MG700 series
Download from Www.Somanuals.com. All Manuals Search And Download.
p
q
r
ᕥ
ᕦ
Download from Www.Somanuals.com. All Manuals Search And Download.
ᕧ
s
t
ᕨ
ᕩ
Download from Www.Somanuals.com. All Manuals Search And Download.
English
G
Use the meat grinder to process
Children should be supervised to
ensure that they do not play with the
appliance.
Only use the appliance for its
intended domestic use. Kenwood
will not accept any liability if the
appliance is subject to improper use,
or failure to comply with these
instructions.
meat, poultry and fish. Use the
inclusive attachments to shape
sausages and kebbe.
G
before using your Kenwood
appliance
Read these instructions carefully and
retain for future reference.
Remove all packaging and any
labels.
G
G
before plugging in
G
G
Make sure your electricity supply is
the same as the one shown on the
underside of your machine.
safety
Always ensure bones and rind etc
are removed from the meat before
mincing.
When mincing nuts only feed a few
G
important (UK) only
The wires in the cord are coloured
as follows:
G
Blue = Neutral
down at a time and allow the scroll
to pick them up before adding any
more.
Brown = Live.
The appliance must be protected by
a 13A approved (BS1362) fuse.
G
G
G
Always unplug:
Note:
G
before fitting or removing parts
For non-rewireable plugs the fuse
cover MUST be refitted when
replacing the fuse. If the fuse cover
is lost then the plug must not be
used until a replacement can be
obtained. The correct fuse cover is
identified by colour and a
replacement may be obtained from
your Kenwood Authorised Repairer
(see Service).
If a non-rewireable plug is cut off it
must be DESTROYED
IMMEDIATELY. An electric shock
hazard may arise if an unwanted
non-rewireable plug is inadvertently
inserted into a 13A socket outlet.
G
after use
G
before cleaning.
G
Always use the pusher supplied.
Never put your fingers or utensils in
the feed tube.
Warning - the cutting blade is sharp,
handle with care both in use and
cleaning.
Ensure the attachment is secured in
position before switching on.
To avoid electric shocks, never let
the power unit, cord or plug get wet.
Never use a damaged appliance.
Get it checked or repaired: see
‘Service’.
Never use an unauthorised
attachment.
Never let the cord hang down where
a child could grab it.
This appliance is not intended for
use by persons (including children)
with reduced physical, sensory or
mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision or
instruction concerning use of the
appliance by a person responsible
for their safety.
G
G
G
G
G
G
G
This appliance conforms to EC
directive 2004/108/EC on
Electromagnetic Compatibility and
EC regulation no. 1935/2004 of
27/10/2004 on materials intended
for contact with food.
G
G
before using for the first time
1 Wash the parts see ‘care and
cleaning’
2 Push excess cord into the cord
stowage compartment at the back
of the power unit.
Download from Www.Somanuals.com4. All Manuals Search And Download.
3 Fit the tray. Put the dish/cover under
the mincer to catch the food.
4 Thaw frozen food thoroughly
before mincing. Cut meat into
2.5cm (1”) -wide strips.
mincer
power unit
locking lever
attachment outlet
on/off speed control
spanner
ring nut
mincer screens: fine, medium,
5 Switch to speed 2. Using the pusher,
gently push the food down the feed
tube, one piece at a time. Don’t
push hard – you could damage
your mincer.
coarse
cutter
Note:
scroll
mincer body
feed tube
Speed 1 is for extruding sausages,
kebbe and for use with the optional
attachments.
tray
pusher
dish/cover
storage unit for kebbe and
sausage adaptors
G
If the machine stalls or overheats
during use, it will stop mincing and
emit a quiet humming noise. In the
case of a stall, switch the machine
off, then turn the control to R (reverse)
for a few seconds to release the
clogged food. Switch off and unplug
the machine and remove any clogged
material. However, if the machine
overheats, switch the machine off and
allow it to cool down for 1 hour
before continuing the mincing
to assemble
1 Fit the scroll inside the mincer body.
2 Fit the cutter – cutting side
outermost ᕡ. Ensure it’s seated
properly – otherwise you
could damage your mincer.
3 Fit a mincer screen ᕢ. Put the notch
over the pin.
Use the fine screen for raw meat;
fish; small nuts; or cooked meat for
shepherd’s pie or meat loaves.
operation.
G
When selecting reverse, always wait
until the machine stops operating
before turning the speed control to
the reverse (R) position.
G
6 Switch off and unplug after use.
7 Loosen the ring nut. If necessay use
the spanner provided.
8 Move the locking lever towards the
back of the unit, then rotate the feed
tube towards the front of the
G
Use the medium and coarse screens
for raw meat; fish and nuts.
4 Loosely fit the ring nut.
to use the mincer
machine, then pull free.
1 With the mincer attachment in the
position shown ᕣ, locate in the
outlet. Rotate the mincer body so
that the feed tube is upright.
2 Tighten the ring nut firmly by hand.
G
If you experience poor results when
mincing meat, switch off and unplug
the machine. Dismantle and clean
the attachment, then re-assemble
the attachment and refit to the
power unit. Tighten the ring nut
using the spanner provided ᕤ.
Download from Www.Somanuals.com5. All Manuals Search And Download.
sausage filler
pork sausage recipe
base plate
large nozzle (for thick sausages)
small nozzle (for thin sausages)
100g (4oz) dry bread
600g (11⁄2lb) pork, lean and fat, cut
into strips
1 egg, beaten
5ml (1tsp) mixed herbs
salt and pepper
Ask your butcher for sausage skin or
mail order from the Natural Casing
Company Ltd, PO Box 133,
Farnham, Surrey GU10 5HT,
1 Soak the bread in water, then
squeeze and discard the water.
2 Mince the pork into a bowl.
3 Add the remaining ingredients and
mix well.
England. Use pig/hog skin on the
large nozzle and sheep/lamb skin on
the small nozzle. Or, instead of using
skin, roll in breadcrumbs or
seasoned flour before cooking.
4 Make into sausages (see ‘to use the
sausage filler’).
5 Fry, grill or bake until golden brown.
to use the sausage filler
1 If you’re using skin, soak it in cold
water for 30 minutes first. Then open
it up with a jet of water and place
your chosen nozzle under a running
tap and pull the skin onto the nozzle.
2 Fit the scroll inside the mincer body.
3 Fit the base plate ᕥ - put the notch
over the pin.
kebbe maker
shaper
cone
Kebbe is a traditional Middle Eastern
dish: deep-fried lamb-and-bulgur-
wheat parcels with a minced meat
filling.
4 Hold the nozzle on the mincer
attachment and loosely screw the
ring nut on.
to use the kebbe maker
1 Fit the scroll inside the mincer body.
2 Fit the shaper ᕧ – put the notch
over the pin.
5 With the mincer attachment in the
position shown ᕦ, locate in the
outlet. Rotate the mincer body so
that the feed tube is upright.
3 Fit the cone.
4 Loosely screw the ring nut on.
5 With the mincer in the position
shown ᕨ, locate in the outlet.
Rotate the mincer body so that the
feed tube is upright.
6 Tighten the ring nut firmly by hand.
7 Fit the tray.
8 Switch on to speed 1. Using the
pusher, gently push your mixture
through. Cut into lengths.
6 Tighten the ring nut firmly by hand.
7 Fit the tray.
8 Switch on to speed 1. Using the
pusher, push the food down the feed
tube. Don’t push hard – you
could damage your mincer.
Ease the skin off the nozzle as it fills.
Don’t overfill.
9 Twist the skin to form sausages.
Download from Www.Somanuals.com6. All Manuals Search And Download.
stuffed kebbe recipe
care and cleaning
G
outer casing
Always switch off and unplug before
500g (1lb 2oz) lamb or fat-free
mutton, cut into strips
500g (1lb 2oz) bulgur wheat,
washed and drained
cleaning.
power unit
Wipe with a damp cloth, then dry.
Never immerse in water or use
abrasives.
G
G
1 small onion, finely chopped
Important
mincer attachment
Always use the bulgur wheat straight
away after draining. If it is allowed to
dry out, it may increase the load on
the mincer resulting in damage.
1 Loosen the ring nut manually or with
the spanner ᕤ and dismantle. Wash
all the parts in hot soapy water, then
dry. Don’t wash any part in the
dishwasher. Never use a soda
solution.
1 Using the fine screen, mince
alternate batches of meat and
wheat.
2 Re-assemble.
2 Mix. Then mince twice more.
3 Stir the onion into the mix.
4 Push through, using the kebbe
maker.
3 Wipe the screens with vegetable oil,
then wrap in greaseproof paper to
prevent discolouring/rusting.
4 If you keep the mincer on the
machine, put the dish/cover on the
tray as a dust-cover.
5 The sausage and kebbe
attachments can be kept together in
the storage unit supplied ᕩ.
Filling
400g (10oz) lamb, cut into strips
15ml (1tbsp) oil
2 medium onions, finely chopped
5-10ml (1-2tsp) ground allspice
15ml (1tbsp) plain flour
salt and pepper
service and customer
care
1 Using the fine screen, mince the
lamb.
2 Fry the onions until golden brown.
Add the lamb.
3 Add the remaining ingredients and
cook for 1-2 minutes.
4 Drain off any excess fat and allow to
cool.
G
If the cord is damaged it must, for
safety reasons, be replaced by
Kenwood or an authorised Kenwood
repairer.
UK
If you need help with:
G
using your machine or
To finish
1 Push the casing mixture through,
using the kebbe maker.
2 Cut into 8cm (3”) lengths.
3 Pinch one end of the tube to seal it.
Push some filling – not too much –
into the other end, then seal.
4 Deep fry in hot (190˚) oil for about 6
minutes or until golden brown.
G
servicing, spare parts or repairs (in or
out of guarantee)
టcall Kenwood customer care on
023 9239 2333. Have your
model number ready – it’s on
the underside of the power unit.
G
spares and attachments
టcall 0870 2413653.
other countries
Contact the shop where you bought
your machine.
Download from Www.Somanuals.com7. All Manuals Search And Download.
G
G
Designed and engineered by
Kenwood in the UK.
Made in China.
guarantee
If your mincer goes wrong within one
year from the date you bought it, we
will repair it (or replace it if
necessary) free of charge provided:
you have not misused, neglected or
damaged it;
IMPORTANT INFORMATION FOR
CORRECT DISPOSAL OF THE
PRODUCT IN ACCORDANCE
WITH EC DIRECTIVE
G
G
2002/96/EC.
At the end of its working life, the product
must not be disposed of as urban
waste.
it has not been modified (unless by
Kenwood);
G
G
G
it is not second-hand;
It must be taken to a special local
authority differentiated waste collection
centre or to a dealer providing this
service.
it has not been used commercially;
you have not fitted a plug incorrectly;
and
G
you supply your receipt to
show when you bought it.
Disposing of a household appliance
separately avoids possible negative
consequences for the environment and
health deriving from inappropriate
disposal and enables the constituent
materials to be recovered to obtain
significant savings in energy and
resources. As a reminder of the need to
dispose of household appliances
separately, the product is marked with
a crossed-out wheeled dustbin.
This guarantee does not affect your
statutory rights.
Download from Www.Somanuals.com8. All Manuals Search And Download.
Head Office Address:
Kenwood Limited, New Lane, Havant, Hampshire PO9 2NH, UK
Designed and engineered by Kenwood in the UK
Made in China
19615/1
Download from Www.Somanuals.com. All Manuals Search And Download.
|