Jettech Metal Products Dishwasher X 32 User Manual

LOW TEMP WAREWASHERS  
X-32  
Technical Manual  
2003 02  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Warranty  
MANUFACTURERS LIMITED WARRANTY  
Jet Tech Systems Corporation (Jet Tech) hereby warrants all new warewashers bearing the name “JET TECH” and installed  
within the continental United States of America or Canada to be free from defects in material and workmanship, under  
normal and regular usage and operation, for a period of one (1) year following the date of original installation, (unless  
specified otherwise) but in no event can exceed eighteen (18) months from the date of shipment from the factory.  
If a defect in material(s) or workmanship is detected; or found to exist within the stated period above, Jet Tech, at its sole  
discretion, shall either repair or replace any original equipment manufacturers part which has proven to fail within the  
machine; providing that the equipment has not been altered or tampered with in any manner, has been installed correctly as  
per the owners manual, and maintained and operated in complete accordance with this manual.  
The labor cost to repair or replace any part proven to be defective, as per above clause(s), shall be covered by Jet Tech  
Systems, within the continental United States of America or Canada; provided that: prior authorization for this labor was  
approved by Jet-Tech Systems, the service work was performed by an authorized Jet Tech service agency; and that this  
agency installed an original and genuine Jet Tech part in the machine. Any repair work performed by a non-authorized  
service depot remains the sole responsibility of the user, and Jet Tech Systems will not be held responsible. The installation  
of any generic part will not be valid; and therefore voids this warranty. All authorized labor coverage shall be limited to  
regular hourly rates only. Any supplemental hourly rates or charges, such as weekends or emergency premiums remain the  
responsibility of the user.  
Jet Tech Systems Corp. (Jet Tech) hereby states that: warranty travel time shall be limited to, and without exception, a round-  
trip total of two (2) hours OR mileage up to a maximum of one hundred (100) miles round-trip. Any charges exceeding those  
stated herein must have prior authorization by the factory.  
Exceptions to above warranty are: (A) Damages resulting from shipping, handling or abuse. (B) Incorrect installation and/or  
connections. (C) Adjustments or calibration of any parts. (D) Faults due to lack of regular maintenance or cleaning of any  
internal part(s). (E) Replacement of any wearable items such as: glasswasher curtains, or peristaltic squeeze tubing or  
gaskets. (F) Excessive lime, mineral, alkali or hard water conditions (In excess of 6 grain) and (G) Poor results due to: use of  
an incorrect type of detergent (for non-commercial type applications), and excessive or inadequate water temperature(s) or  
pressure conditions or incorrect use. (H) Labour and mileage coverage does not apply upon condition of sale.  
JET TECH SYSTEMS CORPORATION STATES THAT THERE ARE NO OTHER WARRANTIES, EXPRESSED OR  
IMPLIED, THAT ARE NOT SET FORTH HEREIN, JET TECH SYSTEMS CORPORATION SHALL ASSUME NO  
OTHER RESPONSIBILITY, EITHER DIRECT OR NON-DIRECT, OR BE LIABLE FOR ANY OTHER OR  
ADDITIONAL LOSS OR DAMAGE WHETHER BEING DIRECT OR CONSEQUENTIAL, AS A RESULT OF ITS  
EQUIPMENT.  
Warranty:  
One year parts & labor (Continental USA and Canada).  
Exceptions: Model “F14” - 90 days labor & One year parts.  
The manufacturer reserves the rights to alter design and specifications without notice.  
Download from Www.Somanuals.c
3
om. All Manuals Search And Download.  
Sanitary inner “deep-drawn” wash tank  
Independent Chemical Pumps  
Construction features  
Body , external housing, wash tank, and all  
Technical Features  
cm)  
m
m
chassis components in brushed stainless steel  
AISI 304 18/8  
m
Rack capacity: 19.75" x 19.75" (50 cm x 50  
cm) (one open combination rack and on peg  
dish rack supplied)  
m
Reduced operating noise of 58 DbA due to  
utilization of double-wall insulated panels  
m
Complete cycle: 160 seconds (145 second  
Wash & 15 second Rinse)  
m
Upper and lower wash and rinse jets on  
revolving arms constructed of fiberglass; easy  
to remove and clean without the need for tools  
m
Wash tank capacity; 3.17 US gallon (12  
liters)  
m
Safety micro-switch on the door to interrupt  
Wash temperature; 140F recommended,  
Supply dependant (no heaters)  
wash pump action  
m
m
Power supply: 110 volts 60Hz 7 Amps  
m
Individual and adjustable variable speed  
peristaltic pumps for: detergent, sanitizer and  
rinse-additive.  
m
Motor pump; 0.75 H.P. With Clipson at  
320F (160C)  
Possibility of built-in or free standing  
installation  
m
m
m
Maximum Power rating; 550 Watts  
Water consumption per cycle; 1.5 U.S.  
Standard equipment includes insulated,  
stainless steel top & side panels  
Gallons (5.7 liters)  
m
working pressure; 25 P.S.I. (Dynamic)  
m
m
Wash tank protected with double filters.  
Door opening with overall clearance of 14.25  
in (36cm)  
m
m
Automatic fill and water level regulation tank  
Slide-out front control panel provides easy  
access for service.  
m
Overall dimensions: height: 33.5 in. (85 cm)  
Width 23.75 in. (60 cm) Depth: 23.75 in. (60  
JET TECH SYSTEMS CORP.  
TEL: (514) 737 9701  
FAX (514) 342 3854  
1 888 275 4538  
WWW.JET-TECH.COM  
Download from Www.Somanuals.c
4
om. All Manuals Search And Download.  
DRAIN  
The X‐32 is equipped with an automatic drain pump that will pump the drain  
water to a maximum height of 36" (0.9 meter). A 1" ID flexible drain hose is  
included to facilitate maintenance and servicing of the machine. It is important  
not to reduce the size of this hose. The drain should have a loop at the back of  
the dishwasher as per illustration below. The loop should be 36 inches (36”)  
above the floor and drop down into a drain pipe with an air gap. These  
instructions must be followed for proper dishwasher operation. It is normal for  
some water to remain in the wash tank after draining.  
WATER INLET  
A 3/4” NPT coupling is required with a maximum of 20 p.s.i. dynamic pressure,  
and a minimum of 18 p.s.i. . A water pressure regulator is required. The water  
pressure should be 20 p.s.i. Incoming water temperature must be 140º F ( 60º  
C). An easily accessible shut‐off valve is recommended ‐‐‐ making installation,  
service and repairs easier.  
Flexible hoses must be used to make installation, servicing and maintenance  
easier.  
Make sure that the water is free from calcium and hard water deposits. Water  
with a mineral contain of 6 grains or higher must have an on‐line water filtering  
system or some other type of water softening system. Build‐up of calcium and  
lime deposits in the washer may occur and servicing will be required on  
a more frequent basis which will not be covered by the warranty.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
ELECTRICAL  
Unit must be connected with a 110 volts 60Hz line. The terminal block will  
receive L1, N and Ground wire. Unit must be well grounded. Breaker rating  
should be 15 amps.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Getting Started  
Immediately upon receipt of your new X-32 dishwasher, inspect the dishwasher for any obvious  
signs of damage. If you do find any traces of damage, contact the transport company that  
brought the dishwasher to your place at once.  
A damage claim must be made immediately with the carrier.  
Please assure that the following items are included with your X-32 dishwasher.  
!
(1) 20 x 20 open rack  
!
(1) 20 x 20 peg rack for dishes  
!4 adjusting feet  
!1 operators manual  
Download from Www.Somanuals.c
5
om. All Manuals Search And Download.  
Chemical hook-up  
This unit is equipped with three (3) chemical pumps. Each will  
inject a different liquid product at a specific time during the  
wash cycle. The chemical pumps have sufficient length of  
tubing hose that can be inserted in gallon containers near the  
dishwasher.  
The chemical pumps have colored tubing for ease of  
identification. The colors are as follow;  
Red for Detergent  
Clear for Sanitizer  
Blue for Rinse-additive  
To prime the pumps; you must complete two full wash cycles.  
You can adjust the amount injected by turning the white screw on the  
chemical pump.  
Installation Check List  
- Is the dishwasher connected electrically?  
- Is the breaker turned on?  
- Is there water connected to the dishwasher?  
- Is the water valve opened?  
- Are the chemicals properly set?  
Starting the dishwasher the first time  
When starting the dishwasher for the first time, you will notice that the only chemical that gets  
drawn in is the detergent. The other chemicals will get drawn only during the wash cycle.  
For more information go to Operation section.  
Download from Www.Somanuals.c
7
om. All Manuals Search And Download.  
Operation  
1.  
When you start the power (GREEN PUSH-BUTTON) TL the machine automatically  
starts to fill the water until the correct water level is reached. During the fill,  
the solenoid valve EC and the detergent dosing pump MPD are operating.  
2.  
By pushing the (BLACK ROUND) push-button TC, the programmed washing cycle starts. The  
length of the times are shown in the schematic electrical diagram:  
2.1  
2.2  
From 0" to 30" the machine is washing and only the wash pump is operating.  
From 30" to 50" while the wash pump is working; also the sanitizer dosing pump MPSA  
is operating to fill the dishwasher with chemical sanitizer.  
2.3  
From 50" to 60" the machine is washing and only the wash pump MPL is operating.  
The wash pump stops to operate when the timer has reached 60" of time.  
2.4  
2.5  
From 60" to 63" is the dripping time; and in this phase only the timer still works.  
From 63" to 83" the solenoid valve ER and the rinse chemical pump MPB are  
operating. MPB is delivering the right quantity of rinse aid product. The quantity can be  
pre-determined with the adjustment of the pump. At the same time , 63" to 83", the drain  
pump MPS is operating. At this time the cycle has ended and the drain pump only is  
operating from 83" to 99" ; and automatically the dishwasher is ready to start again.  
3.  
The black (SQUARE) push-button has a double function:  
.
First function: to give the possibility to make a pre-wash or a continuous wash for as  
long as you want. - in pushing the black button the wash pump MPL works. To stop  
the wash pump you must have the black push-button in OFF position.  
.
Second function: is for de-lime. The operator must put the de-liming chemical product in  
the water in the wash tank of X-32 and then push the black button. When the de-lime  
push-button is in the ON position the wash pump MPL is working: FOR NORMAL  
WASHING CYCLE THE PUSH-BUTTON FOR DE-LIME MUST BE IN THE OFF  
POSITION. If during the wash cycle the de-lime button is pushed in, the wash cycle will  
stop and will only start again when the button is depressed, this from the position  
reached at the moment that the de-lime button has been pushed.  
4. The white (SQUARE) push-button is for the total drain of the tank when the operator has  
finished the washing operations  
1 - Drain Button  
5 - Thermometer gauge  
6 - Wash cycle, Start button  
7 - Indicator light (wash cycle)  
2 - Extended / delime button  
3 - Power switch  
4 - Indicator light (power)  
8
Download from Www.Somanuals.com. All Manuals Search And Download.  
Electrical Schematics  
DPS - Drain pump By-pass switch  
MPS - Drain Pump  
TL - Main Power switch  
PS1, PS2 - Pressure switches  
ER - Rinse solenoid valve  
EC - Fill solenoid valve  
MPD - Detergent pump  
MPB - Rinse additive pump  
MPSA - Sanitizer pump  
MP - Door switch  
TLS - Deliming option switch  
CRP - Contact from relay  
MT - Timer motor  
M1, M2, M3, M4, M5 - Timer  
contact  
LC - Light, Timer cycle  
MPL - Wash pump  
BR - Relay coil  
TC - Start switch  
CR - Contactor relay swicth  
LL - Light, Main power  
BRP - Relay coil  
Download from Www.Somanuals.c
9
om. All Manuals Search And Download.  

Insignia CD Player IS PA040719 User Manual
Intel Server SR6850HW4 User Manual
iOptron Telescope G MC90 User Manual
John Lewis Freezer JLFFW2007 User Manual
JVC Headphones HAEB75S User Manual
Karcher Pressure Washer K 245 User Manual
Kenmore Clothes Dryer 60092 User Manual
Kenmore Water System 350 Series User Manual
Kensington Laptop K33926US User Manual
KitchenAid Ice Maker KUIS15PRHB4 User Manual