WHEELCHAIR TRAY
Assembly, Installation, and Operating Instructions
Model No. 1300, 1035965, and 1035966
6. Repeat STEPS 1-5 for opposite side.
NOTE: Check all parts for shipping damage and test be-
fore using. In case of damage, DO NOT use. Contact the
dealer / Invacare for further instructions.
7. Remove protective paper from the tray.
8. Position the tray bracket on the wheelchair tray BOT-
TOM as shown in FIGURE 1.
SAFETY SUMMARY
The following recommendations are made for the
safe installation of the Wheelchair Tray:
NOTE:Forwheelchairsover18-incheswide, reversethe
traybracketswiththesocketspositionedtowardstheout-
side of the tray.
WARNING
9. Install carriage bolts through TOP of wheelchair tray
and tray bracket.
DO NOT a sse mble or use this e quipme nt with-
out first re a ding a nd unde rsta nding this instruc -
tion she e t. If you a re una ble to unde rsta nd the
Wa rnings, Ca utions or Instruc tions, c onta c t a
he a lthc a re profe ssiona l, de a le r or te c hnic a l
pe rsonne l if a pplic a ble be fore a tte mpting to in-
sta ll this e quipme nt - othe rwise , injury or da m-
a ge ma y oc c ur.
10. Secure the tray bracket to the tray with the two (2)
wing nuts.
11. Repeat STEPS 8-10 for opposite side.
12. Insert the tray support bar into the tray bracket and
hand tighten the socket screw.
Any worn or da ma ge d ha rdwa re MUST be re -
pla c e d.
13. Insert the tray support bars into the bracket supports
at the desired position.
After insta lla tion, repa ir or service a nd BEFORE use,
ma ke sure a ll a tta ching ha rdwa re is securely tight-
ened - otherwise, injury or da ma ge ma y result.
14. Securely tighten the four (4) phillips screws.
15. Center the tray on the wheelchair.
NOTE: If the tray will not center, adjust tray support bars.
INSTALLING WHEELCHAIR TRAY
(FIGURE 1)
16. After making sure the tray is centered on the wheel-
chair, securely tighten the socket screws.
Tray
Wheelchair Tray
Support
1. Removethetwo(2)phillipsscrewsfromthearmpad.
2. Slide the bracket support tube into the bar guide as-
Carriage Bolts
Bars
sembly as shown in FIGURE 1.
Wheelchair
Frame
Tray
Bracket
NOTE: The bracket of the bar guide assembly and the
tube of the bracket support should be positioned towards
the outside of the wheelchair frame.
Arm Pad
Socket Screw
Wing Nuts
Tab
3. Looselyinstallphillipsscrewthroughthebracketsup-
port tab, wheelchair frame and arm pad.
Bracket
4. Position the bar guide assembly tab to align with the
mounting hole of the wheelchair frame.
Tab
Bracket Support
and Tube
Bar Guide
Assembly
5. Loosely install phillips screw through the bar guide
assembly, wheelchair frame and arm pad.
Phillips Screws
FIGURE 1 - INSTALLING WHEELCHAIR TRAY
Invacare Corporation
Technical Support
800-832-4707
Invacare is a registered trademark of Invacare Corporation
© 1999 Invacare Corporation
One InvacareWay
Elyria, Ohio USA
44036-2125
Form No.84-41 P/N 1023704 Rev.B (1) - 11/99
800-333-6900
Download from Www.Somanuals.com. All Manuals Search And Download.
|