S E R V I C E I N S T R U C T I O N S
Part No. 057122
1-800-KEATING
Flexible Tubing to Hard Piping Installation
Instructions – for Motor/Pump Part# 055173
Page 1 of 2
Operation #1 Dis-Assembly
Filter Tub Assembly
See Note #1
Motor/Pump
Housing Covers
See Note #5
(2X)
Motor/Pump
Housing Assembly
Filter Tub Assembly in Unlocked Position
90° Compression
Fitting See Notes
#3 and #5
Filter Cart Frame Assembly
View “A – A”
Bracket SE Coupler
Pull Rod
See Note #4
See Note #2 Compression Fitting
See Note #3
Caution:
Use these Service
Make Sure Saftey Glasses are Worn
Instructions for the
following Kit part #’s:
Notes:
1. Drain and clean all oil from filter tub assembly. Remove filter tub assembly
from filter cart frame assembly. This assembly will be turned over (upside
down), for replacement of parts and adjustment to mating part on motor
mount housing assembly.
057117
057118
057119
057120
SE14
SE18
SE20
SE24
2. Remove pull rod and set aside; this part will be used later.
3. Loosen compression fitting at pump output. Do not remove 90°
fitting from pump.
4. Remove (4) bolts holding bracket SE coupler. This assembly will be
replaced with new parts in kit. The bracket and flex tubing with quick
connect are to be discarded.
5. Inspect 90° compression fitting on the pump as shown in View A – A. If the
fitting is not on center line of the radius on the pump mount housing
assembly as shown, use a #23 or #24 drill to remove pump housing
covers (2) as shown in view A – A, to gain easier access to the top bolts
holding the motor/pump. Loosen (4) bolts on motor/pump to center 90°
fitting as best as possible. These covers will be re-assembled with parts
in the kit. After adjustments are made to the motor/pump to center 90º
compression fitting as shown in view A – A, tighten the (4) bolts for the
motor/pump.
HardPiping057122.qxd
Download from Www.Somanuals.com. All Manuals Search And Download.
|