Omega Speaker Systems Car Amplifier 0603 User Manual

®
FLSC-AMP-A  
Preamplifier and Signal Conditioner  
for Magnetic Pick-ups  
MAGNETIC PICKUP  
AMPLIFIER  
OPERATOR’S  
M1945/0603  
MANUAL  
General Description  
The FLSC-AMP-A Signal Conditioner will amplify low level signals from magnetic pick-up sensors, such as a  
turbine meter or paddlewheel sensor, to an amplified high level square wave pulse output proportional in  
amplitude to the power supply powering the module. This output will drive any OMEGA® flow ratemeter,  
counter, controller or pulse input data acquisition board.  
Unpacking  
Remove the Packing List and verify that you have received all equipment. If you have any questions about the  
shipment, please call the Customer Service Department.  
When you receive the shipment, inspect the container and equipment for any signs of damage. Note any  
evidence of rough handling in transit. Immediately report any damage to the shipping agent.  
NOTE  
The carrier will not honor any claims unless all shipping material is saved for their examination.  
After examining and removing contents, save packing material in the event reshipment is necessary.  
The following items are supplied in the box:  
• FLSC-AMP-A Signal Conditioner  
• Operator’s Manual  
Hookup (Refer to Figure 1)  
For electrical connections, the terminal strip will accommodate up to a 14 gauge wire. 18-20 gauge is  
recommended.  
Note: The signal lines from the magnetic pick-up should be shielded and kept less than ten feet and away from  
relays, solenoids, or other sources of electrical noise. The signal shield should be connected to power/common.  
The module output is recommended to make long distance runs.  
POWER / COMMON  
(ALSO USED FOR OUTPUT RETURN)  
1
2
OUTPUT  
MOUNTING  
HOLES (2)  
USE 8-32  
SCREWS  
+ POWER SUPPLY  
3
4
– SIGNAL  
INPUT  
+ SIGNAL  
5
Figure 1. Terminal Connections  
Mounting  
The FLSC-AMP-A module may be mounted using the screw holes provided in the molded housing. Double-  
sided tape, Velcro, or glue may also be used to secure the module in place. The FLSC-AMP-A module can also  
be snap track mounted using an adapter plate.  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Miele Oven M Nr 09 786 840 User Manual
Milnor Refrigerator KQEXTT1301 User Manual
Mountfield Lawn Mower EL 410 User Manual
Mr Coffee Coffeemaker VB12 User Manual
Nissan Automobile 2010 Xterra User Manual
Nokia Cell Phone 2855i User Manual
Nortel Networks Power Supply NN46200 310 User Manual
Nortel Networks Switch NN47220 101 User Manual
Panasonic Laptop Docking Station FZVEBG11U User Manual
Panasonic Personal Computer CF E1M User Manual