Infinity Portable Speaker OWS 1 User Manual

OWS-1  
Owner’s Guide  
Download from Www.Somanuals.com. All Manuals Search And Download.  
WIRING THE SYSTEM  
FINAL ADJUSTMENTS  
IMPORTANT: Make sure all equipment is turned off before making any  
connections.  
Check the speakers for playback first by setting the system volume control  
to a minimum level, and then by applying power to your audio system.  
Play a favorite music or video segment and increase the system volume  
control to a comfortable level.  
For speaker connections, use a minimum # 18-gauge speaker wire with  
polarity coding.The side of the wire with a ridge or other coding is usually  
considered positive polarity (i.e., +). Heavier gauge wire should be used  
when more than 50 feet of speaker wire is required.The wire channels on  
the rear of the OWS-1 will accommodate most types of 14- to 18-gauge  
wire.  
NOTE: You should hear balanced audio reproduction across the entire  
frequency spectrum. If not, check all wiring connections or consult the  
authorized Infinity dealer from whom you purchased the system for more  
help.  
®
When the OWS-1 speakers are used as part of a Dolby Digital or DTS®  
NOTE: If desired, consult your local Infinity dealer about speaker wire and  
connection options.  
multichannel home theater system with a powered subwoofer, it is  
recommended that you set your receiver/processor speaker mode tosmall”  
orhigh-passfor all channels connected to an OWS-1. In addition, some  
receivers/processors allow you to adjust the high-pass frequency for the  
smallorhigh-passsetting. If your receiver/processor has this capability,  
it is recommended that you set the high-pass frequency to the lowest setting  
above 70Hz. Consult your receiver/processor manual for more information  
about these adjustments.  
The speakers have coded terminals that accept a variety of wire connectors.  
The most common connection is shown in Figure 3.  
To ensure proper polarity, connect each + terminal on the back of the  
amplifier or receiver to the respective + (red) terminal on each speaker, as  
shown in Figure 4. Connect the (black) terminals in a similar way. See the  
owners guides that were included with your amplifier or receiver to confirm  
connection procedures.  
CARE OF YOUR SPEAKER SYSTEM  
IMPORTANT: Do not reverse polarities (i.e., + to or to +) when making  
connections. Doing so will cause poor imaging and diminished bass  
response.  
The OWS-1 does not require any routine maintenance.When needed, use a  
soft cloth, dampened with water only, to remove any fingerprints or dust.  
Clean the grille by gently vacuuming.  
RED =  
+
NOTE: Do not use any cleaning products or polishes on the cabinet or grille.  
BLACK =  
LOOSEN TERMINALS  
.
.
INSERT BARE END;  
SPECIFICATIONS  
TIGHTEN TERMINALS  
Frequency Range:  
70Hz 20,000Hz (±3dB)  
NO STRIPE =  
STRIPE =  
+
Recommended  
Amplifier Power:  
This example shows how to connect bare wires to the  
FIGURE 3  
15 125 watts  
terminals. Banana plugs may also be inserted directly into the rear of the  
connector.  
Sensitivity:  
(2.83V @ 1 meter)  
90dB  
Nominal Impedance:  
Crossover Frequency:  
Low-Frequency Driver:  
8  
(one channel shown)  
2500Hz; 24dB/octave  
6-1/2" (165mm) C.M.M.D.  
3/4" (19mm) C.M.M.D.  
Receiver or  
Amplifier  
(rear view)  
BLACK  
RED  
High-Frequency Driver:  
Dimensions (H x W x D):  
14-1/2" x 9" x 4-1/2"  
(368mm x 229mm x 114mm)  
+
+
Speaker (rear view)  
Weight:  
6.5 lb (3.0kg)  
Wiring diagram shows polarity connections for one  
FIGURE 4  
channel of a stereo or home theater system.  
Infinity continually strives to update and improve existing products, as well as  
create new ones.The specifications and construction details in this and related  
Infinity publications are therefore subject to change without notice.  
3
OWS-1  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Declaration of Conformity  
We, Harman Consumer International  
2, route de Tours  
72500 Chateau-du-Loir  
France  
declare in own responsibility, that the product described  
in this owners manual is in compliance with technical  
standards:  
EN 50081-1:1992  
EN 50082-1:1997  
© 2001 Infinity Systems, Inc.  
Luc E. Godard  
Harman Consumer International  
Chateau-du-Loir, FRANCE. 4/01  
250 Crossways Park Drive,Woodbury, NY 11797 USA  
(800) 553-3332 (USA Only) www.infinitysystems.com  
Infinity is a registered trademark of Infinity Systems, Inc. Printed in USA 4/01 Part No. 337835-001  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Ingersoll Rand Water Pump 6544X X User Manual
Insignia DVD Recorder NS DVDR1 User Manual
Intel Personal Computer CAP08LOOPAIO User Manual
JBL Portable Speaker CS600SAT User Manual
John Lewis Range JLBIGH702 User Manual
JVC Projection Television HD 56FN97 User Manual
Kenwood Two Way Radio KSGCP401 User Manual
Kicker Car Amplifier ZX2002 User Manual
Kobe Range Hoods Ventilation Hood CX1836GS 8 User Manual
Konica Minolta Printer PagePro 1350W User Manual