English Manual
English Manual
General features
•
•
•
•
•
•
4 ports USB 2.0 / 2 ports FireWire ComboHub
With panel for an easy insertion into a 3½“ or 5¼“ front bay
Convienient front acces to USB and IEEE 1394 ports
For PC and MAC
Compliant with Plug & Play specification
No software driver required
USB features
•
Fully compatible with the USB OHCI/UHCI/EHCI
USB-2.0 / FireWire
internal Combo Hub
specification and with USB v. 2.0/1.1
Data transfer rate of 480 Mbit/s maximum
Supports all kinds of USB devices
•
•
IEEE 1394 features
Installation and Use
Benutzerhandbuch
English
•
•
•
OHCI-Link and PHY 100/200/400 Mbit/s
All FireWire ports provide up to 15W power
Supports all kinds of IEEE 1394 devices
Deutsch
Cable connection
Power cable: Ensure that the coloured wires of the cable are (from
left to right) Pin 4 to Pin 1.Connect the Y power cable to an
available connector on the power supply. The other end of the
cable may be used to attach another device. USB cable: Use
either a present internal USB port or do the following: After having
removed one of the slot plates of the computer connect the small
USB port connector to the Hub as shown in the figure above.
Ensure that the coloured wires of the cable are (from left to right)
Pin 4 to Pin 1. After the cable has been leaded through the rear
slot plate space, insert the provided slot plate and put the cables
into the notch. Then fix the slot plate with the large screw and
insert the USB cable into the USB port of the computer.
FireWire cable: To be connected in the same way as the USB
cable.
Hardware requirements
USB 2.0 and FireWire Hub Software Installation
The computer will recognize the Hub by itself. To install the
FireWire Hub you must connect a FireWire device to the PC. Then
follow the instructions on the screen!
•
•
•
USB port
IEEE 1394 port
An empty 3½” or 5¼” bay
Software requirements
•
•
Windows: 98SE / ME / 2k / XP
Mac OS8.6 or higher
Package contents
•
•
•
•
•
•
•
3½” internal Hub with 5¼” conversion case
This manual
0.8m USB 2.0 A Type cable
FireWire 6 pin cable
power cable
Dented slotplate (to connect cables to the rear ports)
Mounting screws & Plastic cable holder
Please check the content carefully.
Installation
1. Ensure that the computer is turned off and all cables are
disconnected
2. Open your computer and remove a 3½” or 5¼” front bay
cover.
LINDY Art. Nr. 32901
3. Insert the hub into the empty space and fix it in securely
using the small 4 screws provided.
© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH
-
Aug-2002
4. follow the cable connection instructions below.
Download from Www.Somanuals.com. All Manuals Search And Download.
|