3
Overview
The TP-202 is a twisted pair branching receiver for computer graphics video
signals with resolutions from VGA up to UXGA and higher or HDTV signals. It
takes a twisted pair signal and converts it into a computer graphics video signal or
HDTV signal available on two 15-pin HD outputs, and simultaneously re-transmits
the original twisted pair signal to another compatible receiver.
The TP-202 UXGA Line Transceiver/DA features:
A transmission range of more than 300ft (more than 100m)
HD signal reception (high-definition resolutions: 480p, 576p, 720p, 1080i and
1080p)
Two UXGA outputs on 15-pin HD connectors
EQ. and LEVEL controls
Selectable polarity for decoding H and V Sync for UXGA graphics
A 12V DC power supply and it can power or be powered by the receiver over
the same CAT 5 cable
A CAT 5 output for transmitting the signal to an additional receiver
3.1
About the Power Connect™ Feature
The Power Connect feature applies as long as the cable can carry power. This
feature is available when using STP cable and the distance does not exceed 50m
(164ft) on standard CAT 5 cable. For longer distances, use heavier gauge cable
(TP cable is still suitable for the video/audio transmission, but not for feeding the
power at these distances). For units that are connected via RJ-45 connectors,
make sure that the shield of the STP cable is connected to the metal casing of the
connectors on both ends of the cable. For units that are connected via terminal
block connectors, the shield of the STP cable must be connected to a ground
terminal on the units at both ends (use the ground terminal of the power supply
connection if necessary).
For a TP cable exceeding a distance of 50m, separate power supplies should be
connected to the transmitter and to the receiver simultaneously.
4
TP-202 - Overview
Download from Www.Somanuals.com. All Manuals Search And Download.
