MT0501.OM O/M 8/13/02 10:35 AM Page 11
5" B&W PORTABLE SOCCER
BALL TELEVISION
MODEL MT0501
BEFORE OPERATING THIS PRODUCT, PLEASE READ THESE
INSTRUCTIONS COMPLETELY.
OPERATING INSTRUCTIONS
Download from Www.Somanuals.com. All Manuals Search And Download.
MT0501.OM O/M 8/13/02 10:35 AM Page 2
12. POWER-CORD PROTECTION
Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against
them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance.
13. LIGHTNING
To protect your unit from a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall
outlet and disconnect the antenna or cable system. This will prevent damage to the unit due to lightning and power-line surges.
14. POWER LINES
An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits,
or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken
to keep from touching such power lines or circuits as contact with them might be fatal.
15. OVERLOADING
Do not overload wall outlets and extension cords as this can result in a risk of fire or electric shock.
16. OBJECT AND LIQUID ENTRY
Do not push objects through any openings in this unit as they may touch dangerous voltage points or short out parts that could
result in fire or electric shock. Never spill or spray any type of liquid into the unit.
17. OUTDOOR ANTENNA GROUNDING
If an outside antenna or cable system is connected to the unit, be sure the antenna or cable system is grounded so as to
provide some protection against voltage surges and built-up static charges. Section 810 of the National Electric Code,
ANSI/NFPA 70, provides information with respect to proper grounding of the mast and supporting structure, grounding of the
lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to
grounding electrodes, and requirements for grounding electrode.
18. SERVICING
Do not attempt to service this unit yourself as opening or removing covers may expose you to dangerous voltage or other
hazards. Refer all servicing to qualified service personnel.
19. DAMAGE REQUIRING SERVICE
Unplug the unit from the wall outlet and refer servicing to qualified service personnel under the following conditions:
a. When the power-supply cord or plug is damaged.
b. If liquid has been spilled, or objects have fallen into the unit.
c. If the unit has been exposed to rain or water.
d. If the unit does not operate normally by following the operating instructions. Adjust only those controls that are covered by the
operating instructions, as an adjustment of other controls may result in damage and will often require extensive work by a
qualified technician to restore the unit to its normal operation.
e. If the unit has been dropped or the cabinet has been damaged.
f. When the unit exhibits a distinct change in performance - this indicates a need for service.
20. REPLACEMENT PARTS
When replacement parts are required, be sure the service technician uses replacement parts specified by the manufacturer or
those that have the same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock or
other hazards.
21. SAFETY CHECK
EXAMPLE OF ANTENNA GROUNDING AS PER
Upon completion of any service or repairs to this
NATIONAL ELECTRICAL CODE
unit, ask the service technician to perform safety
checks to determine that the unit is in proper
operating condition.
22. WALL OR CEILING MOUNTING
The product should be mounted to a wall or ceiling
only as recommended by the manufacturer.
23. HEAT
The product should be situated away from heat
sources such as radiators, heat registers, stoves,
or other products (including amplifiers) that
produce heat.
24. NOTE TO CATV SYSTEM INSTALLER
This reminder is provided to call the CATV
system installer's attention to Article 820-40 of
the NEC that provides guidelines for proper
grounding and, in particular, specifies that the
cable ground shall be connected to the grounding
system of the building, as close to the point of
cable entry as practical.
2
Download from Www.Somanuals.com. All Manuals Search And Download.
MT0501.OM O/M 8/13/02 10:35 AM Page 3
LOCATION OF CONTROLS
FRONT
1
2
7
3
4
5
8
9
6
REAR
10
14
15
16
11
12
13
1. Carrying Handle
2. TV Screen
10. TV/FM Antenna
11. DC 12 JACK
3. Dial Scale and Pointer
4. TV/OFF/RADIO Switch
5. BAND Switch
6. Battery Compartment (Bottom of Unit)
7. TUNING Control
+
-
12. External Antenna Jack
13. CHARGE Switch
14. BRIGHT Control
15. CONTRAST Control
16. V-HOLD Control
8. EARPHONE Jack
9. VOLUME Control
3
Download from Www.Somanuals.com. All Manuals Search And Download.
MT0501.OM O/M 8/13/02 10:35 AM Page 4
POWER SOURCES
POWER SUPPLY
This TV is designed to operate from 10 “C” size batteries, a 120VAC 60Hz AC Adapter or a Car Adapter.
BATTERIES
To operate using batteries, gently remove the battery cover by sliding it in the direction of the arrow and
insert 10 “C” size batteries following the illustration. Replace the
battery cover.
+
+
+
-
-
-
+
+
+
-
-
-
Slide the CHARGE switch to the BATT. position.
BATTERY PRECAUTIONS
+
+
-
-
+
+
-
-
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries
as indicated in the battery compartment. Reversed batteries may
cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline and
Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the
batteries to prevent damage or injury from possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they
can overheat and rupture. (Follow battery manufacturer’s
directions.)
AC POWER
To operate the unit using AC power, connect the AC adapter to the jack labeled “DC-12V” on the unit and
insert it into a wall outlet having 120V, 60Hz only Slide the CHARGE switch to the EXT. position.
AC Outlet
AC Adapter's Plug
NOTE: If the AC adapter’s plug does not fit into a nonpolarized outlet, do not file or cut the wide blade.
CAUTION: Use only the AC adapter provided; using another AC adapter may damage the unit. When not
using AC power, disconnect the AC adapter from the wall outlet by pulling the plug (not the cord). Do not
touch the AC adapter with wet hands.
DC (CAR BATTERY) POWER
+
-
Confirm that your car uses a 12V negative ground battery system
by reading the car’ owner’s
manual or contacting the manufacturer. Remove the cigarette lighter from its socket in the dash and
connect one end of the Car Adapter into the DC 12V Jack and the other end to the car cigarette lighter
socket. Slide the CHARGE switch to the EXT. position.
NOTE: Remove the Car Adapter from the car cigarette lighter socket when not in use.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
MT0501.OM O/M 8/13/02 10:35 AM Page 5
POWER SOURCES (CONTINUED)
RECHARGEABLE BATTERIES (NOT INCLUDED)
Insert Ni-Cd rechargeable batteries just as you would regular batteries. Slide the CHARGE switch to the
CHARGE position. Insert the AC Adapter to the jack labelled “DC 12V” on the unit and to a wall outlet having
120V, 60Hz only. Charging time is approximately 12 hours. Slide the switch to the EXT. or BATT position
when finished charging.
IMPORTANT NOTES:
•
•
Do not attempt to turn on the unit while charging batteries.
Do not attempt to charge batteries other than rechargeable type intended for this unit (Ni-Cad).
ANTENNA
The built-in telescopic antenna can be used to receive VHF and UHF TV channels. To improve TV
reception, connect an external antenna to the antenna adapter and plug the adapter into the External
Antenna Jack on the rear of the TV.
EARPHONE JACK
An earphone jack is provided for private listening. To listen to the unit with an earphone, set the volume to
minimum and insert an earphone into the Earphone jack. The speaker will be disconnected when a plug is
inserted in the jack. Adjust the VOLUME as desired.
EXT/BATT/CHARGE SWITCH
Slide this switch to the EXT position when using the external AC adaptor or Car adaptor. Slide this switch to
the BATT position when using batteries and to the CHARGE position when recharging rechargeable batteries.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
MT0501.OM O/M 8/13/02 10:35 AM Page 6
TV OPERATION
TO VIEW A CHANNEL
1
2
3
1
2
Tune a desired TV station by
turning the TUNING control ❶ and
adjust the VOLUME control ❷ as
desired.
Make sure the EXT/BATT/
CHARGE switch is set properly
(see page 5). Slide the TV/
OFF/RADIO switch to the TV
position to turn the TV on.
Slide the BAND switch to the
desired setting:
VL: Channels 2–6
VH Channels 7–13
UHF Channels 14–83
4
5
6
Adjust picture controls, as
described below, for best picture.
Adjust the rod antenna for best
picture.
Slide the TV/OFF/RADIO switch
to the OFF position to turn the TV
off.
NOTES:
•
•
When you change channels, the telescopic antenna may have to be re-adjusted for best picture.
If reception is poor, even after adjusting telescopic antenna, use an external antenna. See page 5
for details.
PICTURE CONTROLS
1
2
3
CONTRAST:
V-HOLD:
BRIGHTNESS:
If the picture is too strong or too
weak, rotate to adjust the contrast
and clearly define the shades of
blacks, grays and whites.
If the picture moves up and down If the picture is too light or dark,
or rolls, rotate to adjust the verti- rotate to adjust the brightness.
cal hold.
6
Download from Www.Somanuals.com. All Manuals Search And Download.
MT0501.OM O/M 8/13/02 10:35 AM Page 7
RADIO OPERATION
TO LISTEN TO THE RADIO
1
2
3
1
2
Slide the BAND switch to select Tune a desired AM or FM station
Make sure the EXT/BATT/
CHARGE switch is set properly
(see page 5). Slide the TV/
OFF/RADIO switch to the RADIO
position to turn the radio on.
the AM or FM band.
by turning the TUNING control ❶
and adjust the VOLUME control ❷
as desired.
4
5
Rotate the unit for best AM recep- Slide the TV/OFF/RADIO switch
tion, or adjust the TV/FM Antenna to the OFF position to turn the
for best FM reception.
radio off.
7
Download from Www.Somanuals.com. All Manuals Search And Download.
MT0501.OM O/M 8/13/02 10:35 AM Page 8
CARE AND MAINTENANCE
CLEANING
To prevent fire or shock hazard, disconnect your unit from the AC power source when cleaning. The finish
on the unit may be cleaned with a dust cloth and cared for as other furniture. Mild soap and a dampened
cloth may be used.
MAINTENANCE
Do not expose this unit to an excessively hot environment for extended periods of time. Extreme heat could
cause component failure or reduce component life.
TRAFFIC SAFETY
•
•
•
Do not use while operating a motorized vehicle. It may create a traffic hazard and is illegal in many
areas.
Even if your headset is an open air type designed to let you hear outside sounds, do not turn the volume
up so high that you cannot hear what is around you.
Use extreme caution or temporarily discontinue use in potentially hazardous situations.
FOR ADDITIONAL SET-UP OR OPERATING ASSISTANCE, PLEASE VISIT OUR WEBSITE AT
WWW.MEMCORPINC.COM OR CONTACT CUSTOMER SERVICE AT
1-800-919-3647
PLEASE KEEP ALL PACKAGING MATERIAL FOR AT LEAST 90 DAYS IN CASE YOU NEED
TO RETURN THIS PRODUCT TO YOUR PLACE OF PURCHASE OR MEMOREX.
FOR PARTS AND ACCESSORIES, CONTACT FOX INT’L AT 1-800-321-6993.
8
Download from Www.Somanuals.com. All Manuals Search And Download.
MT0501.OM O/M 8/13/02 10:35 AM Page 9
TROUBLESHOOTING GUIDE
If you experience a problem with this unit, please refer to the following chart
before requesting service.
SYMPTOMS
POSSIBLE SOLUTIONS
• Make sure the power cord (not included) is plugged in.
• Try another AC outlet.
Unit does not operate
• Make sure POWER is on.
• CHARGE switch is not in the proper position.
• Batteries are weak, dead or not inserted properly.
• Station experiencing problems, tune to another station.
• Check VOLUME adjustment.
Poor sound or No sound
Poor picture or No picture
• Check for sources of possible interference.
• Earphone is plugged into EARPHONE jack.
• Check antenna connections, reorient antenna.
• Check for sources of possible interference.
• Check picture adjustments.
• Station experiencing problems, tune to another station.
• Station experiencing problems, tune to another station.
• Station signal is weak, reorient antenna to receive weaker
station; connect an external antenna to the external
antenna adapter.
Poor reception on some
channels/radio stations
• Check for sources of possible interference.
• Station experiencing problems, tune to another station.
• Check antenna orientation.
Picture wobbles or drifts
• Check for sources of possible interference.
• Check antenna connections and reorient antenna.
Horizontal or diagonal bars on screen • Check for sources of possible interference.
• If using an external antenna, check connections.
TV shuts off
• Power interrupted.
Picture too dark or too light.
Picture weak or fuzzy.
Picture rolls or jumps.
• Adjust BRIGHTNESS control
• Adjust CONTRAST control
• Adjust V-HOLD control
9
Download from Www.Somanuals.com. All Manuals Search And Download.
MT0501.OM O/M 8/13/02 10:35 AM Page 10
Memcorp, Inc.
Weston, FL
Printed in Hong Kong
Download from Www.Somanuals.com. All Manuals Search And Download.
|