Lanier Worldwide, Inc.
2300 Parklake Dr., N. E.
Atlanta, GA 30345-2979
Emergency Telephone: (800) 526-4371
MATERIAL SAFETY DATA SHEET
Section 1: Chemical Product and Company Information
Identity:
T 6055 Black Toner
MSDS No. CP-239
Product ID:
117- 0098
Issued: 1/5/01
Supersedes: 8/7/95
Date: 01/05/01
Synonyms
& Common
Names:
Prepared by: EH&S Department 770-496-9500
Approved by: Larry Choskey, Manager, CEH&S
European Lanier Worldwide, Inc.
Contact: Walter Fricke, Manager, Safety &
Environment
Toner, Black Toner
M6055, 6155, 6260, 6360 Copier
Mixture
Uses:
Im Taubental D-41468 Neuss, Germany
+49-2131-387-177
Chemical
Formula:
Section 2: Composition / Information on Ingredients
PERCENT
CAS No.
27136-15-8
1333-86-4
9003-07-0
84179-66-8
EXPOSURE LIMITS
Not listed
SOURCE
N/a
OSHA PEL ACGIH TLV
Styrene acrylate copolymer
Carbon black
Polypropylene wax
Organic pigment
90
4
4
2
3.5mg/m3 3.5mg/m3
Not listed
N/a
N/a
Not listed
3
*PEL as the product: 15mg/m (total dust), 5mg/m3 (respirable dust)
*TLV as the product: 10mg/m3 (total dust), 5mg/m3 (respirable dust)
Section 3: Hazards Identification
Hazard Rating:
FIRE = 0
HEALTH = 0
REACTIVITY = 0
SPECIAL = none
Health Hazards (Acute, Chronic, Immediate and Potential): Minimum irritation to respiratory tract may occur as with exposure to any
non-toxic dust. May cause gasping if inhaled. Inhalation should be avoided. May cause temporary eye discomfort.
Health Hazards of Long Term exposure (Chronic): A manufacturer sponsored chronic inhalation study in rats using a special test
toner revealed there were no lung changes at all in the lowest exposure level (1mg/m3), the most relevant level to potential human
exposures. A very slight degree of fibrosis was noted in 25% of the animals at the middle exposure level (4mg/m3), while a slight
degree of fibrosis was observed at the highest exposure level (16mg/m3) in all animals. These findings are attributed to “Lung
Overloading”, a generic response to excessive amount of any dust retained in the lungs for a prolonged interval. The special test
toner was ten times more respirable than commercially available toner to comply with EPA testing protocol and would not function
properly in Xerographic equipment.
Section 4: First Aid Measures
Inhalation:
Remove to fresh air if effects occur. Consult
local medical personnel
Eye Contact: In case of contact, immediately flush eyes with
water for 5 minutes.
Ingestion: Rinse mouth with water. Call a physician.
Skin Contact:
Wash with soap and water.
1
Download from Www.Somanuals.com. All Manuals Search And Download.
MATERIAL SAFETY DATA SHEET
Page 3
of
CP-239
Judgment as to the suitability of information contained herein for user’s purposes is the responsibility of the purchaser. Therefore, although
reasonable care has been taken in the preparation of this information, Lanier Worldwide, Inc. extends no warranties, makes no representations, and
assumes no responsibility as to the accuracy or suitability of such information for application to user’s intended purposes or for consequences of its
use. All materials may present unknown hazards and should be used with caution. Although certain hazards are described herein, we do not
guarantee that these are the only hazards that exist.
Information on this data sheet represents our current data and best opinion as to the proper use in handling of this product under normal conditions. On
the basis of the data available to us, this product is not a dangerous substance. One should, however, observe the usual precautionary measures for dealing
with chemicals.
Download from Www.Somanuals.com. All Manuals Search And Download.
|