Metra Electronics Power Screwdriver 98 8999 User Manual

INSTALLATION INSTRUCTIONS FOR PART 98-8999  
Applications  
MITSUBISHI (page1)  
3000 GT 1991-1999, Diamante 1997-2004, Eclipse 1995-2005,  
Galant*1994-2009 (* With Manual Climate Control), Mirage 1997-2003,  
Montero 1996-2005, Montero Sport 2000-2004  
SUBURU (page2)  
Baja 2003-2005, Forester 1998-2008, Impreza 1993-2007,  
Impreza WRX 2002-2005, Legacy 1995-2004, Outback 2000-2004  
VOLKSWAGEN (page3)  
Golf 2001-2005, Jetta**2001-2005 (** No Including New A5)  
Passat 2001-2005  
98-8999  
KIT FEATURES  
• Holds Three CD Jewel Cases  
KIT COMPONENTS  
A) VW Pocket Trim Plate • B) Subaru Pocket Trim Plate • C) Mitsubishi Trim Plate • D) Pocket  
• E) (2) VW Brackets • F) (2) Left Brackets • G) (2) Right Brackets • H) (4) #8 x 1/4” Phillips Pan Head Screws  
I) (6) #6 x 1/4” Phillips Flat Head Screws  
D
A
C
B
I
F
G
H
E
TOOLS REQUIRED:  
Phillips Screwdriver  
1-800-221-0932  
© COPYRIGHT 2002-2008 METRA ELECTRONICS CORPORATION  
Download from Www.Somanuals.com. All Manuals Search And Download.  
POCKET ASSEMBLY  
98-8999  
SUBARU POCKET  
Disconnect the negative battery  
terminal to prevent an accidental  
short circuit.  
1
2
A
Snap Pocket Trimplate SUB onto  
the front of the Pocket. Locate one  
of the Left Brackets and mount it  
to the “Lside of the Pocket with  
(2) #6 x 1/4" Phillips Flat Head  
Screws. Next locate one of the  
Right Brackets and mount it to  
the “R” side of the Pocket with (2)  
#6 x 1/4" Phillips Flat Head  
Screws. (Figure A)  
B
B2  
Mount the factory brackets to the  
shaded bosses (Fig. B2) with (4) #8  
x 1/4" Phillips Pan Head Screws  
supplied and mount the entire  
3
assembly to the sub-dash. (Figure B)  
2
Download from Www.Somanuals.com. All Manuals Search And Download.  
POCKET ASSEMBLY  
98-8999  
VOLKSWAGEN POCKET  
Disconnect the negative battery  
terminal to prevent an accidental  
short circuit.  
1
2
A
Snap Pocket Trimplate VW (labeled  
TP-9008) onto the front of the  
Pocket. Locate the X-5599L  
Bracket and mount it to the “L”  
side of the Pocket with (3) #6 x  
1/4" Phillips Flat Head Screws.  
Next locate the X-5599R Bracket  
and mount it to the “R” side of the  
Pocket with (3) #6 x 1/4" Phillips  
Flat Head Screws. (Figure A)  
B
Pull out the plastic tray separating  
the dash cavity and remove the tray  
(“A”). Position the Pocket so each  
bracket is configured with (2) screws  
on the top and (1) screw on the bot-  
tom (“B”). Slide the pocket into the  
dash opening until the side clips  
engage. (Figure B)  
3
K
NOWLEDGE IS  
POWER  
Enhance your installation and fabrication skills by  
enrolling in the most recognized and respected  
mobile electronics school in our industry.  
800-354-6782 for more information and take steps  
toward a better tomorrow.  
1-800-221-0932  
REV. 08/12/08 © COPYRIGHT 2002-2008 METRA ELECTRONICS CORPORATION INST98-8999  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  

Krups Coffeemaker XP 4000 User Manual
LG Electronics CRT Television 26 3DCH UA User Manual
Life Fitness Home Gym Elevation Series User Manual
Linear Stereo Receiver RV5060 User Manual
Linear Switch DT 2A User Manual
Lucent Technologies Security Camera Release 6 User Manual
Lux Products Thermostat T10 1141 User Manual
Marvel Industries Beverage Dispenser 8SWCE User Manual
Matsushita Computer Hardware CF 30CTQAZBM User Manual
Meyer Sound Portable Speaker MICA User Manual