Lynx Indoor Furnishings L LS User Manual

eDARTSystem User Guide  
Lynx™ Mold-Closed Limit Switch  
L-LS  
The Lynx™ L-LS Mold-Closed Limit Switch is a tie-bar or  
machine mountable machine cycle input module designed to be  
used with the eDART System™.  
U
The L-LS switch can be used to easily get a machine trigger off of  
most injection molding machines by following the installation steps  
below.  
Always power down before working on  
any equipment.  
Figure 25: Lynx™ Mold-Closed Limit Switch side view  
L-LS Installation  
Step 1.  
Switch the molding machine to Manual mode and close  
the mold.  
!
U
Be careful to note the position of the  
ejector plate, the mold, the limit switch  
and its cable, so the limit switch and/or  
its cable does not get caught as the  
mold opens and closes.  
Step 2.  
Set the limit switch on the tie-bar as shown in figures 26  
and 27.  
Appendix  
32  
Download from Www.Somanuals.com. All Manuals Search And Download.  
eDARTSystem User Guide  
Step 4.  
Hold the limit switch in place and use a ty-wrap to tighten  
it down to the tie-bar. See figure 29.  
More than one ty-wrap can be tied together if the tie-bar is  
large.  
U
B
Always power down before working on  
any equipment.  
L-LS  
A
C
D
Figure 29: Lynx™ Mold-Closed Limit Switch L-LS side view  
A
B
C
D
Moving Half  
Ejector Plate  
Tie Bar  
Tighten Ty-Wrap  
Table 26: Figure Labels  
Step 5.  
Plug a Lynx™ cable between the limit switch and the  
eDART System™.  
Step 6.  
Run the machine to ensure proper use, while monitoring  
the eDART™ software.  
Appendix  
34  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Kuhn Rikon Drill 30 100 User Manual
Lathem GPS Receiver ATX GPS User Manual
Lennox Hearth Stove T150C User Manual
Lindy Car Video System TTX7601 User Manual
Linksys Network Router WRT150N User Manual
Makita Battery Charger DC18SC DC24SA User Manual
Marantz Dust Collector PV5580 User Manual
Melissa Microwave Oven 753 087 User Manual
Memorex DVD Player MVD2045 User Manual
Metrologic Instruments Scanner TECH 7 User Manual