Marshall Amplification Stereo Amplifier MG10CD User Manual

MG  
SERIES  
10CD  
EMULATED  
2 CHANNELS  
CD INPUT  
EQ  
CLEAN  
OVERDRIVE  
CONTOUR  
LINE OUT  
Owners Manual  
Download from Www.Somanuals.com. All Manuals Search And Download.  
WARNING! - Important safety instructions  
!
WARNING: This apparatus must be earthed!  
A
B
PLEASE read this instruction manual carefully before switching on.  
ALWAYS use the supplied mains lead, if a replacement is required please contact your  
authorised Marshall Dealer.  
Note: Closed back equipment with non-detachable mains cord.  
When the equipment is not in use or is being transported, the mains  
cord should be gathered and retained under the top strap handle to  
prevent damage. See diagram.  
C
D
E
NEVER attempt to by-pass the fuses or fit ones of the incorrect value.  
DO NOT attempt to remove the amplifier chassis, there are no user serviceable parts.  
Refer all servicing to qualified service personnel.  
Servicing is required when the apparatus has been damaged in any way, such as when the  
power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the  
apparatus, the apparatus has been exposed to rain or moisture, does not operate normally  
or has been dropped.  
F
NEVER use an amplifier in damp or wet conditions.  
G ALWAYS unplug this apparatus during lightning storms or when unused for long periods of  
time.  
H PROTECT the power cord from being walked on or pinched particularly at plugs,  
convenience receptacles and at the point where they exit from the apparatus.  
I
DO NOT switch the amplifier on without the loudspeaker connected.  
Note: This equipment has been tested and found to comply with the requirements of the EMC  
directive (Environments E1, E2 and E3 EN 55103-1/2) and the Low Voltage directive in the E.U.  
EUROPE ONLY - Note: The Peak Inrush current for the MG10CD is 2 amps.  
CAUTION: Any changes or modifications not expressly approved by the party responsible for  
compliance may void the users authority to operate the equipment.  
Note: It is recommended that all audio cables used to connect to the MG10CD are of a high  
quality screened type. These should not exceed 10 metres in length.  
WARNING: Always ensure free movement of air around the amplifier!  
USA ONLY - DO NOT defeat the purpose of the polarised or grounding type plug. A  
polarised plug has two blades with one wider than the other. A grounding type plug has two  
blades and a third grounding prong. The wide blade or the third prong are provided for your safety.  
When the provided plug does not fit into your outlet, consult an electrician for replacement of the  
obsolete outlet.  
Follow all instructions and heed all warnings  
KEEP THESE INSTRUCTIONS !  
Download from Www.Somanuals.com. All Manuals Search And Download.  
2
MG10CD Front Panel Features  
1
2
3
4
5
6
7
8
9
1. INPUT jack  
Use a good quality guitar (screened) cable to  
plug your guitar in here.  
7. CD IN & EMULATED LINE OUT jack  
The MG10CD cleverly combines its Line Out  
and CD Input functions. If you want to jam to  
your favourite CD or tape, merely connect the  
headphone output of your CD or tape player  
here, adjust the player’s volume to match that of  
your guitar and ‘hey-presto’ – you've got the  
perfect ‘play-along’ practice system.  
2. Clean VOLUME control  
When the OD Select switch is ‘out’, this control  
adjusts the volume of the Clean Channel. At low  
settings the sound will be very clean with a bell-  
like ring. Turning this control above half way will  
introduce a desirable, bluesy distortion as the  
power amplifier is driven into ‘crunch mode’.  
Alternatively, you can use this socket to  
connect the MG10CD to your multi-track  
recording machine and you’ll get a great guitar  
sound direct to disk or tape.  
3. OD (Overdrive) SELECT switch  
Depressing the Overdrive Select Switch will  
engage the Overdrive Channel.  
HELPFUL HINT: for ‘silent’ recording merely  
plug an unconnected jack plug to the headphone  
socket and you’ll disconnect the MG10CD’s  
internal speaker.  
4. Overdrive GAIN control  
Turning up the Overdrive Gain Control will  
increase the amount of distortion generated in  
the Overdrive channel. Low gain settings will  
produce classic rock and blues tones. Crank the  
Gain for fat and aggressive sounds that are  
perfect for soloing or hard rock and nu-metal  
riffs.  
8. EMULATED HEADPHONES jack  
Plug your headphones here for a killer speaker  
emulated sound! Doing this mutes your  
MG10CD's internal speaker for ‘silent’ practice.  
9. POWER Switch & LED  
The power switch turns your amplifier on and  
off. The LED will be lit when your amplifier is on  
and will not be lit when the amplifier is switched  
off.  
5. Overdrive VOLUME control  
Amazingly enough, this control adjusts the  
volume of the Overdrive channel!  
Note: Before connecting to the mains  
electricity supply, always ensure that your  
electricity supply is compatible with your  
amplifier, as detailed on the rear panel.  
The louder this channel is set, the ‘looser’ the  
amplifier will sound and feel. This behaviour is  
exactly what a good all-valve amplifier does and  
is a result of our proprietary FDD circuitry.  
Please ensure the amplifier is switched off and  
unplugged from the mains electricity supply  
before being moved.  
6. CONTOUR control  
This highly effective tone control works on both  
the Clean and Overdrive channels. By radically  
modifying the mid-range (body), the tone can  
range from traditional and woody sounding  
(setting at 10), to aggressive, ‘scooped’ and  
modern (setting at 0) and all points in-between.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
3
MG  
SERIES  
10CD  
Technical Specification  
Especificaciones técnicas  
Technische Daten  
Caractéristiques techniques  
Power Output  
10W RMS into 8  
Potencia de salida  
Ausgangsleistung  
Puissance de sortie  
10W RMS sobre 8Ω  
10W RMS an 8Ω  
10W RMS sous 8 ohms  
10W RMS / 8Ω  
Main Guitar • Input Impedance  
1MΩ  
Impedancia de entrada principal de guitarra  
Guitar • Input Eingangsimpedanz  
Impédance d'entrée  
1MΩ  
1MΩ  
1MΩ  
1MΩ  
CD Input • Input impedance  
3.3kΩ  
Impedancia de entrada de CD  
CD Input • Eingangsimpedanz  
Impédance d'entrée CD  
3.3kΩ  
3.3kΩ  
3.3kΩ  
3.3kΩ  
Emulated Output • Level  
-10dBV  
Nivel de salida de línea simulada  
Emulated Output • Ausgangspegel  
Niveau de sortie  
-10dBV  
-10dBV  
-10dBV  
-10dBV  
Weight  
5.0kg  
Peso  
5.0kg  
5.0kg  
5.0kg  
5.0kg  
Gewicht  
Poids  
Size (mm)  
290mm x 290mm x 180mm  
Tamaño (mm)  
Maße (mm)  
Taille (mm)  
290mm x 290mm x 180mm  
290mm x 290mm x 180mm  
290mm x 290mm x 180mm  
290mm x 290mm x 180mm  
Download from Www.Somanuals.com. All Manuals Search And Download.  
1 6  
Here follows four sample settings to act as starting  
points from which to develop your own sounds.  
Suggested Settings  
Configuraciones que sugerimos  
Soundvorschläge  
N.B. Volume should be adjusted to taste.  
Exemples de Réglages  
Out  
In  
In  
In  
Marshall Amplification plc  
Denbigh Road, Bletchley, Milton Keynes, MK1 1DQ, England  
Tel : [01908] 375411 Fax : [01908] 376118  
Whilst the information contained herein is correct at the time of publication, due to our policy of constant improvement  
and development, Marshall Amplification plc reserve the right to alter specifications without prior notice.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
230V  

Lanzar Car Audio Car Amplifier MXA1600 User Manual
Lasko Fan 1850W User Manual
Linear Car Amplifier HDMI DA 2X8M User Manual
Linksys Network Router WAG54GS User Manual
Loewe Flat Panel Television 46 40 User Manual
Mace DVR DVR 9416 User Manual
Magma Charcoal Grill A10 004 User Manual
Makita Power Hammer HR2445 User Manual
Marantz Car Stereo System NA8005 User Manual
Metabo Planer Routers and Planers User Manual