2005 2:15 PM
Connecting the Speakers
Using Speaker Mounts/Brackets
Read the following before connecting your speakers:
• Turn off your amp before making any connections.
• The nominal impedance of these speakers is 6 Ω. Use
only an amp that supports this impedance.
• Pay close attention to speaker wiring polarity. Con-
nect positive (+) terminals to only positive (+) termi-
nals, and negative (–) terminals to only negative (–)
terminals. If the speakers are wired incorrectly, the
sound will be out of phase and will sound unnatural.
• Be careful not to short the
Threaded inserts for 5 mm machine screws are provided
on the rear and buttom of the speaker for wall-mounting
with commercially available speaker mounts and brack-
ets. Refer to the manual supplied with your mounts or
brackets for installation details.
Note:
The portion of the screw that goes into the speaker’s
threaded insert should be between 5 mm and 9 mm
long.
Mount or bracket
positive and negative wires.
Doing so may damage your
amp.
5 mm
5–9 mm
■ Connecting the Speaker Cables
Operating Precautions
Strip the insulation from the
1
The speaker can handle the specified input power when
used for normal music reproduction. If any of the fol-
lowing signals are fed to them, even if the input power
is within the specified rating, excessive current may
flow in the speaker coils, causing burning or wire break-
age:
1. Interstation noise from an untuned FM radio.
2. Sound from fast-forwarding a cassette tape.
3. High-pitched sounds generated by an oscillator, elec-
tronic musical instrument, and so on.
ends of the speaker cables,
and twist the bare wires tightly.
Use the cables to connect speaker’s input
terminals to the corresponding speaker
output terminals on your amp.
To make a connection, while
pressing the terminal lever,
2
insert the wire into the hole, and
then release the lever.
Make sure that the terminals are
gripping the bare wires, not the insulation.
4. Amplifier oscillation.
5. Special test tones from audio test CDs and so on.
6. Thumps and clicks caused by connecting or discon-
necting audio cables (Always turn off your amplifier
before connecting or disconnecting cables.)
7. Microphone feedback.
• The speaker contain strong magnets, so do not put
magnetic or iron objects such as screwdrivers close to
them. If you do, the object may be attached to the
magnets, causing personal injury or damage to the
diaphragm.
SKR-L500
SKR-L500
Surround back
speaker (right)
Surround back
speaker (left)
SKM-L500S
Surround right
speaker
SKF-L500
Front right
speaker
SKM-L500S
Surround left
speaker
SKF-L500
Front left
speaker
SURROUND BACK SPEAKER
SURROUND SPEAKERS
FRONT PEAKERS
Brown
L
Brown
R
SKC-L500C
Center speaker
CENTER SPEAKER
3
Download from Www.Somanuals.com. All Manuals Search And Download.
SKR-L500.fm Page 4 Tuesday, October 4, 2005 2:15 PM
Speaker care
Specifications
Type:
2-way bass reflex
6 Ω
Wipe the cabinet occasionally with a dry silica or soft
cloth. For heavier dirt, after dampening a soft cloth in a
weak solution of mild detergent and water and wringing
it out dry, wipe off the dirt. Then, dry immediately with
a clean cloth. Do not use rough material, thinners, alco-
hol or other chemical solvents or cloths since these
could damage the finish, remove the panel lettering, or
cause discoloration. If you are using a chemical cloth,
always follow the instructions that come with the cloth.
For dust accumulated on grilles, use a vacuum cleaner
or brush it off.
Impedance:
Maximum input power:
130 W
Output sound pressure level: 80 dB/W/m
Frequency response:
Crossover frequency:
Cabinet capacity:
Speaker (woofer):
Speaker (tweeter):
Terminal:
60 Hz - 35kHz
8 kHz
2.1 L
8 cm cone
2.5 cm balanced dome
Spring type color-coded
Dimensions:
161 (W) × 288 (H) × 93 (D) mm
(Overall dimensions)
Weight:
1.1 kg
Specifications and appearance are subject to change for
improvement without prior notice.
In catalogs and on packaging, the letter added to the end
of the product name indicates the color of the SKR-
L500. Specifications and operation are the same regard-
less of color.
Sales & Product Planning Div. : 2-1, Nisshin-cho, Neyagawa-shi, OSAKA 572-8540, JAPAN
Tel: 072-831-8023 Fax: 072-831-8124
ONKYO U.S.A. CORPORATION
18 Park Way, Upper Saddle River, N.J. 07458, U.S.A.
ONKYO EUROPE ELECTRONICS GmbH
Liegnitzerstrasse 6, 82194 Groebenzell, GERMANY
ONKYO EUROPE UK Office
Suite 1, Gregories Court, Gregories Road, Beaconsfield, Buckinghamshire, HP9 1HQ
UNITED KINGDOM Tel: +44-(0)1494-681515 Fax: +44(0)-1494-680452
HOMEPAGE
ONKYO CHINA LIMITED
Units 2102-2107, Metroplaza Tower I, 223 Hing Fong Road, Kwai Chung,
N.T., HONG KONG Tel: 852-2429-3118 Fax: 852-2428-9039
I0508-1
SN 29344143
(C) Copyright 2005 ONKYO CORPORATION Japan. All rights reserved.
* 2 9 3 4 4 1 4 3 *
Download from Www.Somanuals.com. All Manuals Search And Download.
|