INSTALLATION INSTRUCTIONS
MODEL
NO.
OVERALL SIZE
WALL OPENING
W
H
D
4
W
H
D
MODEL: B703850, B704850
RECESSED / SURFACE MOUNTED
STEEL BATH CABINET
For help, call us toll
free!
B703850
B704850
245/8 193/16
233/8 18 31/2
--- --- ---
237/8 195/16 41/4
1-800-325-8351
Fig. 3
Door Bumper
Placement
Fig. 2
MIRROR CARE
Back Side
Door Pull Placement
•
•
•
•
Use only clean warm water and a clean,
soft, lint-free cloth.
Mirror Side
3
1-1/4”
1-1/4”
14
"
1
DO NOT USE cleaners that contain
solutions of ammonia, vinegar or chlorine.
DO NOT USE powdered cleaners or steel
wool.
Never spray cleaning agent directly on
mirror, especially on exposed edges and
mirror backing. Apply cleaner to soft cloth
and wipe mirror. Dry mirror thoroughly.
Keep mirror dry. A well ventilated bathroom is
important.
14
"
Right Door
Left Door
Left Door
Fig. 1
•
H
Approx.
64" to
Floor
D
INSTALLATION of RECESSED CABINET
1. Carefully remove all packing material. Place
shelves and hardware package aside until needed.
2. Deteremine desired location of cabinet on wall.
Mark wall to show wall opening size (see
7
6
1
W
5
2
dimensions chart). Generally, the recommended
height to the center of the cabinet is 64” from the
floor. Fig. 1
3
4
3. CAUTION: Wall studs, plumbing or electrical lines
that interfere must be removed or relocated. Cut
wall opening, being careful not to damage the
surrounding wall surface. Insert framing to support
all plaster board edges.
4. Insert cabinet into wall opening in plumb and
centered position. Use a carpenter’s level and
shim corners of cabinet if necessary. Secure to
wall studs through the 4 mounting holes inside
cabinet (screws provided).
INSTALLATION of SURFACE MOUNT CABINET
1. Position cabinet on wall, making sure it is level.
2. Mark mounting hole locations through back of
cabinet and onto wall material. Set cabinet aside.
Pre-drill mounting holes if necessary.
3. Re-position cabinet and secure it to wall studs through
mounting holes in rear of cabinet. Use four screws
(provided). If studs are not available, use 3/16” molly
bolts or 3/16” wall anchors, depending on wall material.
SERVICE PARTS
KEY
PART NUMBER
NO.
1
DESCRIPTION
B703850
B704850
A99050344
A97017873
---
Mirror
A99050348
A97017873
3333L
2
3
Handle
Shelf Bracket - Left
Shelf Bracket - Right 3333R
---
4
5
6
7
Shelf
Track
Bumpon
*
A98010537
A98010546
99100485
---
A98010565
99100485
Mounting Screw, Mounting Screw,
1
1
2
2
#8x1 / ”
#8x1 / ”
*Standard hardware - may be purchased locally.
Order replacement parts by “PART NO.” - Not by “KEY NO.”
One Year Limited Warranty
DOOR PULL AND BUMPER PLACEMENT
1. Clean mirror side of doors thoroughly to prepare surface
for self adhesive door pulls.
WARRANTY OWNER: Broan-NuTone warrants to the original consumer purchaser of its products that such products will be free from
defects in materials or workmanship for a period of one (1) year from the date of original purchase. THEREARE NO OTHER WARRANTIES,
EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR
A PARTICULAR PURPOSE.
During this one year period, Broan-NuTone will, at its option, repair or replace, without charge, any product or part which is found to be
defective under normal use and service. THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS OR TUBES,
FILTERS, DUCT, ROOF CAPS, WALL CAPS AND OTHER ACCESSORIES FOR DUCTING. This warranty does not cover (a) normal
maintenance and service or (b) any products or parts which have been subject to misuse, negligence, accident, improper maintenance or
repair (other than by Broan-NuTone), faulty installation or installation contrary to recommended installation instructions.
The duration of any implied warranty is limited to the one year period as specified for the express warranty. Some states do not allow
limitation on how long an implied warranty lasts, so the above limitation may not apply to you.
BROAN-NUTONE’S OBLIGATION TO REPAIR OR REPLACE, AT BROAN-NUTONE’S OPTION, SHALL BE THE PURCHASER’S
SOLE AND EXCLUSIVE REMEDY UNDER THIS WARRANTY. BROAN-NUTONE SHALL NOT BE LIABLE FOR INCIDENTAL,
CONSEQUENTIAL OR SPECIAL DAMAGES ARISING OUT OF OR IN CONNECTION WITH PRODUCT USE OR PERFORMANCE.
Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may
not apply to you. This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state. This
warranty supersedes all prior warranties.
WARRANTY SERVICE: To qualify for warranty service, you must (a) notify Broan-NuTone at the address or telephone number
below, (b) give the model number and part identification and (c) describe the nature of any defect in the product or part. At the
time of requesting warranty service, you must present evidence of the original purchase date.
2. Remove paper backing from door pulls and press them
on to mirror side of door at location shown. Fig. 2
3. Clean back side of mirror to prepare surface for self
adhesive bumper. Remove paper backing from door
bumper and press bumper on to back side of left door.
Fig. 3
ASSEMBLE DOORS TO CABINET
1. Insert the TOP of RIGHT MIRROR DOOR into the
UPPER REAR TRACK, then move mirror door toward
cabinet and lower into the BOTTOM of REAR TRACK.
2. The same procedure is repeated for LEFT HAND
MIRROR DOOR except install the door in FRONT
TRACK.
Date of Installation
Builder or Installer
Model No. and Product Description
IF YOU NEED ASSISTANCE OR SERVICE - CONTACT:
Broan-NuTone Storage Solutions, 501 S. Wilhite Street, Cleburne, TX 76031 www.nutone.com (1-800-325-8351)
Download from Www.Somanuals.com. All Manuals Search And Download.
|